Numerical analysis on the effects of CO2 dilution on the laminar burning velocity of premixed methane/air flame with elevated initial temperature and pressure

Fuel ◽  
2020 ◽  
Vol 264 ◽  
pp. 116858 ◽  
Author(s):  
Mingke Xie ◽  
Jianqin Fu ◽  
Yongxiang Zhang ◽  
Jun Shu ◽  
Yinjie Ma ◽  
...  
Fuel ◽  
2022 ◽  
Vol 309 ◽  
pp. 122081
Author(s):  
Yu Liu ◽  
Wu Gu ◽  
Jinduo Wang ◽  
Hongan Ma ◽  
Nanhang Dong ◽  
...  

2012 ◽  
Vol 6 (1) ◽  
pp. 55-64 ◽  
Author(s):  
S. Y. Liao ◽  
D. L. Zhong ◽  
C. Yang ◽  
X. B. Pan ◽  
C. Yuan ◽  
...  

Laminar burning velocity is strongly dependent on mixture characteristics, e.g. initial temperature, pressure and equivalence ratio. In this work, spherically expanding laminar premixed flames, freely propagating from a spark ignition source in initially quiescent ethanol-air mixtures, have been imaged and then the laminar burning velocities were obtained at initial temperatures of 358 K to 500K, pressure of 0.1 to 0.2 MPa and equivalence ratio of 0.7 to 1.4. The measured re-sults and literature data on ethanol laminar burning velocities were accumulated, to analyze the effects of initial tempera-ture and pressure on the propagation characteristics of laminar ethanol-air flames. A correlation in the form of ul=ulo(Tu/Tu0)αT (Pu/Pu0)βP , and validated over much wide temperature, pressure and equivalence ratio ranges. The global activation temperatures were determined in terms of the laminar burning mass flux for ethanol-air flames. And the Zel’dovich numbers were estimated as well. The dependencies of global activation temperature and Zel’dovich number on initial mixture pressure, temperature and equivalence ratio were explored. Additionally, an alterna-tive correlation of laminar burning velocities, from the view of theoretical arguments, was proposed on the basis of the de-termined ethanol-air laminar mass burning flux. Good agreements were obtained in its comparison with the literature data.


Fuel ◽  
2022 ◽  
Vol 310 ◽  
pp. 122149
Author(s):  
Ryuhei Kanoshima ◽  
Akihiro Hayakawa ◽  
Takahiro Kudo ◽  
Ekenechukwu C. Okafor ◽  
Sophie Colson ◽  
...  

Energies ◽  
2019 ◽  
Vol 12 (15) ◽  
pp. 2892 ◽  
Author(s):  
Zhiqiang Han ◽  
Zhennan Zhu ◽  
Peng Wang ◽  
Kun Liang ◽  
Zinong Zuo ◽  
...  

The initial conditions such as temperature, pressure and dilution rate can have an effect on the laminar burning velocity of natural gas. It is acknowledged that there is an equivalent effect on the laminar burning velocity between any two initial conditions. The effects of initial temperatures (323 K–423 K), initial pressures (0.1 MPa–0.3 MPa) and dilution rate (0–16%, CO2 as diluent gas) on the laminar burning velocity and the flame instability were investigated at a series of equivalence ratios (0.7–1.2) in a constant volume chamber. A chemical kinetic simulation was also conducted to calculate the laminar burning velocity and essential radicals’ concentrations under the same initial conditions. The results show that the laminar burning velocity of natural gas increases with initial temperature but decreases with initial pressure and dilution rate. The maximum concentrations of H, O and OH increase with initial temperature but decrease with initial pressure and dilution rate. Laminar burning velocity is highly correlated with the sum of the maximum concentration of H and OH.


Energies ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 809
Author(s):  
Xueshun Wu ◽  
Peng Wang ◽  
Zhennan Zhu ◽  
Yunshou Qian ◽  
Wenbin Yu ◽  
...  

Initial temperature has a promoting effect on laminar burning velocity, while initial pressure and dilution rate have an inhibitory effect on laminar burning velocity. Equal laminar burning velocities can be obtained by initial condition coupling with different temperatures, pressures and dilution rates. This paper analysed the equivalent distribution pattern of laminar burning velocity and the variation pattern of an equal weight curve using the coupling effect of the initial pressure (0.1–0.3 MPa), initial temperature (323–423 K) and dilution rate (0–16%). The results show that, as the initial temperature increases, the initial pressure decreases and the dilution rate decreases, the rate of change in laminar burning velocity increases. The equivalent effect of initial condition coupling can obtain equal laminar burning velocity with an dilution rate increase (or decrease) of 2% and an initial temperature increase (or decrease) of 29 K. Moreover, the increase in equivalence ratio leads to the rate of change in laminar burning velocity first increasing and then decreasing, while the increases in dilution rate and initial pressure make the rate of change in laminar burning velocity gradually decrease and the increase in initial temperature makes the rate of change in laminar burning velocity gradually increase. The area of the region, where the initial temperature influence weight is larger, gradually decreases as the dilution rate increases, and the rate of decrease gradually decreases.


Sign in / Sign up

Export Citation Format

Share Document