propagation characteristics
Recently Published Documents


TOTAL DOCUMENTS

2878
(FIVE YEARS 492)

H-INDEX

54
(FIVE YEARS 8)

2022 ◽  
Vol 12 (2) ◽  
pp. 758
Author(s):  
Lihu Dong ◽  
Danqing Song ◽  
Guangwei Liu

To investigate the seismic response of layered rock sites, a multidomain analysis method was proposed. Three finite element models with infinite element boundaries for layered sites were analysed. The results of this multidomain analysis show that stratum properties and elevation have an impact on wave propagation characteristics and the dynamic response of layered sites. Compared with the rock mass, the overlying gravel soil has a greater dynamic amplification effect at the sites. A time domain analysis parameter PGA(IMF) was proposed to analyse the effects of different strata on the seismic magnification effect of layered sites, and its application was also discussed in comparison with PGA. According to the frequency domain analysis, the interface of the rock mass strata has a low impact on the Fourier spectrum characteristics of the sites, but gravel soil has a great magnification effect on the spectrum amplitude in the high-frequency band (≥30 Hz) of waves. Moreover, the stratum properties have a great influence on the shape and peak value of the Hilbert energy and marginal spectrum at layered sites. When waves propagate from hard rock to soft rock, the peak value of the Hilbert energy spectrum changes from single to multiple peaks; then, in gravelly soil, the Hilbert energy spectral peak, its nearby amplitude and the amplitude in the high-frequency band (28–36 Hz) are obviously amplified. The frequency components and amplitude of the marginal spectrum become more abundant and larger from rock to gravelly soil in the high-frequency band (28–35 Hz).


2022 ◽  
Vol 2022 ◽  
pp. 1-15
Author(s):  
Usman Rauf Kamboh ◽  
Muhammad Rehman Shahid ◽  
Hamza Aldabbas ◽  
Ammar Rafiq ◽  
Bader Alouffi ◽  
...  

For the last two decades, cybercrimes are growing on a daily basis. To track down cybercrimes and radio network crimes, digital forensic for radio networks provides foundations. The data transfer rate for the next-generation wireless networks would be much greater than today’s network in the coming years. The fifth-generation wireless systems are considering bands beyond 6 GHz. The network design of the next-generation wireless systems depends on propagation characteristics, frequency reuse, and bandwidth variation. This article declares the channel’s propagation characteristics of both line of sight (LoS) and non-LOS (NLoS) to construct and detect the path of rays coming from anomalies. The simulations were carried out to investigate the diffraction loss (DL) and frequency drop (FD). Indoor and outdoor measurements were taken with the omnidirectional circular dipole antenna with a transmitting frequency of 28 GHz and 60 GHz to compare the two bands of the 5th generation. Millimeter-wave communication comes with a higher constraint for implementing and deploying higher losses, low diffractions, and low signal penetrations for the mentioned two bands. For outdoor, a MATLAB built-in 3D ray tracing algorithm is used while for an indoor office environment, an in-house algorithmic simulator built using MATLAB is used to analyze the channel characteristics.


2022 ◽  
pp. 136943322110632
Author(s):  
Jianyi Ji ◽  
Ronghui Wang ◽  
Niujing Ma ◽  
Kunhong Huang ◽  
Xiang Zhang

A physical perspective of the propagation and attenuation of flexural waves is presented in this paper for the dynamic behaviors of cable stayed beams subjected to a moving load. Based on the method of reverberation-ray matrix (MRRM), the waveform solutions of the wave equations of a simplified beam-cable system subjected to a moving load (hereinafter referred to as a beam-cable system) are given, and the theory is verified by a numerical example. The dynamic response of cable stayed beams is decomposed into nine kinds of flexural waves, including traveling waves, near-field waves, and nondispersive waves, according to the wavenumber characteristics. Numerical examples are analyzed to demonstrate the propagation characteristics of flexural waves through cable stayed beams. Numerical results show that the flexural waves in the cable stayed beams are mainly low-frequency waves whose frequencies are less than 3 times the structural fundamental frequency, which can be used to further improve the computational efficiency of response analysis method based on MRRM, and the proportion of high-frequency components increases gradually with increasing structural stiffness. The near-field wave can be transformed into a traveling shear wave when its frequency is larger than the critical frequency, which decreases with increasing radius of gyration and decreasing elastic modulus of the beam. With the increase in the radius of gyration and the elastic modulus of the beam, the attenuation effect of the near-field wave weakens. The wave velocity and the wave dispersion effect have a positive correlation with the stiffness-related parameters of the beam-cable system. The study of the effect of the beam-cable system parameters on flexural wave propagation characteristics can be applied to achieve a better dynamic design for engineering structures.


Author(s):  
Masashi Suzuki ◽  
Shoji Kakio

Abstract Piezoelectricity of YbAlN films has recently been shown to be almost as high as that of ScAlN films. YbAlN film surface acoustic wave (SAW) resonators are expected to have a high coupling factor. We theoretically investigated the propagation characteristics of first-mode Rayleigh SAWs (RSAWs) on Yb0.33Al0.67N film/high-velocity Si, sapphire, AlN, SiC, BN, and diamond substrates. The first-mode RSAWs on the YbAlN layered structures had high coupling factors, higher than those on ScAlN layered structures. An enhancement of the effective coupling factor of the first mode RSAWs was observed in polarity inverted YbAlN film/BN or diamond substrate structures.


2021 ◽  
Vol 8 (4) ◽  
pp. 153-158
Author(s):  
Min Zhang ◽  
Shaolong Zhang ◽  
Shiwei Shen ◽  
Weilong Zhang

Soil–rock mixture is a special geological material between homogeneous soil masses and fractured rock masses. In this study, the shear characteristics, movement and failure characteristics of particles and the evolution law of cracks were studied by direct shear tests and particle flow numerical simulations. The results show that the shear stress-shear displacement curves of the soil–rock mixture can be roughly classified into three stages: elastic stage, plastic stage and strain softening stage, and there was a "jump" phenomenon. The higher the rock content was, the more obvious the phenomenon. The shear strength and its indices of the soil–rock mixture did not increase with increasing rock content, but there was an "optimal rock content". According to the experimental and simulation results, particle breakage can be divided into three types: slight failure, partial failure and complete failure. The crack propagation characteristics can be divided into three stages, and the crack propagation depth increases with increasing shear displacement. It increases with increasing vertical stress and decreases with increasing block rock content.


2021 ◽  
Author(s):  
Qiwei Wang ◽  
Shi Qiu ◽  
Jinhui Yuan ◽  
Guiyao Zhou ◽  
Changming Xia ◽  
...  

Abstract Hollow-core negative curvature fibers (HC-NCFs) have become one of the research hotspots in the field of optical fiber because of its potential applications in the data and energy transmissions. In this paper, a new kind of single-polarization single-mode HC-NCF with nested U-type cladding elements is proposed. To achieve the single-polarization single-mode transmission, we use two different silica tube thicknesses that satisfy the resonance and anti-resonance conditions on the U-type cladding elements and the cladding tubes, respectively. Besides, the elliptical elements are introduced to achieve good single-mode performance. By studying the influences of the structure parameters on the propagation characteristics, the optimized structure parameters are obtained. The simulation results show that when the wavelength is located at 1550 nm, the single-polarization single-mode transmission is achieved, along with the polarization extinction ratio of 25749 and minimum high-order mode extinction ratio of 174. Furthermore, the confinement loss is only 0.0015 dB/m.


Author(s):  
Kabiru Yusuf ◽  
Dahiru Sani Shuaibu ◽  
Suleiman Aliyu Babale

In this paper, we investigated the effect of different channel propagation characteristics on the performance of 4G systems from high altitude platforms (HAPs). The use of High-Altitude Platforms for communication purpose in the past focused mostly on the assumption that the platform is quasi stationary. The technical limitation of the assumption was that of ensuring stability in the positioning of the platform in space. The use of antenna steering and other approaches were proposed as a solution to the said problem. In this paper, we proposed a channel model which account for the motion of the platform. This was done by investigating the effect of Doppler shift on the carrier frequency as the signals propagate between the transmitter and receiver while the High-Altitude Platform is in motion. The basic free space model was used and subjected to the frequency variation caused by the continuous random shift due to the motion of the HAPs. The trajectory path greatly affects the system performance. A trajectory of 30km, 100km and 500km radii were simulated. An acute elevation angle was used in the simulation. The proposed model was also compared to two other channel models to illustrate its performance. The results show that the proposed model behave similar to the existing models except at base station ID 35 and 45 where the highest deviation of 20dBm was observed. Other stations that deviated were less than 2dBm.


Sign in / Sign up

Export Citation Format

Share Document