Aerodynamic noise characteristics of airfoils with morphed trailing edges

2022 ◽  
Vol 93 ◽  
pp. 108892
Author(s):  
Hasan Kamliya Jawahar ◽  
SH. S. Vemuri ◽  
Mahdi Azarpeyvand
Keyword(s):  
Aerodynamic Noise ◽  
Noise Characteristics ◽  
Trailing Edges

scholarly journals Effects of porous trailing edge on aerodynamic noise characteristics

2020 ◽  
Vol 19 (3-5) ◽  
pp. 254-271 ◽  
Author(s):  
Minghui Zhang ◽  
Tze Pei Chong
Keyword(s):  
High Reynolds Number ◽  
Experimental Testing ◽  
Low Frequency ◽  
Reynolds Numbers ◽  
Broadband Noise ◽  
Aerodynamic Noise ◽  
Trailing Edge ◽  
Noise Characteristics ◽  
Trailing Edges ◽  
High Reynolds

The objective of this work is to investigate the effect of the porous trailing edge on the aeroacoustics performance of the NACA 65(12)-10 aerofoil. The motivation behind this study is to investigate the effect of the porous parameters to explore the noise control concepts. Experimental testing in an aeroacoustics open jet wind tunnel was performed at chord-based Reynolds numbers between 0.2 and 0.6 million, and effective angles of attack at ±1.7 degree, including at 0 degrees. The porous trailing edge at porosity 30% with different holes diameters and the length of these porous trailing edges are used in the acoustic experiments. The study reveals that the level of the reduction of the broadband noise becomes larger as the diameter of the holes decreases and the length of the porous trailing edge increases at lower Reynolds numbers. Bluntness-induced tone noise is produced at high Reynolds number. Meanwhile, the porous trailing edge can suppress the laminar instability noise at the middle and low frequency regions.

Study on the Influence of Inlet Asymmetry on Aerodynamic Noise of Cooling Fan

2020 ◽  
Author(s):  
Jie Tian ◽  
Zonghan Sun ◽  
Pengfei Chai ◽  
Hua Ouyang
Keyword(s):  
Heat Dissipation ◽  
Electronic Device ◽  
Numerical Study ◽  
Rotor Blades ◽  
Aerodynamic Noise ◽  
Sampling Point ◽  
Inlet Flow ◽  
Cooling Fan ◽  
Noise Characteristics ◽  
Correction Technique

Abstract Experimental and numerical studies on the aerodynamic noise characteristics of a variable-speed axial fan commonly used for electronic device heat dissipation were conducted. First, the far-field noise spectrum of the fan was measured using a microphone array on the contour plane of the fan axis. The spectral analysis indicated that the discrete single-tone noise energy ratio was high, which indicates that it was the dominant aerodynamic noise. Afterwards, the double-uniform sampling point mode correction technique, which is based on the circumferential acoustic mode measurement method, was used to obtain the modal distribution on the inlet and outlet sides of the cooling fan. The influence of inlet unevenness on the cooling fan was identified. The traditional Tyler-Sofrin rotor-stator interaction formula was modified to account for the non-axisymmetric shape of the fan inlet bellmouth. The validity of the modified formula was verified by measuring the circumferential acoustic modes of three cooling fans with different rotor and strut counts. Furthermore, a CFD numerical study was conducted using Fluent to understand the influence of uneven inlet flow. The results showed that uneven inlet flow significantly affects the size and distribution of unsteady pulses on the rotor blades, which cause regular, periodic changes as the rotor blades rotate. Interactions between rotor blades and inlet unevenness were observed via the POD method as well. The discussion of the circumferential modes from aerodynamic noise of an axial flow cooling fan can act as a reference for further cooling fan noise reduction measures.

scholarly journals Numerical Modeling and Investigation on Aerodynamic Noise Characteristics of Pantographs in High-Speed Trains

Complexity ◽  
2018 ◽  
Vol 2018 ◽  
pp. 1-12 ◽  
Author(s):  
Xiaoqi Sun ◽  
Han Xiao
Keyword(s):  
High Frequency ◽  
High Speed ◽  
Sound Pressure ◽  
Noise Source ◽  
Flow Fields ◽  
Aerodynamic Noise ◽  
Far Field ◽  
Frequency Bands ◽  
Noise Characteristics ◽  
High Speed Trains

Pantographs are important devices on high-speed trains. When a train runs at a high speed, concave and convex parts of the train cause serious airflow disturbances and result in flow separation, eddy shedding, and breakdown. A strong fluctuation pressure field will be caused and transformed into aerodynamic noises. When high-speed trains reach 300 km/h, aerodynamic noises become the main noise source. Aerodynamic noises of pantographs occupy a large proportion in far-field aerodynamic noises of the whole train. Therefore, the problem of aerodynamic noises for pantographs is outstanding among many aerodynamics problems. This paper applies Detached Eddy Simulation (DES) to conducting numerical simulations of flow fields around pantographs of high-speed trains which run in the open air. Time-domain characteristics, frequency-domain characteristics, and unsteady flow fields of aerodynamic noises for pantographs are obtained. The acoustic boundary element method is used to study noise radiation characteristics of pantographs. Results indicate that eddies with different rotation directions and different scales are in regions such as pantograph heads, hinge joints, bottom frames, and insulators, while larger eddies are on pantograph heads and bottom frames. These eddies affect fluctuation pressures of pantographs to form aerodynamic noise sources. Slide plates, pantograph heads, balance rods, insulators, bottom frames, and push rods are the main aerodynamic noise source of pantographs. Radiated energies of pantographs are mainly in mid-frequency and high-frequency bands. In high-frequency bands, the far-field aerodynamic noise of pantographs is mainly contributed by the pantograph head. Single-frequency noises are in the far-field aerodynamic noise of pantographs, where main frequencies are 293 Hz, 586 Hz, 880 Hz, and 1173 Hz. The farther the observed point is from the noise source, the faster the sound pressure attenuation will be. When the distance of two adjacent observed points is increased by double, the attenuation amplitude of sound pressure levels for pantographs is around 6.6 dB.

Study on the Influence of Inlet Asymmetry on Aerodynamic Noise of Cooling Fan

2020 ◽  
Vol 142 (12) ◽  
Author(s):  
Jie Tian ◽  
Zonghan Sun ◽  
Pengfei Chai ◽  
Hua Ouyang
Keyword(s):  
Heat Dissipation ◽  
Electronic Device ◽  
Numerical Study ◽  
Rotor Blades ◽  
Aerodynamic Noise ◽  
Sampling Point ◽  
Inlet Flow ◽  
Cooling Fan ◽  
Noise Characteristics ◽  
Correction Technique

Abstract Experimental and numerical studies on the aerodynamic noise characteristics of a variable-speed axial fan commonly used for electronic device heat dissipation were conducted. First, the far-field noise spectrum of the fan was measured using a microphone on the contour plane of the fan axis. The spectral analysis indicated that the discrete single-tone noise energy ratio was high, which indicates that it was the dominant aerodynamic noise. Afterward, the double-uniform sampling point mode correction technique, which is based on the circumferential acoustic mode measurement method, was used to obtain the modal distribution on the inlet and outlet sides of the cooling fan. The influence of inlet unevenness on the cooling fan was identified. The traditional Tyler–Sofrin rotor–stator interaction formula was modified to account for the nonaxisymmetric shape of the fan inlet bellmouth. The validity of the modified formula was verified by measuring the circumferential acoustic modes of three cooling fans with different rotor and strut counts. Furthermore, a computational fluid dynamics (CFD) numerical study was conducted using Fluent to understand the influence of uneven inlet flow. The results showed that uneven inlet flow significantly affects the size and distribution of unsteady pulses on the rotor blades, which cause regular, periodic changes as the rotor blades rotate. Interactions between rotor blades and inlet unevenness were observed via the proper orthogonal decomposition (POD) method as well. The discussion of the circumferential modes from aerodynamic noise of an axial flow cooling fan can act as a reference for further cooling fan noise reduction measures.

Sign in / Sign up

Export Citation Format

Share Document