Study on the flow behaviour and aerodynamic noise characteristics of a high-speed pantograph under crosswinds

2020 ◽  
Vol 63 (6) ◽  
pp. 977-991
Author(s):  
YaDong Zhang ◽  
JiYe Zhang ◽  
XiaoZhen Sheng
Complexity ◽  
2018 ◽  
Vol 2018 ◽  
pp. 1-12 ◽  
Author(s):  
Xiaoqi Sun ◽  
Han Xiao

Pantographs are important devices on high-speed trains. When a train runs at a high speed, concave and convex parts of the train cause serious airflow disturbances and result in flow separation, eddy shedding, and breakdown. A strong fluctuation pressure field will be caused and transformed into aerodynamic noises. When high-speed trains reach 300 km/h, aerodynamic noises become the main noise source. Aerodynamic noises of pantographs occupy a large proportion in far-field aerodynamic noises of the whole train. Therefore, the problem of aerodynamic noises for pantographs is outstanding among many aerodynamics problems. This paper applies Detached Eddy Simulation (DES) to conducting numerical simulations of flow fields around pantographs of high-speed trains which run in the open air. Time-domain characteristics, frequency-domain characteristics, and unsteady flow fields of aerodynamic noises for pantographs are obtained. The acoustic boundary element method is used to study noise radiation characteristics of pantographs. Results indicate that eddies with different rotation directions and different scales are in regions such as pantograph heads, hinge joints, bottom frames, and insulators, while larger eddies are on pantograph heads and bottom frames. These eddies affect fluctuation pressures of pantographs to form aerodynamic noise sources. Slide plates, pantograph heads, balance rods, insulators, bottom frames, and push rods are the main aerodynamic noise source of pantographs. Radiated energies of pantographs are mainly in mid-frequency and high-frequency bands. In high-frequency bands, the far-field aerodynamic noise of pantographs is mainly contributed by the pantograph head. Single-frequency noises are in the far-field aerodynamic noise of pantographs, where main frequencies are 293 Hz, 586 Hz, 880 Hz, and 1173 Hz. The farther the observed point is from the noise source, the faster the sound pressure attenuation will be. When the distance of two adjacent observed points is increased by double, the attenuation amplitude of sound pressure levels for pantographs is around 6.6 dB.


2012 ◽  
Vol 15 (3) ◽  
pp. 231-236 ◽  
Author(s):  
Hee-Min Noh ◽  
Sung-Hoon Choi ◽  
Hyo-In Koh ◽  
Suk-Yoon Hong

2020 ◽  
Vol 27 (6) ◽  
pp. 1802-1813
Author(s):  
Xi-feng Liang ◽  
Hui-fang Liu ◽  
Tian-yun Dong ◽  
Zhi-gang Yang ◽  
Xiao-ming Tan

2019 ◽  
Vol 9 (11) ◽  
pp. 2332 ◽  
Author(s):  
Yongfang Yao ◽  
Zhenxu Sun ◽  
Guowei Yang ◽  
Wen Liu ◽  
Prasert Prapamonthon

The high-speed-train pantograph is a complex structure that consists of different rod-shaped and rectangular surfaces. Flow phenomena around the pantograph are complicated and can cause a large proportion of aerodynamic noise, which is one of the main aerodynamic noise sources of a high-speed train. Therefore, better understanding of aerodynamic noise characteristics is needed. In this study, the large eddy simulation (LES) coupled with the acoustic finite element method (FEM) is applied to analyze aerodynamic noise characteristics of a high-speed train with a pantograph installed on different configurations of the roof base, i.e. flush and sunken surfaces. Numerical results are presented in terms of acoustic pressure spectra and distributions of aerodynamic noise in near-field and far-field regions under up- and down-pantograph as well as flushed and sunken pantograph base conditions. The results show that the pantograph with the sunken base configuration provides better aerodynamic noise performances when compared to that with the flush base configuration. The noise induced by the down-pantograph is higher than that by the up-pantograph under the same condition under the pantograph shape and opening direction selected in this paper. The results also indicate that, in general, the directivity of the noise induced by the down-pantograph with sunken base configuration is slighter than that with the flush configuration. However, for the up-pantograph, the directivity is close to each other in Y-Z or X-Z plane whether it is under flush or sunken roof base condition. However, the sunken installation is still conducive to the noise environment on both sides of the track.


2014 ◽  
Vol 488-489 ◽  
pp. 886-891
Author(s):  
Ai Jian Zheng ◽  
Feng Niu ◽  
Hai Jiang Zhu

This paper presents two nose cones models and their numerical calculation of aerodynamic noise in high speed airflow field combining the analysis theory of fluid dynamics with the acoustic boundary element analysis method. The noise sound pressure levels (SPL) of these two models are calculated under the different speed airflow. And we compare the SPL of the better model with that of commercial nose cone models. These simulated results show that the aerodynamic noise of the nose cone with a ellipsoid head has lower flow-induced noise than that of commercial nose cone models at relative high air flow velocities at most frequencies.


Sign in / Sign up

Export Citation Format

Share Document