Hybrid high energy femtosecond laser system based on Yb:YAG single crystal fiber amplifier

Optik ◽  
2018 ◽  
Vol 156 ◽  
pp. 155-160 ◽  
Author(s):  
Feng Li ◽  
Zhi yang ◽  
Yishan Wang ◽  
Zhiguo Lv ◽  
Qianglong Li ◽  
...  
2012 ◽  
Vol 285 (10-11) ◽  
pp. 2715-2718 ◽  
Author(s):  
Chi Zhang ◽  
Yu-ying Zhang ◽  
Ming-lie Hu ◽  
Si-jia Wang ◽  
You-jian Song ◽  
...  

2009 ◽  
Vol 36 (11) ◽  
pp. 2812-2816
Author(s):  
刘华刚 Liu Huagang ◽  
胡明列 Hu Minglie ◽  
刘博文 Liu Bowen ◽  
宋有建 Song Youjian ◽  
柴路 Chai Lu ◽  
...  

Crystals ◽  
2019 ◽  
Vol 9 (4) ◽  
pp. 216
Author(s):  
Feng Li ◽  
Zhi Yang ◽  
Zhiguo Lv ◽  
Yang Yang ◽  
Yishan Wang ◽  
...  

A laser master oscillator power amplifier (MOPA) system consisting of a fiber amplifier and a two-stage Yb:YAG single crystal fiber (SCF) is experimentally studied. The nonlinear stimulated Raman scattering (SRS) is avoided by limiting the output power of the fiber preamplifier to 600 mW. Due to the benefit from the low nonlinearity and high amplification gain of the SCF, a laser pulse duration of 16.95 ps and a high average power of 41.7 W at a repetition rate of 250 kHz are obtained by using a two-stage polarization controlled double-pass amplification of Yb:YAG SCF, corresponding to an output energy of 166.8 μJ and a peak power of 9.84 MW, respectively. The polarization controlled SCF amplification scheme achieved a gain as high as more than 69 times. During the amplification, the spectra gain narrowing effect and the polarization controlled four-pass amplification setup are also studied. The laser spectrum is narrowed from over 10 nm to less than 3 nm, and the pulse width is also compressed to hundreds of femtosecond by dechirping the laser pulse. This compact-sized, cost-effective laser source can be used in laser micromachining, or as the seeder source for generating much higher power and energy laser for scientific research. For some applications which need femtosecond laser, this laser source can also be compressed to femtosecond regime.


2016 ◽  
Author(s):  
Vesna Markovic ◽  
Andreas Rohrbacher ◽  
Peter Hofmann ◽  
Wolfgang Pallmann ◽  
Simonette Pierrot ◽  
...  

2020 ◽  
Vol 8 ◽  
Author(s):  
François Lureau ◽  
Guillaume Matras ◽  
Olivier Chalus ◽  
Christophe Derycke ◽  
Thomas Morbieu ◽  
...  

Abstract We report on a two-arm hybrid high-power laser system (HPLS) able to deliver 2 × 10 PW femtosecond pulses, developed at the Bucharest-Magurele Extreme Light Infrastructure Nuclear Physics (ELI-NP) Facility. A hybrid front-end (FE) based on a Ti:sapphire chirped pulse amplifier and a picosecond optical parametric chirped pulse amplifier based on beta barium borate (BBO) crystals, with a cross-polarized wave (XPW) filter in between, has been developed. It delivers 10 mJ laser pulses, at 10 Hz repetition rate, with more than 70 nm spectral bandwidth and high-intensity contrast, in the range of 1013:1. The high-energy Ti:sapphire amplifier stages of both arms were seeded from this common FE. The final high-energy amplifier, equipped with a 200 mm diameter Ti:sapphire crystal, has been pumped by six 100 J nanosecond frequency doubled Nd:glass lasers, at 1 pulse/min repetition rate. More than 300 J output pulse energy has been obtained by pumping with only 80% of the whole 600 J available pump energy. The compressor has a transmission efficiency of 74% and an output pulse duration of 22.7 fs was measured, thus demonstrating that the dual-arm HPLS has the capacity to generate 10 PW peak power femtosecond pulses. The reported results represent the cornerstone of the ELI-NP 2 × 10 PW femtosecond laser facility, devoted to fundamental and applied nuclear physics research.


Sign in / Sign up

Export Citation Format

Share Document