Optimization of alcoholic soybean oil extraction as a step towards developing in-situ transesterification for fatty acid isopropyl esters

2016 ◽  
Vol 94 ◽  
pp. 189-196 ◽  
Author(s):  
Nattapong Tuntiwiwattanapun ◽  
Chantra Tongcumpou ◽  
Dennis Wiesenborn
2017 ◽  
Vol 10 (27) ◽  
pp. 1319-1327
Author(s):  
Angel Dario Gonzalez-Delgado ◽  
Andres Fernando Barajas-Solano ◽  
Yeimmy Yolima Peralta-Ruiz

Microalgae has recently been highlighted as source of valuable products including biofuel. The production process of biofuels from microalgae involves mass cultivation, harvesting, deep dewatering, lipid extraction and biofuel conversion. In this work, lipids from microalgae Navicula sp. were obtained using multifunctional process that consists of acid hydrolysis or cellular disruption, oil extraction and in situ transesterification. The effect of alcohol added to produce ethyl and methyl esters on lipid extraction efficiency was evaluated using methanol and ethanol in order to determine the most suitable route for obtaining the high values of lipids and total reducing sugar. The highest lipid extraction efficiency and total reducing sugar (7.72 % and 2.63 mg/ml, respectively) was obtained for methanol. The low lipid extraction efficiency of multifuctional process is due to transesterification of lipids that gradually released into the system. The formation of alkyl esters was confirmed by FTIR with an increase in carbonyl peak as the reaction progressed, thus muntifuctional process reduce cost of alkyl esters production by eliminating the step of lipid extraction by solvent.


2014 ◽  
Vol 68 ◽  
pp. 560-569 ◽  
Author(s):  
Vikram Kumar ◽  
Muthusivaramapandian Muthuraj ◽  
Basavaraj Palabhanvi ◽  
Aloke Kumar Ghoshal ◽  
Debasish Das

2020 ◽  
Vol 2020 ◽  
pp. 1-10
Author(s):  
Alex K. Koech ◽  
Anil Kumar ◽  
Zachary O. Siagi

The present technology of transesterification of vegetable oils to produce biodiesel, which is suited to replace petrodiesel, has economic challenges, and therefore, alternative sources are being explored. Microalgae, a renewable, third-generation biofuel resource, have the potential to become a viable feedstock due to their high oil content and environmentally friendly nature. The present study investigates the effect of microwave irradiation on the simultaneous extraction and transesterification of algae lipids to produce fatty acid methyl ester (FAME), in a batch reaction system using sulphuric acid catalyst. In situ transesterification combines the two steps of lipid extraction and transesterification into a single step. The microwave synthesis unit comprised of a 3-neck round bottom flask inside a 1300-Watt microwave oven, fitted with a quick-fit condenser and having an external stirrer. Response surface methodology (RSM) was used to analyse the influence of process variables, dry algae to methanol ratio 1 : 4 − 1 : 14   g / ml , algae biomass to catalyst ratio 1 : 0.0032 − 1 : 0.0368   wt % , and reaction time 1 − 11   min , at 500  rpm stirring rate for in situ reaction. FAME was analysed using gas chromatography (GC). The total lipid content of Arthrospira Spirulina platensis microalgae biomass was found to be 10.7 % by weight. The algae biomass also contained proteins at   51.83 % , moisture content at 7.8 % , and ash content 14.30 % by weight. RSM gave the optimum process conditions as dry algae biomass feed to methanol wt / vol ratio of 1 : 9, catalyst concentration of 2   wt % , and reaction time of   7   minutes   for a maximum FAME yield of 83.43   wt % . The major fatty acid composition of FAME was palmitic 43.83 % , linoleic   38.83 % , and linolenic 19.41 % . FAME properties obtained according to European Standards (EN 14214) and American Society for Testing and Materials (ASTM D 6751) standards were as follows: flash point 16 4 o C calorific value 32,911   kJ / kg , acid value 0.475 KOH / g , viscosity 4.45   m m 2 / s , and specific gravity   0.868 . The study showed that Arthrospira Spirulina platensis microalgae lipid FAME met the biodiesel standards (EN 14214 and ASTM D 6751) and has the potential to replace petrodiesel. Microwave irradiation increased the reaction rate resulting in a reduced reaction time of 7 minutes (as compared to 8 hours for conventional heating) and therefore was found to be a superior heating mode as compared to conventional heating.


2012 ◽  
Vol 403 (1) ◽  
pp. 167-178 ◽  
Author(s):  
Lieve M. L. Laurens ◽  
Matthew Quinn ◽  
Stefanie Van Wychen ◽  
David W. Templeton ◽  
Edward J. Wolfrum

Sign in / Sign up

Export Citation Format

Share Document