Thermodynamic behaviour of binary mixture of 1,3-dimethoxyimidazolium bis(trifluoromethyl-sulfonyl)imide and water

Author(s):  
Sayeed Ashique Ahmed ◽  
Aditya Meena ◽  
Debabrata Seth
2002 ◽  
Author(s):  
Sophie Mergui ◽  
Boubaker Feroual ◽  
Christine Benard ◽  
Dominique Gobin
Keyword(s):  

Author(s):  
Fernando Manente Perrella Balestieri ◽  
Carlos Manuel Romero Luna ◽  
Ivonete Ávila

1999 ◽  
Vol 64 (4) ◽  
pp. 726-734 ◽  
Author(s):  
Miloslav Pekař ◽  
Josef Koubek

Various kinetic pathways to the adsorption equilibrium in an isothermal differential bed of adsorbent are illustrated on several examples. Discussion is based on the computed transient responses of adsorption rate and distance from adsorption equilibrium to the start of adsorptive feed. It is shown that adsorption behaviour in flow system may not be smooth and very steep changes on the rate responses may appear. Even the simple reaction need not approach equilibrium smoothly but at a jump. The approach assuming "closeness to the equilibrium" should be used very carefully, in this case.


2021 ◽  
Vol 42 (9) ◽  
Author(s):  
Nils von Preetzmann ◽  
Reiner Kleinrahm ◽  
Philipp Eckmann ◽  
Giuseppe Cavuoto ◽  
Markus Richter

AbstractDensities of an air-like binary mixture (0.2094 oxygen + 0.7906 nitrogen, mole fractions) were measured along six isotherms over the temperature range from 100 K to 298.15 K at pressures up to 8.0 MPa, using a low-temperature single-sinker magnetic suspension densimeter. The measurements were carried out at T = (100, 115, and 130) K in the homogeneous gas and liquid region, and at T = (145, 220, and 298.15) K in the supercritical region (critical temperature TC = 132.35 K); in total, we present results for 52 (T, p) state points. The relative expanded combined uncertainty (k = 2) of the experimental densities was estimated to be between 0.03 % and 0.13 %, except for four values near the critical point. The largest error is caused by the magnetic suspension coupling in combination with the mixture component oxygen, which is strongly paramagnetic; the resulting force transmission error is up to 1.1 %. However, this error can be corrected with a proven correction model to an uncertainty contribution in density of less than 0.044 %. Due to a supercritical liquefaction procedure and the integration of a special VLE-cell, it was possible to measure densities in the homogeneous liquid phase without changing the composition of the liquefied mixture. Moreover, saturated liquid and saturated vapor densities were determined at T = (100, 115, and 130) K by extrapolation of the experimental single-phase densities to the saturation pressure. The new experimental results were compared with the mixture model of Lemmon et al. for the system (nitrogen + argon + oxygen) and the GERG-2008 equation of state.


2021 ◽  
Vol 330 ◽  
pp. 115503
Author(s):  
Xinzi Zhou ◽  
Haiyun Hou ◽  
Junru Wang ◽  
Luohong Zhang ◽  
Haojun Shi ◽  
...  
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document