scholarly journals Performance enhancement of polymer electrolyte fuel cells by combining liquid removal mechanisms of a gas diffusion layer with wettability distribution and a gas channel with microgrooves

2016 ◽  
Vol 323 ◽  
pp. 37-43 ◽  
Author(s):  
Yoshio Utaka ◽  
Ryo Koresawa
Keyword(s):  
Fuel Cells ◽  
Polymer Electrolyte ◽  
Diffusion Layer ◽  
Performance Enhancement ◽  
Gas Diffusion Layer ◽  
Gas Diffusion ◽  
Polymer Electrolyte Fuel Cells ◽  
Gas Channel ◽  
Removal Mechanisms ◽  
Liquid Removal

Fabrication and Characterization of Tuneable Flow-Channel/Gas-Diffusion-Layer Interface for Polymer Electrolyte Fuel Cells

2019 ◽  
Vol 17 (1) ◽  
Author(s):  
Deepashree Thumbarathy ◽  
Gaurav Gupta ◽  
Mohamed Mamlouk ◽  
Prodip K. Das
Keyword(s):  
Fuel Cells ◽  
Surface Morphology ◽  
Polymer Electrolyte ◽  
Diffusion Layer ◽  
Gas Diffusion Layer ◽  
Gas Diffusion ◽  
Polymer Electrolyte Fuel Cells ◽  
Flow Channel ◽  
Surface Wettability ◽  
Selective Wetting

Abstract Gas diffusion layer (GDL) and its interfaces with the flow-channel and microporous layer or catalyst layer in polymer electrolyte fuel cells (PEFCs) play a significant role in water management and heat removal from the cells. Both surface morphology and surface wettability of GDL influence and control the water transport in PEFCs. Thus, the surface morphology and selectivity of its surface wettability are critical for PEFCs to provide optimum outputs. In this study, we have reported the fabrications of GDLs with a selective wetting pattern. Sigracet® GDLs were used as a substrate and two different monomers, polydimethylsiloxane (PDMS) added with fumed silica (Si) and fluorinated ethylene propylene (FEP), were used to print a selective pattern on the GDL surfaces. The evaluations of printed GDL surfaces, by means of static contact angle, sliding angles, and scanning electron microscopy image show that superhydrophobicity was achieved with both FEP and PDMS-Si coatings. Fourier transform infrared spectroscopy analysis confirmed the successful introduction of the functional groups in both the coatings. Finally, pore size distributions, sliding angle measurements, and adhesion forces were used to investigate the interactions between the water droplets and GDL surfaces. The results of this study demonstrate that the present approach provides a novel but simple way to tune GDL surfaces with selective wetting properties and obtain superhydrophobic interfaces. The electrochemical results showed that an improvement can be achieved for the performance of PEFCs with patterned GDL/flow-channel interfaces.

Sign in / Sign up

Export Citation Format

Share Document