Use of a mechanical analogy to couple the time-domain of a one-cylinder cold-engine model with the input impedance of its intake system

2011 ◽  
Vol 330 (23) ◽  
pp. 5769-5783 ◽  
Author(s):  
S. Rodriguez ◽  
V. Gibiat ◽  
A. Lefebvre ◽  
S. Guilain
Author(s):  
Bingjie Guo ◽  
Eivind Ruth ◽  
Håvard Austefjord ◽  
Elzbieta M. Bitner-Gregersen ◽  
Odin Gramstad

IMO introduced Energy Efficiency Design Index (EEDI) to regulate the greenhouse gas (GHG) emissions from ships. The cheapest and easiest way to fulfil the EEDI requirement is to reduce installed power for most ships. Therefore, it has raised serious concerns that some ship designers might choose to lower the installed power to achieve EEDI requirements and not consider ship safety in a satisfactory way. This could induce ship manoeuvrability and safety problems in adverse seas, which needs urgent investigations on minimum power to maintain ship manoeuvrability in adverse sea. A time domain code ‘Waqum’ has been developed based on the force superposition of unified theory to study the minimum required power for maintaining ship manoeuvring ability in adverse sea states. The code combines sea-keeping and maneuvering equations, together with an engine model to predict ship responses in waves. The code can help us to study ship responses in transit situation and give us better insight into ship maneuvering ability in adverse sea states. In order to improve the simulation speed, the time domain code does not calculate all the hydrodynamic forces directly. Thus, some precalculations should be done for some force components before launching the simulation for a new ship. Therefore, the methodology and accuracy of each force component will influence the accuracy of the manoeuvring code. The methodology for determining each force component will be discussed, especially the identification of maneuvering derivatives based on CFD simulations. The code has been improved recently, and another rudder model has been implemented. Further, the the code with new rudder model is verified in calm water. The code’s ability to capture ship maneuvering in waves is also demonstrated.


1980 ◽  
Vol 238 (6) ◽  
pp. H932-H937 ◽  
Author(s):  
H. Piene

Piene and Sund (Cardiovasc. Res., 1980) have recently demonstrated that the performance of the ventricle can be expressed by relating the principal variables pressure (P), volume (V), and time after onset of contraction (t): P = function (V,t). The function can be mapped experimentally as a three-dimensional surface, denoted the PVt surface, and can thereafter be approximated by an empirical equation. The vascular load of the ventricle is defined by the arterial input impedance vs. frequency graph, Z(f), which can be converted to the time domain by inverse Fourier transformation. This report describes how flow and pressure generated by the ventricle can be calculated when the independent expressions for the ventricle and for the load are given. The method is applied on right ventricular contractions of isolated cat hearts, and excellent fit between calculated and observed flow and pressure curves was obtained.


1992 ◽  
Vol 2 (4) ◽  
pp. 615-620
Author(s):  
G. W. Series
Keyword(s):  

2018 ◽  
Vol 12 (7-8) ◽  
pp. 76-83
Author(s):  
E. V. KARSHAKOV ◽  
J. MOILANEN

Тhe advantage of combine processing of frequency domain and time domain data provided by the EQUATOR system is discussed. The heliborne complex has a towed transmitter, and, raised above it on the same cable a towed receiver. The excitation signal contains both pulsed and harmonic components. In fact, there are two independent transmitters operate in the system: one of them is a normal pulsed domain transmitter, with a half-sinusoidal pulse and a small "cut" on the falling edge, and the other one is a classical frequency domain transmitter at several specially selected frequencies. The received signal is first processed to a direct Fourier transform with high Q-factor detection at all significant frequencies. After that, in the spectral region, operations of converting the spectra of two sounding signals to a single spectrum of an ideal transmitter are performed. Than we do an inverse Fourier transform and return to the time domain. The detection of spectral components is done at a frequency band of several Hz, the receiver has the ability to perfectly suppress all sorts of extra-band noise. The detection bandwidth is several dozen times less the frequency interval between the harmonics, it turns out thatto achieve the same measurement quality of ground response without using out-of-band suppression you need several dozen times higher moment of airborne transmitting system. The data obtained from the model of a homogeneous half-space, a two-layered model, and a model of a horizontally layered medium is considered. A time-domain data makes it easier to detect a conductor in a relative insulator at greater depths. The data in the frequency domain gives more detailed information about subsurface. These conclusions are illustrated by the example of processing the survey data of the Republic of Rwanda in 2017. The simultaneous inversion of data in frequency domain and time domain can significantly improve the quality of interpretation.


2019 ◽  
Vol 629 ◽  
pp. A112 ◽  
Author(s):  
B. M. Giuliano ◽  
A. A. Gavdush ◽  
B. Müller ◽  
K. I. Zaytsev ◽  
T. Grassi ◽  
...  

Context. Reliable, directly measured optical properties of astrophysical ice analogues in the infrared and terahertz (THz) range are missing from the literature. These parameters are of great importance to model the dust continuum radiative transfer in dense and cold regions, where thick ice mantles are present, and are necessary for the interpretation of future observations planned in the far-infrared region. Aims. Coherent THz radiation allows for direct measurement of the complex dielectric function (refractive index) of astrophysically relevant ice species in the THz range. Methods. We recorded the time-domain waveforms and the frequency-domain spectra of reference samples of CO ice, deposited at a temperature of 28.5 K and annealed to 33 K at different thicknesses. We developed a new algorithm to reconstruct the real and imaginary parts of the refractive index from the time-domain THz data. Results. The complex refractive index in the wavelength range 1 mm–150 μm (0.3–2.0 THz) was determined for the studied ice samples, and this index was compared with available data found in the literature. Conclusions. The developed algorithm of reconstructing the real and imaginary parts of the refractive index from the time-domain THz data enables us, for the first time, to determine the optical properties of astrophysical ice analogues without using the Kramers–Kronig relations. The obtained data provide a benchmark to interpret the observational data from current ground-based facilities as well as future space telescope missions, and we used these data to estimate the opacities of the dust grains in presence of CO ice mantles.


2009 ◽  
Vol 6 (7) ◽  
pp. 577-580
Author(s):  
N. H. Adamyan ◽  
H. H. Adamyan ◽  
G. Yu. Kryuchkyan

2019 ◽  
Vol 141 (5) ◽  
Author(s):  
Wei Xiong ◽  
Qingbo He ◽  
Zhike Peng

Wayside acoustic defective bearing detector (ADBD) system is a potential technique in ensuring the safety of traveling vehicles. However, Doppler distortion and multiple moving sources aliasing in the acquired acoustic signals decrease the accuracy of defective bearing fault diagnosis. Currently, the method of constructing time-frequency (TF) masks for source separation was limited by an empirical threshold setting. To overcome this limitation, this study proposed a dynamic Doppler multisource separation model and constructed a time domain-separating matrix (TDSM) to realize multiple moving sources separation in the time domain. The TDSM was designed with two steps of (1) constructing separating curves and time domain remapping matrix (TDRM) and (2) remapping each element of separating curves to its corresponding time according to the TDRM. Both TDSM and TDRM were driven by geometrical and motion parameters, which would be estimated by Doppler feature matching pursuit (DFMP) algorithm. After gaining the source components from the observed signals, correlation operation was carried out to estimate source signals. Moreover, fault diagnosis could be carried out by envelope spectrum analysis. Compared with the method of constructing TF masks, the proposed strategy could avoid setting thresholds empirically. Finally, the effectiveness of the proposed technique was validated by simulation and experimental cases. Results indicated the potential of this method for improving the performance of the ADBD system.


Sign in / Sign up

Export Citation Format

Share Document