Influence of feeding increasing level of dry or modified wet corn distillers grains plus solubles in whole corn grain-based finishing diets on growth performance, carcass traits, and feeding behavior in finishing cattle

2014 ◽  
Vol 161 ◽  
pp. 53-59 ◽  
Author(s):  
H. Salim ◽  
K.M. Wood ◽  
P.L. McEwen ◽  
G. Vandervoort ◽  
S.P. Miller ◽  
...  
2020 ◽  
Vol 98 (10) ◽  
Author(s):  
Karen M Koenig ◽  
Gwinyai E Chibisa ◽  
Gregory B Penner ◽  
Karen A Beauchemin

Abstract High grain diets are fed to finishing beef cattle to maximize animal performance in a cost-effective manner. However, a small amount of roughage is incorporated in finishing diets to help prevent ruminal acidosis, although few studies have examined optimum roughage inclusion level in barley-based diets. The objective of the study was to evaluate the effects of roughage proportion in barley-based finishing diets on growth performance, feeding behavior, and carcass traits of feedlot cattle. Crossbred beef steers (n = 160; mean body weight ± SD, 349.7 ± 21.4 kg) were allocated to 20 pens that were assigned randomly to four dietary treatments (five pens of eight steers per treatment). The treatment diets contained barley silage at 0%, 4%, 8%, and 12% of dietary dry matter (DM). The remainder of the diets (DM basis) consisted of 80%, 76%, 72%, and 68% barley grain, respectively, 15% corn dried distiller’s grains, 5% mineral and vitamin supplement, and 32 mg monensin/kg diet DM. The diets were fed as total mixed rations for ad libitum intake (minimum of 5% refusal) once per day. Cattle were weighed on 2 consecutive days at the start and end of the experiment and on 1 d every 3 wk throughout the experiment (124 d). Two pens for each treatment group were equipped with an electronic feeding system (GrowSafe Systems Ltd., Calgary, Alberta) to monitor feed intake and feeding behavior of individual cattle. The data for dry matter intake (DMI), average daily gain (ADG), gain:feed (G:F) ratio, and carcass traits were analyzed as a completely randomized design with fixed effect of barley silage proportion and pen replicate as experimental unit. Feeding behavior data were analyzed similarly, but with animal as experimental unit. Averaged over the study, DMI increased linearly (11.1, 11.3, 11.7, 11.8 kg/d; P = 0.001) as barley silage proportion increased from 0%, 4%, 8%, and 12% of DM, but ADG was not affected (carcass-adjusted,1.90, 1.85, 1.87, 1.89 kg/d; P ≥ 0.30). Consequently, G:F ratio decreased linearly (carcass-adjusted, 168.9, 163.8, 158.5, 160.6 g/kg DMI; P = 0.023). When averaged over the study, proportion of barley silage in the diet had no linear or quadratic effects (P > 0.10) on meal frequency, duration of meals, intermeal duration, or meal size, but eating rate decreased linearly with increasing silage proportion (P = 0.008). There was no diet effect on liver abscesses (P ≥ 0.92), and effects on carcass characteristics were minor or nonexistent. We conclude that increasing the proportion of barley silage in a feedlot finishing diet at the expense of barley grain to minimize the incidence of ruminal acidosis may decrease feed conversion efficiency.


2015 ◽  
Vol 95 (3) ◽  
pp. 407-415 ◽  
Author(s):  
H. Salim ◽  
K. M. Wood ◽  
J. P. Cant ◽  
K. C. Swanson

Salim, H., Wood, K. M., Cant, J. P. and Swanson, K. C. 2015. Influence of feeding increasing levels of dry or modified wet corn distillers’ grains plus solubles in whole corn grain-based finishing diets on hepatic and renal mass, and glutathione peroxidase and urea cycle enzyme activities in finishing cattle. Can. J. Anim. Sci. 95: 407–415. Forty-two cross-bred steers (BW=357±5.8 kg) fed whole corn grain-based finishing diets were used in a completely randomized block (60, 120, or 180 d on feed) design (2×3 factorial arrangement of treatments plus control) to determine the effect of inclusion level [0 (control), 16.7, 33.3, and 50% of diet DM) and form (dry (DDGS) or modified wet (MWDGS)] of distillers’ grains plus solubles (DGS) on hepatic and renal glutathione peroxidase (GPx) and hepatic urea cycle enzyme activities. Kidney weight (g kg−1of BW) increased linearly (P=0.004) with increasing inclusion levels of DGS. There were no effects (P≥0.11) of dietary treatment on hepatic and renal GPx activity (U g−1, U mg−1of protein, and kU liver−1). Hepatic carbamoyl phosphate synthetase activity (kU liver−1and U kg−1of BW) tended to linearly increase (P=0.09 and P=0.10, respectively) with increasing inclusion level of DGS. Hepatic ornithine transcarbamoylase and argininosuccinate synthetase activity (kU liver−1and U kg−1of BW) increased linearly (P≤0.05) with increasing inclusion levels of DGS. These data indicate that steers adapt to feeding up to 50% DGS by increasing kidney mass and activity of urea cycle enzymes in liver to allow for clearance of excess nitrogen. Also, hepatic and renal GPx activity, as an indicator of Se status, is not affected when typical finishing diets are fed.


2016 ◽  
Vol 96 (3) ◽  
pp. 294-298 ◽  
Author(s):  
H. Salim ◽  
K.M. Wood ◽  
J.P. Cant ◽  
K.C. Swanson

The objectives of this study were to determine the effect of dietary inclusion [0%–50% of diet dry matter (DM)] and form (dry and modified wet) of corn distillers grains plus solubles (DGS) on pancreatic α-amylase and trypsin activities in calves. Feeding up to 50% DGS did not negatively impact pancreatic exocrine function.


2017 ◽  
Vol 1 (3) ◽  
pp. 367-381 ◽  
Author(s):  
D. B. Burken ◽  
B. L. Nuttelman ◽  
J. L. Gramkow ◽  
A. L. McGee ◽  
K. M. Sudbeck ◽  
...  

Abstract Corn plants were sampled over 2 consecutive years to assess the effects of corn hybrid maturity class, plant population, and harvest time on whole corn plant quality and yield in Nebraska. A finishing experiment evaluated the substitution of corn with corn silage in diets with corn modified distillers grains with solubles (MDGS). The first 2 harvest dates were at the mid- and late-silage harvest times whereas the final harvest was at the grain harvest stage of plant maturity. Whole plant yields increased as harvest time progressed (yr 1 quadratic P < 0.01; yr 2 linear P < 0.01). However, differences in TDN concentration in both years were quite minimal across harvest time, because grain percentage increased but residue NDF in-situ disappearance decreased as harvest time was delayed. In the finishing experiment, as corn silage inclusion increased from 15 to 55% (DM basis) by replacing dry rolled and high moisture corn grain with corn silage in diets containing 40% MDGS, DMI, ADG, and G:F linearly decreased (P ≤ 0.01), with the steers on the 15% corn silage treatment being 1.5%, 5.0%, and 7.7% more efficient than steers on treatments containing 30, 45, and 55% corn silage, respectively. Calculated dietary NEm and NEg decreased linearly as corn silage inclusion increased indicating that net energy values were greater for corn grain than for corn silage. In addition, dressing percentage decreased linearly (P < 0.01) as silage inclusion increased suggesting more fill as silage inclusion increases in diets. Cattle fed greater than 15% corn silage in finishing diets based on corn grain will gain slower and be slightly less efficient and likely require increased days to market at similar carcass fatness and size. When 30% silage was fed with 65% MDGS, DMI, and ADG were decreased (P < 0.01) compared to feeding 30% silage with 40% MDGS suggesting some benefit to including a proportion of corn in the diet. Conversely, when 45% silage was fed with 40% MDGS, ADG, and G:F were greater (P < 0.04) than when 45% silage was fed with just grain implying a greater energy value for MDGS than for corn grain. Substituting corn silage for corn grain in finishing diets decreased ADG and G:F which would increase days to finish to an equal carcass weight; however, in this experiment, increasing corn silage levels with MDGS present reduced carcass fat thickness without significantly decreasing marbling score.


2020 ◽  
Vol 98 (Supplement_3) ◽  
pp. 127-128
Author(s):  
Braden Troyer ◽  
Zac Carlson ◽  
Levi J McPhillips ◽  
Andrea K Watson ◽  
James C MacDonald ◽  
...  

Abstract Steam-flaked corn (SFC) has been widely used in feedlots in the southern United States to improve feed efficiency (G:F) by increasing starch digestibility. Similarly, feedlots in the Midwest have commonly fed high moisture corn (HMC), both to ensure corn supply for the year and to improve G:F. However, popularity of SFC in the Midwest is on the rise, but producers still recognize the benefits of HMC utilization. A study was conducted at the Eastern Nebraska Research and Extension Center (ENREC) to compare finishing cattle performance when fed HMC, SFC, or a blend. The objective was to determine the optimum inclusion of the grains when modified distillers grains (MDGS) was included at 20% of the diet. This study utilized 90 yearling steers (353 kg; SD=5.8 kg) individually fed using the Calan gate system in a completely randomized design with cattle stratified by body weight (BW). Treatments included: 100% HMC, 75% HMC blended with 25% SFC, a 50% blend of the grains, 25% HMC blended with 75% SFC, or 100% SFC (DM basis; % of the 70% grain in the diet). Cattle were on feed 168 days with 3-day initial BW and 1 day final BW. Animal was the experimental unit with 18 replications per treatment. No differences in initial BW, ribeye area, or marbling score between treatments were detected (P > 0.12). Ending BW, hot carcass weight, average daily gain, and G:F all linearly increased with increasing inclusion of SFC in the diet (P < 0.05). Carcass adjusted G:F improved from 0.158 to 0.170 for 100% HMC compared to 100% SFC diets, respectively. In conclusion, feeding higher inclusions of SFC in finishing diets resulted in improved performance compared to HMC in diets containing 20% MDGS.


2019 ◽  
Vol 97 (Supplement_3) ◽  
pp. 220-220
Author(s):  
Cody Ream ◽  
Allison V Stevens ◽  
Gwinyai Chibisa

Abstract This study examined the effects of altering ruminal fermentable carbohydrate (RFC) supply by feeding different amounts of corn and wheat in finishing cattle diets containing 15% corn dried distillers grains [DDGS; dry matter (DM) basis] on ruminal fermentation characteristics and nitrogen (N) utilization. Six ruminally-cannulated crossbred heifers were used in a replicated 3 × 3 Latin square design with 28 d periods. Dietary treatments were either corn (73% of diet DM; CON), 53:20 corn:wheat blend (20W) or 33:40 corn:wheat blend (40W) as the major fermentable carbohydrate source. Diets were isonitrogenous (12% CP; DM basis). Feed intake was measured daily. Indwelling pH logger were used to measure ruminal pH (d 22 to 28) and ruminal fluid was collected from d 26 to 28 to determine fermentation characteristics, as were feces and urine to measure N excretion. Data was analyzed using PROC MIXED in SAS. Dry matter and N intake tended to be lower (P ≤ 0.07) for heifers fed the 40W compared to the CON and 20W diets. There was no diet effect (P = 0.15) on total VFA concentration; however, the duration and area for pH < 5.5 tended to be longer (P = 0.07) and greater (P = 0.096), respectively, for heifers fed the 20W and 40W compared to the CON diet. There was no diet effect (P ≥ 0.44) on ruminal ammonia concentration and total urine N excretion (g and % of N intake). However, urine urea N (UUN) excretion as a percentage of total urine N tended to be lower (P = 0.05) in heifers fed the 20W and 40W compared to the CON diet. In summary, although altering RFC supply by feeding increasing amounts of wheat resulted in a decrease in UUN excretion, it also caused a decrease in ruminal pH that possibly compromised DM intake.


Sign in / Sign up

Export Citation Format

Share Document