The role of iron ions on microstructural and magnetic properties of MgCuZn ferrites prepared by sol-gel auto-combustion process

2019 ◽  
Vol 111 ◽  
pp. 195-201 ◽  
Author(s):  
Hamed Bahiraei ◽  
C.K. Ong
Keyword(s):  
Magnetic Properties ◽  
Sol Gel ◽  
Combustion Process ◽  
Iron Ions ◽  
Auto Combustion

IMPROVED MAGNETIC PROPERTIES OF Sm COMBINING Co OR/AND Zn SUBSTITUTED BARIUM M-TYPE HEXAFERRITES

2012 ◽  
Vol 26 (26) ◽  
pp. 1250141 ◽  
Author(s):  
Y. B. HAN ◽  
J. SHA ◽  
L. N. SUN ◽  
Q. TANG ◽  
Q. LU ◽  
...  
Keyword(s):  
Magnetic Properties ◽  
Phase Composition ◽  
Magnetocrystalline Anisotropy ◽  
Sol Gel ◽  
Combustion Process ◽  
X Ray Diffraction ◽  
X Ray ◽  
Barium Hexaferrites ◽  
Auto Combustion ◽  
Magnetic Dilution

Sm (Co or/and Zn) substituted nanocrystalline barium hexaferrites were synthesized by the sol–gel auto-combustion process, then X-ray diffraction (XRD) and vibrating sample magnetometer (VSM) were used to characterize and discuss the phase composition and the magnetic properties of the as-prepared barium hexaferrites. All results showed that the phase composition and magnetic properties were closely related to the doping elements and x. Owing to hyperfine field, canting spin, magnetic dilution and impurity phases, the saturation magnetization (Ms) of all samples increased firstly, and then decreased. Considering the crystallization, the magnetocrystalline anisotropy and the ions occupancy, the doping elements and x critically affected the coercivity (Hc). Compared the magnetic properties of all the samples, it is concluded that Zn 2+ and Co 2+ influenced each other and Zn 2+ occupied 4f2 sites prior to Co 2+, which led to the increase of Ms and the decrease of Hc.

scholarly journals Influence of the B-site cation nature on crystal structure and magnetic properties of Ca2BMoO6 (B = Cr, La, Sm) double perovskite

2014 ◽  
Vol 22 (2) ◽  
pp. 145-154 ◽  
Author(s):  
Ioana A. Gorodea
Keyword(s):  
Magnetic Properties ◽  
Sol Gel ◽  
Double Perovskite ◽  
Combustion Method ◽  
X Ray Diffraction ◽  
Ionic Radii ◽  
Auto Combustion ◽  
The Fourier Transform ◽  
First Time

Abstract Double perovskite-type oxide Ca2BMoO6 materials, where B = Cr, La and Sm, were prepared by the sol-gel auto-combustion method for the first time. The role of different B-site cations on their synthesis, structures, and magnetic properties was investigated. The synthesis progress was followed by the Fourier transform infrared spectroscopy and the samples’ structure was investigated by X-ray diffraction. The increase of the ionic radii B leads to the decrease of the t-value which reflects the structural distortion from the ideal cubic perovskite. Magnetization measurements were made with a SQUID magnetometer. All compounds are ferimagnetic and magnetic properties are indirectly influenced by the distortion degree of the lattice and disorder on the B/B’ positions

Preparation and magnetic properties of titanium-substituted LiZn ferrites via a sol-gel auto-combustion process

2003 ◽  
Vol 23 (1) ◽  
pp. 189-193 ◽  
Author(s):  
Zhenxing Yue ◽  
Ji Zhou ◽  
Xiaohui Wang ◽  
Zhilun Gui ◽  
Longtu Li
Keyword(s):  
Magnetic Properties ◽  
Sol Gel ◽  
Combustion Process ◽  
Auto Combustion

Structural, Morphological and Magnetic Characterization of Sm-substituted Ni-Zn Ferrite

2020 ◽  
Vol 10 (2) ◽  
pp. 152-156 ◽  
Author(s):  
Muhammad Hanif bin Zahari ◽  
Beh Hoe Guan ◽  
Lee Kean Chuan ◽  
Afiq Azri bin Zainudin
Keyword(s):  
Magnetic Properties ◽  
Rare Earth ◽  
Saturation Magnetization ◽  
Sol Gel ◽  
Magnetic Behavior ◽  
Rare Earth Ions ◽  
Ion Concentration ◽  
Zn Ferrite ◽  
Auto Combustion ◽  
Combustion Technique

Background: Rare earth materials are known for its salient electrical insulation properties with high values of electrical resistivity. It is expected that the substitution of rare earth ions into spinel ferrites could significantly alter its magnetic properties. In this work, the effect of the addition of Samarium ions on the structural, morphological and magnetic properties of Ni0.5Zn0.5SmxFe2-xO4 (x=0.00, 0.02, 0.04, 0.06, 0.08, 0.10) synthesized using sol-gel auto combustion technique was investigated. Methods: A series of Samarium-substituted Ni-Zn ferrite nanoparticles (Ni0.5Zn0.5SmxFe2-xO4 where x=0.00, 0.02, 0.04, 0.06, 0.08, 0.10) were synthesized by sol-gel auto-combustion technique. Structural, morphological and magnetic properties of the samples were examined through X-Ray Diffraction (XRD), Field-Emission Scanning Electron Microscope (FESEM) and Vibrating Sample Magnetometer (VSM) measurements. Results: XRD patterns revealed single-phased samples with spinel cubic structure up to x= 0.04. The average crystallite size of the samples varied in the range of 41.8 – 85.6 nm. The prepared samples exhibited agglomerated particles with larger grain size observed in Sm-substituted Ni-Zn ferrite as compared to the unsubstituted sample. The prepared samples exhibited typical soft magnetic behavior as evidenced by the small coercivity field. The magnetic saturation, Ms values decreased as the Sm3+ concentration increases. Conclusion: The substituted Ni-Zn ferrites form agglomerated particles inching towards more uniform microstructure with each increase in Sm3+ substitution. The saturation magnetization of substituted samples decreases with the increase of samarium ion concentration. The decrease in saturation magnetization can be explained based on weak super exchange interaction between A and B sites. The difference in magnetic properties between the samples despite the slight difference in Sm3+ concentrations suggests that the properties of the NiZnFe2O4 can be ‘tuned’, depending on the present need, through the substitution of Fe3+ with rare earth ions.

scholarly journals Green synthesis and characterization of hexaferrite strontium-perovskite strontium photocatalyst nanocomposites

2020 ◽  
Vol 43 (1) ◽  
pp. 26-42 ◽  
Author(s):  
Zahra Hajian Karahroudi ◽  
Kambiz Hedayati ◽  
Mojtaba Goodarzi
Keyword(s):  
Magnetic Properties ◽  
Green Synthesis ◽  
Sol Gel ◽  
Synthesis Method ◽  
Combustion Method ◽  
Lemon Juice ◽  
X Ray Diffraction ◽  
X Ray ◽  
Auto Combustion

AbstractThis study presents a preparation of SrFe12O19– SrTiO3 nanocomposite synthesis via the green auto-combustion method. At first, SrFe12O19 nanoparticles were synthesized as a core and then, SrTiO3 nanoparticles were prepared as a shell for it to manufacture SrFe12O19–SrTiO3 nanocomposite. A novel sol-gel auto-combustion green synthesis method has been used with lemon juice as a capping agent. The prepared SrFe12O19–SrTiO3 nanocomposites were characterized by using several techniques to characterize their structural, morphological and magnetic properties. The crystal structures of the nanocomposite were investigated via X-ray diffraction (XRD). The morphology of SrFe12O19– SrTiO3 nanocomposite was studied by using a scanning electron microscope (SEM). The elemental composition of the materials was analyzed by an energy-dispersive X-ray (EDX). Magnetic properties and hysteresis loop of nanopowder were characterized via vibrating sample magnetometer (VSM) in the room temperature. Fourier transform infrared spectroscopy (FTIR) spectra of the samples showed the molecular bands of nanoparticles. Also, the photocatalytic behavior of nanocomposites has been checked by the degradation of azo dyes under irradiation of ultraviolet light.

Sign in / Sign up

Export Citation Format

Share Document