High contrast ratio all-optical 4 × 2 encoder based on two-dimensional photonic crystals

2019 ◽  
Vol 113 ◽  
pp. 447-452 ◽  
Author(s):  
Fariborz Parandin
2019 ◽  
Vol 0 (0) ◽  
Author(s):  
Bahman Shahmohammadi ◽  
Alireza Andalib

AbstractIn this paper, we are going to design simulate an all optical OR gate based on two-dimensional photonic crystals. The proposed structure was designed based on phase shift keying technique. The working principle of the proposed structure is based on constructive and destructive interference of optical beams. The simulation results shows that the rise and fall times are 0.8 and 0.2 ps, respectively.


Crystals ◽  
2019 ◽  
Vol 9 (9) ◽  
pp. 461 ◽  
Author(s):  
Mohammad Reza Jalali Azizpour ◽  
Mohammad Soroosh ◽  
Narges Dalvand ◽  
Yousef Seifi-Kavian

In this paper, an all-optical photonic crystal-based switch containing a graphene resonant ring has been presented. The structure has been composed of 15 × 15 silicon rods for a fundamental lattice. Then, a resonant ring including 9 thick silicon rods and 24 graphene-SiO2 rods was placed between two waveguides. The thick rods with a radius of 0.41a in the form of a 3 × 3 lattice were placed at the center of the ring. Graphene-SiO2 rods with a radius of 0.2a were assumed around the thick rods. These rods were made of the graphene monolayers which were separated by SiO2 disks. The size of the structure was about 70 µm2 that was more compact than other works. Furthermore, the rise and fall times were obtained by 0.3 ps and 0.4 ps, respectively, which were less than other reports. Besides, the amount of the contrast ratio (the difference between the margin values for logics 1 and 0) for the proposed structure was calculated by about 82%. The correct switching operation, compactness, and ultra-fast response, as well as the high contrast ratio, make the presented switch for optical integrated circuits.


2018 ◽  
Vol 39 (4) ◽  
pp. 369-373 ◽  
Author(s):  
Hassan Absalan

Abstract The aim of this paper was to propose and design an all optical four-channel demultiplexer using two-dimensional photonic crystals. To do so a resonant cavity was created by reducing the radius of the two adjacent rods. The radius of these defect rods was about 85 nm. The resonant cavity has a resonant mode at 1,557 nm. Then by using four resonant cavities with different radius values a four-channel optical demultiplexer was designed. The demultiplexer has four optical channels at λ1=1,537 nm, λ2=1,546 nm, λ3=1,553 nm and λ4=1,560 nm.


2017 ◽  
Vol 109 ◽  
pp. 437-441 ◽  
Author(s):  
Fariborz Parandin ◽  
Mohammad-Reza Malmir ◽  
Mosayeb Naseri

Sign in / Sign up

Export Citation Format

Share Document