Application scheme and performance analysis of free space optical communication technology in INMARSAT

In this study, we propose an application scheme of free space optical communication technology in INMARSAT, and propose a 1.12 Tbit/s coherent free-space optical (FSO) communication system based on wavelength division multiplexing (WDM) and polarization-multiplexing quadrature phase shift keying (PM-QPSK) modulation technology. Based on optisystem software platform, the spectrum, bit error rate (BER), received power, error vector magnitude (EVM), and receiver sensitivity of the edge and middle channels of the system are analyzed. The simulation results show that the transmission rate and channel capacity of INMARSAT communication system are greatly improved by selecting the channel spacing and transmission environment reasonably.

Novel add-drop filter based on serial and parallel photonic crystal ring resonators (PCRR)

Photonic crystal ring resonators (PCRR) as momentous candidates for future photonic crystal integrated circuits (PCICs) draw worldwide attention. In this paper, different configurations are proposed based on single, parallel, and serial PCRRs. To be precise, the different coupling lengths and alignments have been discussed in double and triple PCRRs in parallel and serial configurations to achieve the highest efficiency concerning the desired applications such as an add-drop filter (ADF) and a power splitter. Moreover, in the achieved optimum double and triple PCRRs, the effect of coupling radius change has been discussed.

Performance analysis of long band passive optical network using amplifier spontaneous noise and fiber Bragg gratings

Long band (L-Band) passive optical networks (PONs) are attracting a lot of attention these days, thanks to rising capacity demands. Because of PONs requesting more and more channels, fault detection/monitoring is critical. Fault detection in the conventional band (C-Band) employing reflecting Fiber Bragg Gratings (FBGs) and a probe signal integrating an additional amplified spontaneous noise (ASEN) source has been frequently demonstrated. However, interference occurs when ASEN and transmitter signals are in the same wavelength band, and adding additional ASEN sources to the network raises the overall cost. So, in L-Band PONs, a cost-effective, low-complexity fault detection/monitoring system is required. Therefore, in this work, a fault detection/monitoring system for L-Band PON using C-Band ASEN from inline erbium doped fiber amplifier (EDFA) and dual purpose FBG, i.e. (1) ASEN reflection for fault monitoring and (2) dispersion compensation is proposed. A 4 × 10 Gbps L-Band PON is investigated over 40 km feeder fiber (FF) and 1 km drop fibers (DFs) that serve 32 optical network units (ONUs)/different input powers, dispersion values, and laser linewidths in terms of reflective power of FBGs, eye opening factor, and bit error rate (BER), respectively.

Pulse width shortening combinations (PWSC) for ultra-dense WDM systems and calculation of PWSE

Optical communication systems introduced paradigm shift in the forte of data transmission at higher speeds and over longer distances where, on contrary electrical transmission systems failed due to higher amplitude degradation, interferences and lower bandwidths. However, pulse width increase (PWI) in the optical fiber limits the overall distance reach and also introduces more bit errors which needs to addressed. So far, pulse width shortening fibers (PFs) and fiber Bragg grating (FG) used individually in most of the reported studies, however pulse width shortening (PWS) took either high cost (in PFs) or lower PWS efficiency (PWSE) (in FG). Therefore, in this research manuscript, we made emphasis on the combined PWS effects of diverse techniques such as optical phase conjugation (OC), FG and PFs in ultra-dense wavelength division multiplexing (WDM) system. Total link length of 400 km has been covered in 128 channels ultra dense wavelength division multiplexing (UDWDM) system at 10 Gbps by incorporating diverse combined organized placements of FG, OC and PFs such as FG-PF, OC-PF and FG-PF-OC. Results revealed that economical and maximum PWSE arrangement for proposed system is FG-PF-OC.

Analysis of optical networks in presence of nodes noise and crosstalk

Optical packet switching has gained lot of momentum in last decade due to the advantages of optical fiber over copper cables. Optical switching is beneficial in optical networks which form connections of links and switching nodes. In these high speed networks minimum delay and high throughput are two important parameters which are considered. To minimize network delay shortest path algorithm is used for route selections. In previous studies while choosing shortest path distance among various nodes is considered. In this work we have shown that it is necessary to consider both distance and number of hops while choosing path from source to destination to minimize power per bit used for the transmission.

Analyzing optical TDMA to mitigate interference in downlink LiFi optical attocell networks

Co-channel interference in the downlink of LiFi attocell networks significantly decreases the network performance in terms of rate. Analysis of multiple access schemes is essential to mitigate interference and improve rate. The light-emitting diodes (LEDs) being centrally monitored, the time division multiple access (TDMA) scheme over the LEDs will be suitable to analyze. This work considers the interference characterization in Ref. (Surampudi A, Ganti RK. Interference characterization in downlink Li-Fi optical attocell networks. J Lightwave Technol 2018;36:3211–28) over M-PAM modulated signals to derive an exact expression for the goodput G of the time scheduled attocell network, which is arranged as a deterministic square lattice in two dimensions. Given this TDMA over the LEDs, numerical simulations show that the LEDs can be optimally time scheduled to maximize the goodput, which implies that the TDMA mitigates interference in an attocell network compared to the case when the LEDs are unscheduled.

Alternative method of implementation of all-optical NOR and NAND gates using quantum-dot semiconductor optical amplifiers in non-interferometer structure

Present communication deals with the design and analysis of all-optical NOR and NAND gates using Quantum dot Semiconductor Optical Amplifiers (QDSOA). The design uses no interferometer structure but cross gain modulation is utilized for operation. The structures are simple and simulations at a rate of 1 Tb/s are processed. For unsaturated gain 30 dB, the logic gates show high values of ER (29.82 dB, 16.93 dB), CR (29.6 dB, 21.33 dB), and Q (25.4 dB, 13.2 dB). This ensures practical feasibility and high quality of the proposed gates.

Effect of optical pulse shaping and adaptive equalization on the performance of 100G DP-QPSK WDM system

Dual polarization quadrature phase shifting keying (DP-QPSK) modulation format along with coherent receiver helps in increasing the data carrying capability of existing optical networks without any major change in existing transmission infrastructure. The various linear and nonlinear fiber effects, frequency and phase errors are corrected in electrical domain at the receiver end with digital back propagation algorithms (DBP) instead of in-line compensation. In such a case the selection of optimum values of system parameters make the task easier for DBP algorithms. This paper highlights the importance of finding optimum operating point of continuous modulus algorithm (CMA) for better adaptive equalization (AE). The paper also discusses the optical pulse shaping using Gaussian optical band-pass filter to improve the spectral characteristics of DP-QPSK signal.

Performance analysis of wavelength division multiplexing MDM-PON system using different advanced modulations

Mode division multiplexing (MDM) is very competent next generation multiplexing technique and is becoming popular among researchers these days. In this research article, an integrated passive optical network (PON) using MDM and wavelength division multiplexing (WDM) is proposed at 25 Gbps over 3 km multimode fiber (MMF) link distance. For MDM, diverse Laguerre–Gaussian (LG) such as LG12, LG15, LG18, LG111 and LG114 are incorporated and also for cost reduction, vertical cavity surface emitting laser (VCSEL) is located in optical line terminal (OLT). Performance of diverse advanced modulations such as compressed spectrum return to zero (CSRZ), duo-binary return to zero (DRZ) and modified duo-binary return to zero (MDRZ) is evaluated and compared with non-return to zero (NRZ) in terms of Bit error rate (BER) at varied MMF link lengths. Results revealed that CSRZ performance stand out and NRZ provide worst performance.