Capacitive detection of micrometric airborne particulate matter for solid-state personal air quality monitors

2014 ◽  
Vol 219 ◽  
pp. 80-87 ◽  
Author(s):  
M. Carminati ◽  
L. Pedalà ◽  
E. Bianchi ◽  
F. Nason ◽  
G. Dubini ◽  
...  
2021 ◽  
Vol 2021 ◽  
pp. 1-11
Author(s):  
Caroline Kiai ◽  
Christopher Kanali ◽  
Joseph Sang ◽  
Michael Gatari

Air pollution is one of the most important environmental and public health concerns worldwide. Urban air pollution has been increasing since the industrial revolution due to rapid industrialization, mushrooming of cities, and greater dependence on fossil fuels in urban centers. Particulate matter (PM) is considered to be one of the main aerosol pollutants that causes a significant adverse impact on human health. Low-cost air quality sensors have attracted attention recently to curb the lack of air quality data which is essential in assessing the health impacts of air pollutants and evaluating land use policies. This is mainly due to their lower cost in comparison to the conventional methods. The aim of this study was to assess the spatial extent and distribution of ambient airborne particulate matter with an aerodynamic diameter less than 2.5 μm (PM2.5) in Nairobi City County. Seven sites were selected for monitoring based on the land use type: high- and low-density residential, industrial, agricultural, commercial, road transport, and forest reserve areas. Calibrated low-cost sensors and cyclone samplers were used to monitor PM2.5 concentration levels and gravimetric measurements for elemental composition of PM2.5, respectively. The sensor percentage accuracy for calibration ranged from 81.47% to 98.60%. The highest 24-hour average concentration of PM2.5 was observed in Viwandani, an industrial area (111.87 μg/m³), and the lowest concentration at Karura (21.25 μg/m³), a forested area. The results showed a daily variation in PM2.5 concentration levels with the peaks occurring in the morning and the evening due to variation in anthropogenic activities and the depth of the atmospheric boundary layer. Therefore, the study suggests that residents in different selected land use sites are exposed to varying levels of PM2.5 pollution on a regular basis, hence increasing the potential of causing long-term health effects.


Heliyon ◽  
2020 ◽  
Vol 6 (6) ◽  
pp. e04207 ◽  
Author(s):  
Opeyemi R. Omokungbe ◽  
Olusegun G. Fawole ◽  
Oyediran K. Owoade ◽  
Olalekan A.M. Popoola ◽  
Roderic L. Jones ◽  
...  

2020 ◽  
Author(s):  
Brigitte Rooney ◽  
Yuan Wang ◽  
Jonathan H. Jiang ◽  
Bin Zhao ◽  
Zhao-Cheng Zeng ◽  
...  

Abstract. The Northern California Camp Fire that took place in November 2018 was one of the most damaging environmental events in California history. Here, we analyze ground-based station observations of airborne particulate matter that has a diameter


2003 ◽  
Vol 67 (2) ◽  
pp. 163-171 ◽  
Author(s):  
B. Parsons ◽  
L. Salter ◽  
T. Coe ◽  
R. Mathias ◽  
R. J. Richards ◽  
...  

Work was undertaken in 1997 as part of a UK government programme to monitor air quality in the Cornish china clay area. These studies showed that concentrations of airborne particulate matter with an aerodynamic diameter <10 μm (PM10) did not exceed UK National Air Quality Strategy (NAQS, 1995) guidelines but were, however, greater than those normally associated with rural areas. Subsequently, in the summer of 2000, airborne dust sampling was conducted at three sites around the IMERYS (formerly ECCI) Kernick mica dam, a potential source of resuspended airborne particulates from china clay waste minerals. Analytical scanning electron microscopy examination of the collected material suggested that up to 61% of the airborne PM10 monitored next to the mica dam could be associated with china clay extraction compared with 46% 2 km to the south. Results showed the presence of substantial percentages of respirable kaolinite, muscovite and quartz; the major components of china clay waste. The health effects of the particular mineral dust emissions associated with china clay mining are reviewed.


1999 ◽  
Vol 09 (03n04) ◽  
pp. 373-379 ◽  
Author(s):  
MILOŠ BUDNAR ◽  
MIHA D. PUC

The air quality sampling and analysis of airborne particulate matter (APM) in Ljubljana region has been started, recently. The sampler is positioned at around 10 km from the city limits in the direction of the prevailing winds. The aerosol samples were measured by a standard in-vacuum PIXE arrangement. The measured concentrations show the influences of the industry and traffic at the city.


Sign in / Sign up

Export Citation Format

Share Document