Effects of land-use/cover change on soil hydraulic properties and pore characteristics in a semi-arid region of central Iran

2020 ◽  
Vol 197 ◽  
pp. 104478 ◽  
Author(s):  
Eftekhar Baranian Kabir ◽  
Hossein Bashari ◽  
Mehdi Bassiri ◽  
Mohammad Reza Mosaddeghi
2021 ◽  
pp. e00475
Author(s):  
S. Dharumarajan ◽  
M. Lalitha ◽  
Cecil Gomez ◽  
R. Vasundhara ◽  
B. Kalaiselvi ◽  
...  

2015 ◽  
Vol 7 (1) ◽  
Author(s):  
Ágota Horel ◽  
Eszter Tóth ◽  
Györgyi Gelybó ◽  
Ilona Kása ◽  
Zsófia Bakacsi ◽  
...  

AbstractSoil hydraulic properties are among the most important parameters that determine soil quality and its capability to serve the ecosystem. Land use can significantly influence soil properties, including its hydraulic conditions; however, additional factors, such as changes in climate (temperature and precipitation), can further influence the land use effects on soil hydraulic properties. In order to develop possible adaptation measures and mitigate any negative effects of land use and climatic changes, it is important to study the impact of land use and changes in land use on soil hydraulic properties. In this paper, we summarize recent studies examining the effect of land use/land cover and the associated changes in soil hydraulic properties, mainly focusing on agricultural scenarios of cultivated croplands and different tillage systems.


2013 ◽  
Vol 2 (1) ◽  
pp. 224-230 ◽  
Author(s):  
HS Bello ◽  
T Isa ◽  
MA Isa ◽  
K Akinmuisere

This study was aim to investigate the effects of land use on the nature and population of microorganisms in soil from five different farms within University of Maiduguri, Borno State. A total of ten composite samples were obtained and analyzed in the laboratory. The total microbial population was consistently higher in the grazing reserved land with mean of 105x104CFU/g than in cultivated farms with means of 84.5x104CFU/g, 66x104CFU/g and 66x104CFU/g, for cereal (sorghum), beans and tomato farms respectively. The site with the least microbial population was gum-Arabic plantation with the mean of 29x104CFU/g. Bacteria were the most dominant species at all sites regardless of depths. International Journal of Environment, Volume-2, Issue-1, Sep-Nov 2013, Pages 224-230 DOI: http://dx.doi.org/10.3126/ije.v2i1.9223


Geoderma ◽  
2015 ◽  
Vol 241-242 ◽  
pp. 210-220 ◽  
Author(s):  
B. Khalili Moghadam ◽  
M. Jabarifar ◽  
M. Bagheri ◽  
E. Shahbazi

2015 ◽  
Vol 19 (3) ◽  
pp. 1193-1207 ◽  
Author(s):  
S. Siltecho ◽  
C. Hammecker ◽  
V. Sriboonlue ◽  
C. Clermont-Dauphin ◽  
V. Trelo-ges ◽  
...  

Abstract. Adequate water management is required to improve the efficiency and sustainability of agricultural systems when water is scarce or over-abundant, especially in the case of land use changes. In order to quantify, to predict and eventually to control water and solute transport into soil, soil hydraulic properties need to be determined precisely. As their determination is often tedious, expensive and time-consuming, many alternative field and laboratory techniques are now available. The aim of this study was to determine unsaturated soil hydraulic properties under different land uses and to compare the results obtained with different measurement methods (Beerkan, disc infiltrometer, evaporation, pedotransfer function). The study has been realized on a tropical sandy soil in a mini-watershed in northeastern Thailand. The experimental plots were positioned in a rubber tree plantation in different positions along a slope, in ruzi grass pasture and in an original forest site. Non-parametric statistics demonstrated that van Genuchten unsaturated soil parameters (Ks, α and n) were significantly different according to the measurement methods employed, whereas the land use was not a significant discriminating factor when all methods were considered together. However, within each method, parameters n and α were statistically different according to the sites. These parameters were used with Hydrus1D for a 1-year simulation and computed pressure head did not show noticeable differences for the various sets of parameters, highlighting the fact that for modeling, any of these measurement methods could be employed. The choice of the measurement method would therefore be motivated by the simplicity, robustness and its low cost.


Sign in / Sign up

Export Citation Format

Share Document