Effect of wall cooling on boundary-layer-induced pressure fluctuations at Mach 6

2017 ◽  
Vol 822 ◽  
pp. 5-30 ◽  
Author(s):  
Chao Zhang ◽  
Lian Duan ◽  
Meelan M. Choudhari
Keyword(s):  
Boundary Layer ◽  
Boundary Layers ◽  
Wall Temperature ◽  
Pressure Fluctuation ◽  
Free Stream ◽  
Pressure Fluctuations ◽  
Turbulent Boundary Layers ◽  
Wall Pressure ◽  
Wall Region ◽  
Near Wall

Direct numerical simulations of turbulent boundary layers with a nominal free-stream Mach number of $6$ and a Reynolds number of $Re_{\unicode[STIX]{x1D70F}}\approx 450$ are conducted at a wall-to-recovery temperature ratio of $T_{w}/T_{r}=0.25$ and compared with a previous database for $T_{w}/T_{r}=0.76$ in order to investigate pressure fluctuations and their dependence on wall temperature. The wall-temperature dependence of widely used velocity and temperature scaling laws for high-speed turbulent boundary layers is consistent with previous studies. The near-wall pressure-fluctuation intensities are dramatically modified by wall-temperature conditions. At different wall temperatures, the variation of pressure-fluctuation intensities as a function of wall-normal distance is dramatically modified in the near-wall region but remains almost intact away from the wall. Wall cooling also has a strong effect on the frequency spectrum of wall-pressure fluctuations, resulting in a higher dominant frequency and a sharper spectrum peak with a faster roll-off at both the high- and low-frequency ends. The effect of wall cooling on the free-stream noise spectrum can be largely accounted for by the associated changes in boundary-layer velocity and length scales. The pressure structures within the boundary layer and in the free stream evolve less rapidly as the wall temperature decreases, resulting in an increase in the decorrelation length of coherent pressure structures for the colder-wall case. The pressure structures propagate with similar speeds for both wall temperatures. Due to wall cooling, the generated pressure disturbances undergo less refraction before they are radiated to the free stream, resulting in a slightly steeper radiation wave front in the free stream. Acoustic sources are largely concentrated in the near-wall region; wall cooling most significantly influences the nonlinear (slow) component of the acoustic source term by enhancing dilatational fluctuations in the viscous sublayer while damping vortical fluctuations in the buffer and log layers.

scholarly journals Interactions of large-scale free-stream turbulence with turbulent boundary layers

2016 ◽  
Vol 802 ◽  
pp. 79-107 ◽  
Author(s):  
Eda Dogan ◽  
Ronald E. Hanson ◽  
Bharathram Ganapathisubramani
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Boundary Layers ◽  
Large Scale ◽  
Free Stream ◽  
Turbulent Boundary Layers ◽  
Scale Interactions ◽  
Free Stream Turbulence ◽  
Small Scales ◽  
Near Wall

The scale interactions occurring within a turbulent boundary layer are investigated in the presence of free-stream turbulence. The free-stream turbulence is generated by an active grid. The free stream is monitored by a single-component hot-wire probe, while a second probe is roved across the height of the boundary layer at the same streamwise location. Large-scale structures occurring in the free stream are shown to penetrate the boundary layer and increase the streamwise velocity fluctuations throughout. It is speculated that, depending on the extent of the penetration, i.e. based on the level of free-stream turbulence, the near-wall turbulence production peaks at different wall-normal locations than the expected location of $y^{+}\approx 15$ for a canonical turbulent boundary layer. It is shown that the large scales dominating the log region have a modulating effect on the small scales in the near-wall region; this effect becomes more significant with increasing turbulence in the free stream, i.e. similarly increasing $Re_{\unicode[STIX]{x1D706}_{0}}$. This modulating interaction and its Reynolds-number trend have similarities with canonical turbulent boundary layers at high Reynolds numbers where the interaction between the large scales and the envelope of the small scales exhibits a pure amplitude modulation (Hutchins & Marusic, Phil. Trans. R. Soc. Lond. A, vol. 365 (1852), 2007, pp. 647–664; Mathis et al., J. Fluid Mech., vol. 628, 2009, pp. 311–337). This similarity has encouraging implications towards generalising scale interactions in turbulent boundary layers.

An Aspect of Heat Transfer in Accelerating Turbulent Boundary Layers

1969 ◽  
Vol 91 (2) ◽  
pp. 229-234 ◽  
Author(s):  
B. E. Launder ◽  
F. C. Lockwood
Keyword(s):  
Boundary Layer ◽  
Boundary Layers ◽  
Wall Temperature ◽  
Thermal Boundary Layer ◽  
Free Stream ◽  
Turbulent Boundary Layers ◽  
Stanton Number ◽  
Stream Velocity ◽  
Velocity Boundary Layer ◽  
Positive Exponent

Theoretical consideration indicates that, in an accelerated turbulent flow, the thermal boundary layer may penetrate significantly beyond the edge of the velocity boundary layer. This effect may contribute in part to the marked decrease in Stanton number which has been reported in accelerated turbulent boundary layers. This paper presents theoretical solutions to turbulent velocity and thermal boundary layers in flow between converging planes where the wall temperature varies as the free-stream velocity raised to a positive exponent. The solutions clearly illustrate that, as the wall-temperature variation is made less rapid, the thermal boundary layer penetrates progressively further beyond the velocity boundary layer, causing the Stanton number to decrease.

Wall-Layer Scale Electromagnetic Turbulence Control in an Axisymmetric Body

Volume 1 ◽  
2004 ◽  
Author(s):  
Promode R. Bandyopadhyay ◽  
John M. Castano ◽  
Daniel P. Thivierge
Keyword(s):  
Boundary Layer ◽  
Large Diameter ◽  
Pressure Fluctuations ◽  
Axisymmetric Body ◽  
Wall Pressure ◽  
Wall Region ◽  
Turbulence Control ◽  
Wall Pressure Fluctuations ◽  
Surface Normal ◽  
Near Wall

The progress made with the control of turbulence in a boundary layer developing over a small axisymmetric body in saltwater at moderate Reynolds numbers is briefly described. A resonance-interference mechanism of control by means of a small periodic Lorenz force confined to the near-wall region, designed to overcome the issue of low efficiency of electromagnetic turbulence control in general, is attempted to alter surface normal turbulence near-wall. At a low momentum thickness Reynolds number of 2300, drag is reduced by 15–25% at a freestream speed of 5.12 m/s with an efficiency of 2–3.4%. Bi-polar pulsing succeeds in lowering surface-normal turbulence intensity near wall. It also makes wall pressure fluctuations less spiky. Positive uni-polar pulsing is found to weaken the sources of wall-pressure fluctuations residing in the logarithmic region of the boundary layer. Further confirmatory work is needed with robust electrodes and drag measurements on a large diameter axisymmetric body.

Heat Transfer In Turbulent Boundary Layers Subjected to Free-Stream Turbulence—Part II: Analysis and Correlation

2003 ◽  
Vol 125 (2) ◽  
pp. 242-251 ◽  
Author(s):  
Michael J. Barrett ◽  
D. Keith Hollingsworth
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Boundary Layers ◽  
Free Stream ◽  
Turbulent Boundary Layers ◽  
Stanton Number ◽  
Length Scale ◽  
Free Stream Turbulence ◽  
New Correlation ◽  
Near Wall

A new heat transfer correlation for turbulent boundary layers subjected to free-stream turbulence was developed. The new correlation estimates dimensionless heat transfer coefficients without the use of conventional boundary-layer thickness measures and the associated Reynolds numbers. Using only free-stream parameters (mean velocity, turbulence intensity and length scale), the new correlation collected many authors’ elevated-turbulence, flat-plate Stanton number data to within ±11%. The level of scatter around the new correlation compared well to previous correlations that require additional flow information as input parameters. For a common subset of data, scatter using earlier correlation methods ranged from 5–10%; scatter around the new correlation varied from 6–9% over the same data subset. A length-scale dependence was identified in a Stanton number previously defined using a near-wall streamwise velocity fluctuation, St′. A new near-wall Stanton number was introduced; this parameter was regarded as a constant in a two-region boundary layer model on which the new correlation is based.

Axially symmetric turbulent boundary layers on cylinders: mean velocity profiles and wall pressure fluctuations

1976 ◽  
Vol 76 (1) ◽  
pp. 35-64 ◽  
Author(s):  
W. W. Willmarth ◽  
R. E. Winkel ◽  
L. K. Sharma ◽  
T. J. Bogar
Keyword(s):  
Boundary Layer ◽  
Boundary Layers ◽  
Pressure Fluctuations ◽  
Velocity Profiles ◽  
Turbulent Boundary Layers ◽  
Wall Pressure ◽  
Axially Symmetric ◽  
Mean Velocity ◽  
Law Of The Wall ◽  
Wall Pressure Fluctuations

Experimental measurements of the mean velocity profiles produced by axially symmetric turbulent boundary layers on cylinders of various diameters are described. The profile measurements were made with very small hot wires developed for this investigation. Measurements of the wall shear stress on cylinders ranging from 0.02 to 2.0 in. in diameter are also reported. In the boundary layer on cylinders, well-defined regions exist in which the two-dimensional law of the wall and a three-dimensional wake law are valid. There was no evidence that the boundary layer was not fully turbulent even on the cylinders of smallest diameter. Measurements of wall pressure fluctuations beneath the boundary layer on a 1 in. diameter cylinder are also described. The results were much the same as those previously reported by Willmarth & Yang (1970) for a 3 in. diameter cylinder. The only difference was the discovery that the wall pressure was correlated in the transverse direction approximately half-way around the cylinder. This was not true on the 3 in. diameter cylinder.

The Effects of Adverse Pressure Gradients on Momentum and Thermal Structures in Transitional Boundary Layers: Part 2—Fluctuation Quantities

1996 ◽  
Vol 118 (4) ◽  
pp. 728-736 ◽  
Author(s):  
S. P. Mislevy ◽  
T. Wang
Keyword(s):  
Boundary Layer ◽  
Shear Stress ◽  
Transition Region ◽  
Boundary Layers ◽  
Reynolds Shear Stress ◽  
Turbulent Shear ◽  
Wall Region ◽  
Pressure Gradients ◽  
Baseline Case ◽  
Near Wall

The effects of adverse pressure gradients on the thermal and momentum characteristics of a heated transitional boundary layer were investigated with free-stream turbulence ranging from 0.3 to 0.6 percent. Boundary layer measurements were conducted for two constant-K cases, K1 = −0.51 × 10−6 and K2 = −1.05 × 10−6. The fluctuation quantities, u′, ν′, t′, the Reynolds shear stress (uν), and the Reynolds heat fluxes (νt and ut) were measured. In general, u′/U∞, ν′/U∞, and νt have higher values across the boundary layer for the adverse pressure-gradient cases than they do for the baseline case (K = 0). The development of ν′ for the adverse pressure gradients was more actively involved than that of the baseline. In the early transition region, the Reynolds shear stress distribution for the K2 case showed a near-wall region of high-turbulent shear generated at Y+ = 7. At stations farther downstream, this near-wall shear reduced in magnitude, while a second region of high-turbulent shear developed at Y+ = 70. For the baseline case, however, the maximum turbulent shear in the transition region was generated at Y+ = 70, and no near-wall high-shear region was seen. Stronger adverse pressure gradients appear to produce more uniform and higher t′ in the near-wall region (Y+ < 20) in both transitional and turbulent boundary layers. The instantaneous velocity signals did not show any clear turbulent/nonturbulent demarcations in the transition region. Increasingly stronger adverse pressure gradients seemed to produce large non turbulent unsteadiness (or instability waves) at a similar magnitude as the turbulent fluctuations such that the production of turbulent spots was obscured. The turbulent spots could not be identified visually or through conventional conditional-sampling schemes. In addition, the streamwise evolution of eddy viscosity, turbulent thermal diffusivity, and Prt, are also presented.

Compressibility and Variable Density Effects in Turbulent Boundary layers

2006 ◽  
Vol 129 (4) ◽  
pp. 441-448 ◽  
Author(s):  
Kunlun Liu ◽  
Richard H. Pletcher
Keyword(s):  
Boundary Layer ◽  
Mach Number ◽  
Turbulent Boundary Layer ◽  
Boundary Layers ◽  
Wall Temperature ◽  
Stokes Equations ◽  
Variable Density ◽  
Turbulent Boundary Layers ◽  
Reynolds Analogy ◽  
Density Effects

Two compressible turbulent boundary layers have been calculated by using direct numerical simulation. One case is a subsonic turbulent boundary layer with constant wall temperature for which the wall temperature is 1.58 times the freestream temperature and the other is a supersonic adiabatic turbulent boundary layer subjected to a supersonic freestream with a Mach number 1.8. The purpose of this study is to test the strong Reynolds analogy (SRA), the Van Driest transformation, and the applicability of Morkovin’s hypothesis. For the first case, the influence of the variable density effects will be addressed. For the second case, the role of the density fluctuations, the turbulent Mach number, and dilatation on the compressibility will be investigated. The results show that the Van Driest transformation and the SRA are satisfied for both of the flows. Use of local properties enable the statistical curves to collapse toward the corresponding incompressible curves. These facts reveal that both the compressibility and variable density effects satisfy the similarity laws. A study about the differences between the compressibility effects and the variable density effects associated with heat transfer is performed. In addition, the difference between the Favre average and Reynolds average is measured, and the SGS terms of the Favre-filtered Navier-Stokes equations are calculated and analyzed.

Sign in / Sign up

Export Citation Format

Share Document