scholarly journals Dynamic stall in vertical axis wind turbines: scaling and topological considerations

2018 ◽  
Vol 841 ◽  
pp. 746-766 ◽  
Author(s):  
Abel-John Buchner ◽  
Julio Soria ◽  
Damon Honnery ◽  
Alexander J. Smits
Keyword(s):  
Wind Turbine ◽  
Wind Turbines ◽  
Vortex Shedding ◽  
Turbine Blades ◽  
Vertical Axis ◽  
Dynamic Stall ◽  
Speed Ratio ◽  
Vertical Axis Wind Turbine ◽  
Wind Turbine Blades ◽  
Vertical Axis Wind Turbines

Vertical axis wind turbine blades are subject to rapid, cyclical variations in angle of attack and relative airspeed which can induce dynamic stall. This phenomenon poses an obstacle to the greater implementation of vertical axis wind turbines because dynamic stall can reduce turbine efficiency and induce structural vibrations and noise. This study seeks to provide a more comprehensive description of dynamic stall in vertical axis wind turbines, with an emphasis on understanding its parametric dependence and scaling behaviour. This problem is of practical relevance to vertical axis wind turbine design but the inherent coupling of the pitching and velocity scales in the blade kinematics makes this problem of more broad fundamental interest as well. Experiments are performed using particle image velocimetry in the vicinity of the blades of a straight-bladed gyromill-type vertical axis wind turbine at blade Reynolds numbers of between 50 000 and 140 000, tip speed ratios between $\unicode[STIX]{x1D706}=1$ to $\unicode[STIX]{x1D706}=5$, and dimensionless pitch rates of $0.10\leqslant K_{c}\leqslant 0.20$. The effect of these factors on the evolution, strength and timing of vortex shedding from the turbine blades is determined. It is found that tip speed ratio alone is insufficient to describe the circulation production and vortex shedding behaviour from vertical axis wind turbine blades, and a scaling incorporating the dimensionless pitch rate is proposed.

On the Use of Velocity Data for Load Estimation of a VAWT in Dynamic Stall

2011 ◽  
Vol 133 (1) ◽  
Author(s):  
Carlos J. Simão Ferreira ◽  
Gerard J. W. van Bussel ◽  
Gijs A. M. van Kuik ◽  
Fulvio Scarano
Keyword(s):  
Velocity Field ◽  
Wind Turbine ◽  
Turbine Blades ◽  
Pressure Sensors ◽  
Vertical Axis ◽  
Dynamic Stall ◽  
Velocity Data ◽  
Vertical Axis Wind Turbine ◽  
Wind Turbine Blades ◽  
Image Velocimetry

This paper focuses on evaluating the feasibility of estimating loads on vertical axis wind turbine blades in dynamic stall with velocity data acquired with Particle Image Velocimetry. The study uses numerical simulation data of a 2D Vertical Axis Wind Turbine in dynamic stall to verify sources of error and uncertainty and estimate the accuracy of the method. The integration of the forces from the velocity field overcomes the difficulties and limitations presented by pressure sensors for estimating the local section loads, but adds the difficulty in determining the correct velocity field and its time and spatial derivatives. The analysis also evaluates the use of phase-locked average data as an estimator of average loads.

scholarly journals Application of Simultaneous Symmetric and Cambered Airfoils in Novel Vertical Axis Wind Turbines

2021 ◽  
Vol 11 (17) ◽  
pp. 8011
Author(s):  
Sajad Maleki Dastjerdi ◽  
Kobra Gharali ◽  
Armughan Al-Haq ◽  
Jatin Nathwani
Keyword(s):  
Wind Turbine ◽  
Wind Turbines ◽  
Vertical Axis ◽  
Dynamic Stall ◽  
Power Coefficient ◽  
Speed Ratio ◽  
Vertical Axis Wind Turbines ◽  
Good Potential ◽  
Computational Fluid Dynamics Cfd ◽  
Naca0018 Airfoil

Two novel four-blade H-darrieus vertical axis wind turbines (VAWTs) have been proposed for enhancing self-start capability and power production. The two different airfoil types for the turbines are assessed: a cambered S815 airfoil and a symmetric NACA0018 airfoil. For the first novel wind turbine configuration, the Non-Similar Airfoils 1 (NSA-1), two NACA0018 airfoils, and two S815 airfoils are opposite to each other. For the second novel configuration (NSA-2), each of the S815 airfoils is opposite to one NACA0018 airfoil. Using computational fluid dynamics (CFD) simulations, static and dynamic conditions are evaluated to establish self-starting ability and the power coefficient, respectively. Dynamic stall investigation of each blade of the turbines shows that NACA0018 under dynamic stall impacts the turbine’s performance and the onset of dynamic stall decreases the power coefficient of the turbine significantly. The results show that NSA-2 followed by NSA-1 has good potential to improve the self-starting ability (13.3%) compared to the turbine with symmetric airfoils called HT-NACA0018. In terms of self-starting ability, NSA-2 not only can perform in about 66.67% of 360° similar to the wind turbine with non-symmetric airfoils (named HT-S815) but the power coefficient of NSA-2 at the design tip speed ratio of 2.5 is also 4.5 times more than the power coefficient of HT-S815; the power coefficient difference between HT-NACA0018 and HT-S815 (=0.231) is decreased significantly when HT-S815 is replaced by NSA-2 (=0.076). These novel wind turbines are also simple.

Numerical Investigations on the Use of Multi-Element Airfoils for Vertical Axis Wind Turbine Configurations

2013 ◽  
Author(s):  
Elhadji A. A. Bah ◽  
Lakshmi N. Sankar ◽  
Jechiel I. Jagoda
Keyword(s):  
Wind Turbines ◽  
Vertical Axis ◽  
Dynamic Stall ◽  
Speed Ratio ◽  
Single Element ◽  
Ratio Analysis ◽  
Vertical Axis Wind Turbine ◽  
Tip Speed Ratio ◽  
Pressure Distributions ◽  
Vertical Axis Wind Turbines

Vertical axis wind turbines (VAWT) have a relatively simple, rugged construction compared to HAWTs. However, vertical-axis wind turbines have numerous challenges that may hinder their performance. For instance they are strongly affected by dynamic stall at low tip speed ratios. A significant part of the kinetic energy contained in the oncoming wind is lost in swirl and vortices. As a result, VAWTs have a lower power production and efficiency compared to HAWTs. In an effort to alleviate the adverse effects of dynamic stall phenomena, the present study explores the use of two-element airfoils. A comparative study of single element and dual element VAWT configurations for representative VAWT turbines is given. The benefits of dual-element configurations are analyzed through a detailed flow visualization study of the single and two-element VAWT configurations at various azimuthal locations for a representative tip speed ratio. Analysis of these qualitative phenomena is complemented by a discussion on quantitative data for torque, surface pressure distributions, and airloads.

Unsteady Flow Simulation and Dynamic Stall Behaviour of Vertical Axis Wind Turbine Blades

2011 ◽  
Vol 35 (4) ◽  
pp. 511-527 ◽  
Author(s):  
Ning Qin ◽  
Robert Howell ◽  
Naveed Durrani ◽  
Kenichi Hamada ◽  
Tomos Smith
Keyword(s):  
Unsteady Flow ◽  
Wind Turbine ◽  
Turbine Blades ◽  
Flow Simulation ◽  
Vertical Axis ◽  
Dynamic Stall ◽  
Vertical Axis Wind Turbine ◽  
Wind Turbine Blades ◽  
Unsteady Flow Simulation

Numerical Studies on the Effect of Cambered Airfoil Blades on Self-Starting of Vertical Axis Wind Turbine Part 1: NACA 0012 and NACA 4415

2015 ◽  
Vol 787 ◽  
pp. 250-254 ◽  
Author(s):  
T. Micha Premkumar ◽  
Sivamani Seralathan ◽  
T. Mohan ◽  
N.N.P. Saran Reddy
Keyword(s):  
Wind Turbine ◽  
Turbine Blades ◽  
Vertical Axis ◽  
Vertical Axis Wind Turbine ◽  
Wind Turbine Blades ◽  
Static Pressure Distribution ◽  
Numerical Studies ◽  
Airfoil Blades ◽  
Torque Values ◽  
Naca 0012

This is Part-1 of the two-part paper in considering the effect of cambered airfoil blades on self-starting of vertical axis wind turbine. Part 1 reports the numerical studies on self-starting of vertical axis wind turbine with comparative studies involving NACA 0012 and cambered airfoil NACA 4415. Part 2 of the paper deals with numerical studies of NACA 0018 and cambered air foil NACA 63415. Darrieus type VAWT is attracting many researchers attention for its inherent advantages and its diversified applications. However, a disadvantage is when the rotor is stationary, no net rotational forces arises, even at high-wind speed. The principal advantage of the vertical axis format is their ability to accept wind from any direction without yawing mechanism. However, self-starting capability is the major drawbacks. Moreover, literatures based on computational analysis involving the cambered airfoil are few only. The objective of this present study is to select the suitable airfoil blades on self-starting of VAWT at low-Reynolds number. The numerical studies are carried out to identify self-starting capability of the airfoil using CFD analysis by studying the flow field over the vertical axis wind turbine blades. The commercial CFD code, ANSYS CFX 13.0© was used for the present studies. Initially, the flow over NACA 0012 was simulated and analyzed for different angles of attacks and similarly carried out for NACA 4415. The contours of static pressure distribution and velocity as well as the force and torque were obtained. Even though the lift force for cambered airfoil NACA 4415 is higher, based on the torque values of the above blade profiles, asymmetrical airfoil NACA 0012 is found to be appropriate for self-starring of VAWT.

Vertical axis wind turbine operation in icing conditions: A review study

2021 ◽  
pp. 0309524X2110618
Author(s):  
Syed Abdur Rahman Tahir ◽  
Muhammad Shakeel Virk
Keyword(s):  
Wind Turbine ◽  
Wind Turbines ◽  
Vertical Axis ◽  
Electricity Production ◽  
Vertical Axis Wind Turbine ◽  
Vertical Axis Wind Turbines ◽  
Horizontal Axis Wind Turbines ◽  
Promising Solution ◽  
Review Study ◽  
Accretion Physics

Vertical Axis Wind Turbine (VAWT) can be a promising solution for electricity production in remote ice prone territories of high north, where good wind resources are available, but icing is a challenge that can affect its optimum operation. A lot of research has been made to study the icing effects on the conventional horizontal axis wind turbines, but the literature about vertical axis wind turbines operating in icing conditions is still scarce, despite the importance of this topic. This paper presents a review study about existing knowledge of VAWT operation in icing condition. Focus has been made in better understanding of ice accretion physics along VAWT blades and methods to detect and mitigate icing effects.

scholarly journals Numerical Simulation of Aerodynamic Performance of Off-grid Small Vertical Axis Wind Turbine

2018 ◽  
Vol 53 ◽  
pp. 02004
Author(s):  
Qiuyun Mo ◽  
Jiabei Yin ◽  
Lin Chen ◽  
Weihao Liu ◽  
Li Jiang ◽  
...  
Keyword(s):  
Wind Turbine ◽  
Turbine Blades ◽  
Vertical Axis ◽  
Aerodynamic Performance ◽  
Velocity Fields ◽  
Compact Model ◽  
Vertical Axis Wind Turbine ◽  
Wind Turbine Blades ◽  
Rotation Domain ◽  
Rng Turbulence Model

In this paper, a 2D off-grid small compact model of vertical axis wind turbine was established. The sliding grid technology, the RNG turbulence model and the Coupld algorithm was applied to simulate the unsteady value of the model's aerodynamic performance. Through the analysis on the flow field at difference moments, the rules about velocity fields, vortices distributions and the wind turbine's total torque were obtained. The results show that: the speed around wind turbine blades have obvious gradient, and the velocity distribution at different times show large differences in the computional domain. In the rotating domain vorticity is large. With away from the rotation domain, vorticity reduced quickly. In the process of rotating for vertical axis wind turbine, the wind turbine's total torque showed alternating positive and negative changes.

Sign in / Sign up

Export Citation Format

Share Document