Optimal frequency for flow energy harvesting of a flapping foil

2011 ◽  
Vol 675 ◽  
pp. 495-517 ◽  
Author(s):  
QIANG ZHU

Inspired by the correlation between the propulsion efficiency of a flapping foil propeller and stability of the wake behind it (which leads to the optimal Strouhal number for propulsion), we numerically simulated a heaving/pitching foil in energy harvesting regime, and investigated the relation between wake stability and the energy harvesting efficiency. The base flow is computed using a Navier–Stokes algorithm and the stability analysis is performed via the Orr–Sommerfeld equation. The wake is found to be convectively unstable and the frequency of the most unstable mode fw is determined. The case when fw ~ f coincides with maximum energy harvesting efficiency of the system (f is the frequency of foil oscillation), suggesting that flow energy extraction is closely related to efficient evolution of the wake. This occurs at a frequency of f ~ 0.15 (f is normalized by the chord length and the flow speed), under the constraint that there is significant vortex shedding from the leading edge at sufficiently large effective angles of attack. Indeed, this ‘foil–wake resonance’ is usually associated with multi-vortex shedding from the leading edge. Furthermore, detailed examination of energy extractions from the heaving and the pitching motions indicates that near the optimal performance point the average energy extraction from the pitching motion is close to zero. This suggests the feasibility of achieving high-efficient energy harvesting through a simple fully passive system we proposed earlier in which no activation is needed.

Author(s):  
Firas F. Siala ◽  
Alexander D. Totpal ◽  
James A. Liburdy

An experimental investigation is conducted to study the leading edge vortex (LEV) evolution of a simultaneously heaving and pitching foil operating in the energy harvesting regime. Two dimensional particle image velocimetry measurements are collected in a wind tunnel at reduced frequencies of k = fc/U = 0.05–0.20. Vorticity flux analysis is performed to calculate the constant C in the vortex formation number equation proposed by J. O. Dabiri [1], and it is shown that for a flapping foil operating in the energy harvesting regime, this constant is approximately equal to 1.33. We demonstrate that the optimal LEV formation number (T̂max ≈ 4) is achieved at k = 0.11, which is well within the range of optimal reduced frequency for energy harvesting applications (k = 0.1–0.15). This suggests that the flow energy extraction is closely related to the efficient evolution process of the LEV.


Author(s):  
Olivier Doaré ◽  
Sébastien Michelin ◽  
Miguel Pineirua ◽  
Yifan Xia

In this article, energy harvesting with a fluttering cantilevered plate covered by piezoelectric patches in an axial flow is adressed. A theoretical model is presented which is then discretized and numerically integrated to perform a parametric study of the energy harvesting efficiency of the system. When one, two or three piezoelectric patches cover the plate, the optimal distributions of the patches that maximize the efficiency are obtained. Experimental results are presented, which are in good agreement with the model. When a significantly high number of patches of small size are considered, a continuous model is used to study the influence of a resonant harvesting circuit. A lock-in phenomenon is evidenced, which is able to significantly increase the efficiency.


2018 ◽  
Vol 30 (2) ◽  
pp. 193-211 ◽  
Author(s):  
Maryam Pourmahdavi ◽  
Mohammad Naghi Safari ◽  
Shahram Derakhshan

The flapping foil hydrokinetics turbine is a new method to generate energy from incoming flow field. The numerical simulations have been performed computationally by using two-dimensional unsteady Reynolds-averaged Navier–Stokes equations. It was found that the maximum energy efficiency reached about 35.2% when the reduced frequency was 0.11; at this time, the foil experienced a light dynamic stall and two opposite-sign vorticities were shed from the foil per half of the cycle. This report also studied the energy extraction performance of flapping foil device and the correlation between the foil kinematic parameters and the flow fields around it at actual operating Reynolds number comprehensively. In addition, the vortex variation and the pressure coefficient distribution along the foil’s surface were used to demonstrate the mechanism of flapping foil energy generation turbine. The creation and shedding of the leading edge vortex played the critical role in energy transformation between the flow fluid and energy harvesting systems. Therefore, if the timing of the leading edge vortex generation and shedding is controlled, the energy extraction efficiency can be increased considerably.


2021 ◽  
Vol 6 (7) ◽  
Author(s):  
Bernardo Luiz R. Ribeiro ◽  
Yunxing Su ◽  
Quentin Guillaumin ◽  
Kenneth S. Breuer ◽  
Jennifer A. Franck

2016 ◽  
Author(s):  
Douglas Da Costa Ferreira ◽  
Fábio Roberto Chavarette ◽  
Jean-Marc Stephane Lafay ◽  
Paulo Rogerio Novak ◽  
Samuel Pagotto ◽  
...  

2010 ◽  
Author(s):  
S. P. Philipps ◽  
G. Peharz ◽  
R. Hoheisel ◽  
T. Hornung ◽  
N. M. Al-Abbadi ◽  
...  

2018 ◽  
Vol 15 (1) ◽  
pp. 172988141875587 ◽  
Author(s):  
Tao Wang ◽  
Wei Song ◽  
Shiqiang Zhu

Energy consumption has significant influence on the working time of soft robots in mobile applications. Fluidic soft actuators usually release pressurized fluid to environment in retraction motion, resulting in dissipation of considerable energy, especially when the actuators are operated frequently. This article mainly explores the potential and approaches of harvesting the energy released from the actuators. First, the strain energy and pressurized energy stored in fluidic soft actuators are modeled based on elastic mechanics. Then, taking soft fiber-reinforced bending actuators as case study, the stored energy is calculated and its parametric characteristics are presented. Finally, two energy harvesting schematics as well as dynamic models are proposed and evaluated using numerical analysis. The results show that the control performance of the energy harvesting system becomes worse because of increased damping effect and its energy harvesting efficiency is only 14.2% due to the losses of energy conversion. The energy harvesting system in pneumatic form is a little more complex. However, its control performance is close to the original system and its energy harvesting efficiency reaches about 44.1%.


2022 ◽  
Vol 891 ◽  
pp. 162040
Author(s):  
Ikhtiar Ahmad ◽  
Rashida Jafer ◽  
Syed Mustansar Abbas ◽  
Nisar Ahmad ◽  
Ata-ur-Rehman ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document