Low-Reynolds-number effects in a fully developed turbulent channel flow

1992 ◽  
Vol 236 ◽  
pp. 579-605 ◽  
Author(s):  
R. A. Antonia ◽  
M. Teitel ◽  
J. Kim ◽  
L. W. B. Browne

Low-Reynolds-number effects are observed in the inner region of a fully developed turbulent channel flow, using data obtained either from experiments or by direct numerical simulations. The Reynolds-number influence is observed on the turbulence intensities and to a lesser degree on the average production and dissipation of the turbulent energy. In the near-wall region, the data confirm Wei & Willmarth's (1989) conclusion that the Reynolds stresses do not scale on wall variables. One of the reasons proposed by these authors to account for this behaviour, namely the ‘geometry’ effect or direct interaction between inner regions on opposite walls, was investigated in some detail by introducing temperature at one of the walls, both in experiment and simulation. Although the extent of penetration of thermal excursions into the opposite side of the channel can be significant at low Reynolds numbers, the contribution these excursions make to the Reynolds shear stress and the spanwise vorticity in the opposite wall region is negligible. In the inner region, spectra and co-spectra of the velocity fluctuations u and v change rapidly with the Reynolds number, the variations being mainly confined to low wavenumbers in the u spectrum. These spectra, and the corresponding variances, are discussed in the context of the active/inactive motion concept and the possibility of increased vortex stretching at the wall. A comparison is made between the channel and the boundary layer at low Reynolds numbers.

2000 ◽  
Author(s):  
Ajit Pal Singh ◽  
S. H. Winoto ◽  
D. A. Shah ◽  
K. G. Lim ◽  
Robert E. K. Goh

Abstract Performance characteristics of some low Reynolds number airfoils for the use in micro air vehicles (MAVs) are computationally studied using XFOIL at a Reynolds number of 80,000. XFOIL, which is based on linear-vorticity stream function panel method coupled with a viscous integral formulation, is used for the analysis. In the first part of the study, results obtained from the XFOIL have been compared with available experimental data at low Reynolds numbers. XFOIL is then used to study relative aerodynamic performance of nine different airfoils. The computational analysis has shown that the S1223 airfoil has a relatively better performance than other airfoils considered for the analysis.


2016 ◽  
Vol 28 (3) ◽  
pp. 273-285
Author(s):  
Katsuya Hirata ◽  
◽  
Ryo Nozawa ◽  
Shogo Kondo ◽  
Kazuki Onishi ◽  
...  

[abstFig src='/00280003/02.jpg' width=""300"" text='Iso-Q surfaces of very-slow flow past an iNACA0015' ] The airfoil is often used as the elemental device for flying/swimming robots, determining its basic performances. However, most of the aerodynamic characteristics of the airfoil have been investigated at Reynolds numbers Re’s more than 106. On the other hand, our knowledge is not enough in low Reynolds-number ranges, in spite of the recent miniaturisation of robots. In the present study, referring to our previous findings (Hirata et al., 2011), we numerically examine three kinds of high-performance airfoils proposed for very-low Reynolds numbers; namely, an iNACA0015 (the NACA0015 placed back to front), an FPBi (a flat plate blended with iNACA0015 as its upper half) and an FPBN (a flat plate blended with the NACA0015 as its upper half), in comparison with such basic airfoils as a NACA0015 and an FP (a flat plate), at a Reynolds number Re = 1.0 × 102 using two- and three-dimensional computations. As a result, the FPBi shows the best performance among the five kinds of airfoils.


2010 ◽  
Vol 22 (S1) ◽  
pp. 215-218 ◽  
Author(s):  
Jian-ping Luo ◽  
Zhi-ming Lu ◽  
TatsLo Ushijima ◽  
Osami Kitoh ◽  
Xiang Qiu ◽  
...  

1997 ◽  
Author(s):  
Peter O'Sullivan ◽  
Sedat Biringen ◽  
Peter O'Sullivan ◽  
Sedat Biringen

Sign in / Sign up

Export Citation Format

Share Document