scholarly journals Liquid–Liquid Phase Behavior of Diesel/Biofuel Blends: Ternary Mixtures of n-Hexadecane, 2,2,4,4,6,8,8-Heptamethylnonane, and Ethanol and the Binary Subsystems

2021 ◽  
Vol 35 (6) ◽  
pp. 4835-4847
Author(s):  
Anna Ballhause ◽  
Sabine Wagenfeld ◽  
Johannes Kiefer ◽  
Wolffram Schröer ◽  
Bernd Rathke
1981 ◽  
Vol 21 (04) ◽  
pp. 480-492 ◽  
Author(s):  
F.M. Orr ◽  
A.D. Yu ◽  
C.L. Lien

Abstract Phase behavior of CO2/Crude-oil mixtures which exhibit liquid/liquid (L/L) and liquid/ liquid/vapor (L/L/V) equilibria is examined. Results of single-contact phase behavior experiments for CO2/separator-oil mixtures are reported. Experimental results are interpreted using pseudoternary phase diagrams based on a review of phase behavior data for binary and ternary mixtures of CO2 with alkanes. Implications for the displacement process of L/L/V phase behavior are examined using a one-dimensional finite difference simulator. Results of the analysis suggest that L/L and L/L/V equilibria will occur for CO2/crude-oil mixtures at temperatures below about 120 degrees F (49 degrees C) and that development of miscibility occurs by extraction of hydrocarbons from the oil into a CO2-rich liquid phase in such systems. Introduction The efficiency of a displacement of oil by CO2 depends on a variety of factors, including phase behavior of CO2/crude-oil mixtures generated during the displacement, densities and viscosities of the phases present, relative permeabilities to individual phases, and a host of additional complications such as dispersion, viscous fingering, reservoir heterogeneities, and layering. It generally is acknowledged that phase behavior and attendant compositional effects on fluid properties strongly influence local displacement efficiency, though it also is clear that on a reservoir scale, poor vertical and areal sweep efficiency (caused by the low viscosity of the displacing CO2) may negate the favorable effects of phase behavior.Interpretation of the effects of phase behavior on displacement efficiency is made difficult by the complexity of the behavior of CO2/crude-oil mixtures. The standard interpretation of CO2 flooding phase behaviour, given first by Rathmell et al. is that CO2 flooding behaves much like a vaporizing gas drive, as described originally by Hutchinson and Braun. During a flood, vaporphase CO2 mixes with oil in place and extracts light and intermediate hydrocarbons. After multiple contacts, the CO2-rich phase vaporizes enough hydrocarbons to develop a composition that can displace oil efficiently, if not miscibly. The picture presented by Rathmell et al. appears to be consistent with phase behavior observed for CO2/ crudeoil mixtures as long as the reservoir temperature is high enough. Table 1 summarizes data reported for CO2/crude-oil mixtures. Of the 10 systems studied, all those at temperatures above 120 degrees F (50 degrees C) show only L/V equilibria while those below 120 degrees F exhibit L/L/V separations (Stalkup also reports two phase diagrams that are qualitatively similar to the other low-temperature diagrams but does not give temperatures). Thus, at temperatures not too far above the critical temperature of CO2 [88 degrees F (31 degrees C)], mixtures of CO2 and crude oil exhibit multiple liquid phases, and at some pressures L/L/V equilibria are observed. It has not been established whether Rathmell et al.'s interpretation of the process mechanism can be extended to cover the more complex phase behavior of low-temperature CO2/crude-oil mixtures. In a recent paper, Metcalfe and Yarborough argued critical temperature CO2 floods behave more like condensing gas drives, whereas Kamath et al. concluded that an increase in the solubility of liquid-phase CO2 in crude oil at temperatures near the critical temperature of CO2 should cause more efficient displacements of oil by CO2. SPEJ P. 480^


AIChE Journal ◽  
2008 ◽  
Vol 54 (7) ◽  
pp. 1886-1894 ◽  
Author(s):  
Brian C. Attwood ◽  
Carol K. Hall

1979 ◽  
Vol 44 (8) ◽  
pp. 2378-2383 ◽  
Author(s):  
Libor Červený ◽  
Radka Junová ◽  
Vlastimil Růžička

Hydrogenation of olefinic substrates in binary and ternary mixtures using 5% Pt on silica gel as the catalyst was studied in normal conditions in the liquid phase with methanol or cyclohexane or in solvent-free systems. The effect of the solvent concentration on the selectivity of hydrogenation of the unsaturated alcohol-olefin binary mixtures was investigated. In ternary systems of unsaturated substrates, the effect of each of the substrates on the selectivity of hydrogenation of the remaining two substances was examined. Another system was found in which a jump change of the hydrogenation selectivity occurred on the vanishing of the fastest reacting substance.


1972 ◽  
Vol 12 (02) ◽  
pp. 89-95 ◽  
Author(s):  
Ahmad H.M. Totonji ◽  
S.M. Farouq Ali

Abstract The chief objective of the study was to exercise control on the system phase behavior through the use of mixtures of two alcohols exhibiting opposite phase behavior characteristics in the alcohol-hydrocarbon-water system involved. Such systems were employed in displacements in porous media to ascertain their effectiveness. Introduction Displacement of oil and water in a porous medium by a mutually miscible alcohol or other solvent has been the subject of numerous investigations. This process, in spite of its limited scope as an oil recovery method, has certain mechanistic features that are of value in gaining an understanding of some of the newer recovery techniques (e.g., the Maraflood* process). The works of Gatlin and Slobod, proposing piston-like displacement of oil and water by a miscible alcohol; of Taber et al., describing the displacement mechanism in terms of the ternary phase behavior involved; and of Holm and Csaszar, defining displacement mechanism in terms of phase velocity ratio, are major contributions in this area. In a later work, Taber and Meyer suggested the addition of small amounts of oil and water (as the case may be) to the alcohol used for displacement, since this helped to obtain piston-like displacements with systems that are usually characterized by the efficient displacement of either oil or water. APPARATUS, EXPERIMENTAL PROCEDURE, AND SIMULATOR PROCEDURE, AND SIMULATOR The procedure employed for determining the equilibrium phase behavior of ternary systems involved the titration of a hydrocarbon-water (or brine) mixture by the particular solvent (pure alcohol, or alcohol mixture) for the determination of the binodal curve, and the analysis by refractive index measurement of ternary mixtures having known compositions for the determination of the tie lines. Since the procedure is valid for strictly ternary systems, its use in this case where essentially quaternary systems are involved would yield the total alcohol content rather than the correct proportion of each alcohol. The ternary diagrams presented should be viewed with this limitation in mind. presented should be viewed with this limitation in mind. The apparatus used for experimental runs in porous media consisted of a positive displacement Ruska pump and a core encased in a steel pipe. Suitable sampling apparatus and auxiliary equipment were employed. Most runs consisted of injecting a slug of the particular solvent into a core initially containing a residual oil (waterflood) or irreducible water saturation, at a constant rate, and then following the slug by water or brine. The effluent samples collected were analyzed for the hydrocarbon, water and alcohol in order to plot the production histories. Complete experimental details and fluid production histories. Complete experimental details and fluid properties are given in Ref. 6. Table 1 lists the properties properties are given in Ref. 6. Table 1 lists the properties of the porous media used. Computer simulations of some of the experimental runs, as well as exploratory simulations, were carried out using the method earlier reported. The method basically consists in the representation of a porous medium by a certain number of cells containing immobile oil (or oleic) and water (or aqueous) fractions into which alcohol is injected in a stepwise manner allowing for phase changes. SPEJ P. 89


1982 ◽  
Vol 86 (3) ◽  
pp. 393-400 ◽  
Author(s):  
B. M. Knickerbocker ◽  
C. V. Pesheck ◽  
H. T. Davis ◽  
L. E. Scriven

Sign in / Sign up

Export Citation Format

Share Document