Using Triethylborane to Manipulate Reactivity Ratios in Epoxide-Anhydride Copolymerization: Application to the Synthesis of Polyethers with Degradable Ester Functions

The anionic ring-opening copolymerization (ROCOP) of epoxides, namely of ethylene oxide (EO), with anhydrides (AH) generally produces strictly alternating copolymers. With triethylborane (TEB)-assisted ROCOP of EO with AH, statistical copolymers of high molar mass including ether and ester units could be obtained. In the presence of TEB, the reactivity ratio of EO (rEO), which is normally equal to 0 in its absence, could be progressively raised to values lower than 1 or higher than 1. Conditions were even found to obtain rEO equal or close to 1. Samples of P(EO-co-ester) with minimal compositional drift could be synthesized; upon basic degradation of their ester linkages, these samples afforded poly(ethylene oxide) (PEO) diol samples of narrow molar mass distribution. In other cases where rEO were lower or higher than 1, the PEO diol samples eventually isolated after degradation exhibited a broader distribution of molar masses because of the compositional drift of initial P(EO-co-ester) samples.

Study on effect of supercritical CO2 on structural ordering and charge transporting property in thiophene-based block copolymer

We reported that supercritical (sc) annealing of poly(3-hexylthiophene) (P3HT), and its block copolymers with poly(ethylene oxide) (PEO) and polystyrene (PSt) brought about improvements in the crystal structure and hole mobility, determined by the space charge limited current (SCLC) measurement. P3HT-b-PEO showed the largest increase in mobility. From XRD profile, it was found that the treatment with scCO2 increased the crystallite size and crystallinity. UV-vis spectra showed that the effective conjugation length in the scCO2 treated films was increased compared to the as-spun, suggesting that CO2 molecules are incorporated into domains of the second block domains and P3HT amorphous region, and assist to alter the characteristics of the crystalline region. Then, it was considered that the change in the crystalline structure and the improvement of P3HT chains packing led to the enhanced mobility. Since PEO is known to have a higher affinity for CO2, the increase of mobility was specifically intensive.

Effect of Potassium Alum Salt Particles on the Activation Energy of Poly(ethylene oxide) Doped with Conductive Carbon Black (CB) Nanoparticles

The electrical properties of conductive carbon black (CB) nanoparticles (0.1wt percent) doped thin films made of poly(ethylene oxide) (PEO) filled with varying amounts of the electrolyte potassium alum salt and doped with conductive carbon black (CB) nanoparticles (0.1wt percent) have been investigated. The dependence of the activation energy of the composites on frequency, temperature, and filler content was studied using the AC impedance technique. The current research looked at how activation energy changed with frequency (200-1000 kHz) and temperature (30-55oC) for composites with varied potassium alum salt concentrations: 0, 2, 4, 8, 12, and 16 wt. percent. The activation energy (Ea) values measured exhibited frequency, temperature, and filler content relationships. According to polarization processes, the activation energy of the produced sheets decreases with the potassium alum salt content in the composite and decreases with the temperature. With increasing frequency, the activation energy of the produced thin films decreases.

E-Beam Cross-Linking of Complex Hydrogels Formulation: The Influence of Poly(Ethylene Oxide) Concentration on the Hydrogel Properties

In the present study, we report on the complex hydrogels formulations based on collagen-poly(vinyl pyrrolidone) (PVP)-poly(ethylene oxide) (PEO) cross-linked by e-beam irradiation in an aqueous polymeric solution, aiming to investigate the influence of different PEO concentrations on the hydrogel properties. The hydrogel networks’ structure and their composition were investigated using equilibrium swelling degree, complex rheological analysis, and FT-IR spectroscopy. Rheological analysis was performed to determine the elastic (G′) and viscous (G″) moduli, the average molecular weight between cross-linking points (Mc), cross-link density (Ve), and the mesh size (ξ). The effect of the PEO concentration on the properties of the hydrogel was investigated as well. Depending on the PEO concentration added in their composition, the hydrogels swelling degree depends on the absorbed dose, being lower at low PEO concentrations. All hydrogel formulations showed higher G′ values (9.8 kPa) compared to G″ values (0.2 kPa), which shows that the hydrogels have a predominantly elastic behavior. They presented stability greater than 72 h in physiological pH buffers and reached equilibrium after 25 h. The Mc parameter is strongly dependent on the PEO concentration and the absorbed dose for all hydrogel compositions. The cross-linking density increased with the absorbed dose.

Ion-Conducting Flexible Thin Films of Composites from Poly(ethylene oxide) and Nematic Liquid Crystals E8—Characterization by Impedance and Dielectric Relaxation Spectroscopy

Complex electrical impedance and dielectric spectroscopy were applied to study the dielectric relaxations and their thermal behavior in ion-conducting composites/complexes from polymer poly(ethylene oxide) (PEO) and E8 nematic liquid crystals (LCs), at the compositional ratio PEO:E8 = 70:30 wt%. Flexible thin films of PEO/E8 with a thickness of 150 μm were inspected, as well as such films from Na+ ion-conducting electrolyte PEO/E8/NaIO4 with the same PEO:E8 compositional ratio, but additionally containing 10 wt.% from the salt sodium metaperiodate (NaIO4) as a dopant of Na+ ions. The molecular dynamics, namely the dielectric relaxation of PEO/E8 and PEO/E8/NaIO4, were characterized through analyses of complex impedance and dielectric spectra measured in the frequency range of 1 Hz–1 MHz, under variation of temperature from below to above the glass-transition temperature of these composites. The relaxation and polarization of dipole formations in PEO/E8 and PEO/E8/NaIO4 were evidenced and compared in terms of both electrical impedance and dielectric response depending on temperature. The results obtained for molecular organization, molecular relaxation dynamics, and electric polarization in the studied ion-conducting polymer/LC composites/complexes can be helpful in the optimization of their structure and performance, and are attractive for applications in flexible organic electronics, energy storage devices, and mechatronics.