Understanding the Effect of Different Biomass Ash Additions on Pyrolysis Product Distribution, Char Physicochemical Characteristics, and Char Gasification Reactivity of Bituminous Coal

2019 ◽  
Vol 33 (4) ◽  
pp. 3068-3076 ◽  
Author(s):  
Juntao Wei ◽  
Qinghua Guo ◽  
Lu Ding ◽  
Yan Gong ◽  
Junqin Yu ◽  
...  
2020 ◽  
Vol 7 (3) ◽  
pp. 464-475 ◽  
Author(s):  
Xiaoming Li ◽  
Caifeng Yang ◽  
Mengjie Liu ◽  
Jin Bai ◽  
Wen Li

Abstract Catalytic coal gasification technology shows prominent advantages in enhancing coal gasification reactivity and is restrained by the cost of catalyst. Two typical biomass ash additions, corn stalk ash (CSA, high K–Na and low Si) and poplar sawdust ash (PSA, high K–Ca and high Si), were employed to study the influence of biomass ash on pyrolysis process and char gasification reactivity of the typical anthracite. Microstructure characteristics of the char samples were examined by X-ray diffraction (XRD). Based on isothermal char-CO2 gasification experiments, the influence of biomass ash on reactivity of anthracite char was determined using thermogravimetric analyzer. Furthermore, structural parameters were correlated with different reactivity parameters to illustrate the crucial factor on the gasification reactivity varied with char reaction stages. The results indicate that both CSA and PSA additives hinder the growth of adjacent basic structural units in a vertical direction of the carbon structure, and then slow down the graphitization process of the anthracite during pyrolysis. The inhibition effect is more prominent with the increasing of biomass ash. In addition, the gasification reactivity of anthracite char is significantly promoted, which could be mainly attributed to the abundant active AAEM (especially K and Na) contents of biomass ash and a lower graphitization degree of mixed chars. Higher K and Na contents illustrate that the CSA has more remarkable promotion effect on char gasification reactivity than PSA, in accordance with the inhibition effect on the order degree of anthracite char. The stacking layer number could reasonably act as a rough indicator for evaluating the gasification reactivity of the char samples.


2019 ◽  
Vol 16 (14) ◽  
pp. 1144-1151 ◽  
Author(s):  
Junwei Chen ◽  
Weibin Chen ◽  
Ru Ji ◽  
Yang Jiao ◽  
Xidong Wang

Catalysts ◽  
2020 ◽  
Vol 10 (2) ◽  
pp. 187
Author(s):  
Yuguo Dong ◽  
Xinyu Lu ◽  
Chengjuan Hu ◽  
Liang Li ◽  
Qixiang Hu ◽  
...  

This paper investigated the pyrolytic behaviors of enzymatic hydrolysis lignin (EHL) and EHL treated with steam explosion (EHL-SE) by pyrolysis-gas chromatography/mass spectrometer (Py-GC/MS). It was shown that the main component of the pyrolysis products was phenolic compounds, including G-type, H-type, S-type, and C-type phenols. With different treatment methods, the proportion of units in phenolic products had changed significantly. Meanwhile, proximate, elemental, and FTIR analysis of both lignin substrates were also carried out for a further understanding of the lignin structure and composition with or without steam explosion treatment. FTIR result showed that, after steam explosion treatment, the fundamental structural framework of the lignin substrate was almost unchangeable, but the content of lignin constituent units, e.g., hydroxyl group and alkyl group, evidently changed. It was noticeable that 2-methoxy-4-vinylphenol with 11% relative content was the most predominant pyrolytic product for lignin after steam explosion treatment. Combined with the above analysis, the structural change and pyrolysis product distribution of EHL with or without steam explosion treatment could be better understood, providing more support for the multi-functional utilization of lignin.


Sign in / Sign up

Export Citation Format

Share Document