THE EFFECT OF SURFACE ACTIVE AGENTS ON CRYSTAL GROWTH RATE AND CRYSTAL HABIT

1960 ◽  
Vol 64 (1) ◽  
pp. 13-19 ◽  
Author(s):  
A. S. Michaels ◽  
A. R. Colville
Crystals ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 812
Author(s):  
Freshsya Zata Lini ◽  
Dhanang Edy Pratama ◽  
Tu Lee

The addition of dissolved templating molecules in crystallization will create “supramolecular assemblies” within the solution, serving as “anchor points” for the solute molecules to nucleate and grow. In this work, nucleation and crystal growth kinetics of 2:1 benzoic acid (HBz)–sodium benzoate (NaBz) co-crystallization with or without templates in a solution were analyzed by monitoring the concentration of the mother liquor during cooling crystallization. The results showed that the addition of the dissolved 2:1 or 1:1 HBz–NaBz co-crystals as templating molecules could reduce the critical free energy barrier of 2:1 HBz–NaBz co-crystal during its nucleation, but did not significantly affect the order of crystal growth rate. On the other hand, the critical free energy barrier of the nucleation process was increased if dissolved NaBz was used as a templating molecule, while a significant rise in the order of crystal growth rate occurred. The crystal habit obtained from the NaBz-templated system was needle-like, suggesting that sodium–sodium coordination chains of NaBz supramolecular assemblies in the solution phase were responsible for creating elongated crystals. Conversely, a large prismatic crystal habit found in non-templated and 2:1 and 1:1 HBz–NaBz co-crystal-templated systems implied that those templating molecules formed sparsely interconnected supramolecular assemblies in the solution phase.


1987 ◽  
Vol 48 (C1) ◽  
pp. C1-661-C1-662 ◽  
Author(s):  
J. R. PETIT ◽  
P. DUVAL ◽  
C. LORIUS

1990 ◽  
Vol 55 (7) ◽  
pp. 1691-1707 ◽  
Author(s):  
Miloslav Karel ◽  
Jiří Hostomský ◽  
Jaroslav Nývlt ◽  
Axel König

Crystal growth rates of copper sulphate pentahydrate (CuSO4.5 H2O) determined by different authors and methods are compared. The methods included in this comparison are: (i) Measurement on a fixed crystal suspended in a streaming solution, (ii) measurement on a rotating disc, (iii) measurement in a fluidized bed, (iv) measurement in an agitated suspension. The comparison involves critical estimation of the supersaturation used in measurements, of shape factors used for data treatment and a correction for the effect of temperature. Conclusions are drawn for the choice of values to be specified when data of crystal growth rate measurements are published.


2007 ◽  
Vol 18 (2) ◽  
pp. 260-264 ◽  
Author(s):  
Laura Bereczki ◽  
Emese Pálovics ◽  
Petra Bombicz ◽  
György Pokol ◽  
Elemér Fogassy ◽  
...  

1999 ◽  
Vol 55 (2) ◽  
pp. 577-580 ◽  
Author(s):  
Abel Moreno ◽  
Manuel Soriano-García

In attempts to obtain protein crystals of a sufficient size for structural studies, lack of knowledge of the physicochemical properties of protein solutions and of their crystal-growth behaviour lead to a bottleneck for drug design as well as for X-ray crystallography. Most formal investigations on crystal-growth phenomena have been focused on equilibrium studies, where the protein is soluble, and on the kinetics of crystal growth, which is related to both nucleation and crystal-growth phenomena. The aim of this work is to measure the crystal-growth rate along a capillary tube used as a growing cell. These experiments were carried out using the gel-acupuncture technique [García-Ruiz et al. (1993). Mater. Res. Bull. 28, 541–546; García-Ruiz & Moreno (1994). Acta Cryst. D50, 484–490; García-Ruiz & Moreno (1997). J. Cryst. Growth, 178, 393–401]. Crystal-growth investigations took place using lysozyme and thaumatin I as standard proteins. The maximum average growth rate obtained in the lower part of the capillary tube was about 35 Å s−1 and the minimum average growing rate in the upper part of the capillary tube was about 8 Å s−1. The crystal-growth rate as a function of the supersaturation was experimentally estimated at a constant height along the capillary tube.


1999 ◽  
Vol 14 (9) ◽  
pp. 3653-3662 ◽  
Author(s):  
K. L. Lee ◽  
H. W. Kui

Three different kinds of morphology are found in undercooled Pd80Si20, and they dominate at different undercooling regimens ΔT, defined as ΔT = T1 – Tk, where T1 is the liquidus of Pd80Si20 and Tk is the kinetic crystallization temperature. In the small undercooling regimen, i.e., for ΔT ≤ 190 K, the microstructures are typically dendritic precipitation with a eutecticlike background. In the intermediate undercooling regimen, i.e., for 190 ≤ ΔT ≤ 220 K, spherical morphologies, which arise from nucleation and growth, are identified. In addition, Pd particles are found throughout an entire undercooled specimen. In the large undercooling regimen, i.e., for ΔT ≥ 220 K, a connected structure composed of two subnetworks is found. A sharp decrease in the dimension of the microstructures occurs from the intermediate to the large undercooling regimen. Although the crystalline phases in the intermediate and the large undercooling regimens are the same, the crystal growth rate is too slow to bring about the occurrence of grain refinement. Combining the morphologies observed in the three undercooling regimens and their crystallization behaviors, we conclude that phase separation takes place in undercooled molten Pd80Si20.


Sign in / Sign up

Export Citation Format

Share Document