Direct Numerical Simulation of Statistically Stationary One- and Two-Phase Turbulent Combustion: A Turbulent Injection Procedure

2004 ◽  
Vol 73 (2) ◽  
pp. 133-167 ◽  
Author(s):  
L. Guichard ◽  
Julien Réveillon ◽  
R. Hauguel
2000 ◽  
Author(s):  
J. Réveillon

Abstract Turbulent combustion of two-phase flows is studied by 2D direct numerical simulation. A spray of droplets is injected inside a jet with a preheated coflow. Triple flames appear to represent the global structure of the flame around the spray. Attention is focused upon global and local flame structures and droplet histories. A whole range of combustion phenomena are observed and described. The observed prevailing occurrence, for example, of the rich premixed flame compared to the diffusion flame is of great importance for any turbulent combustion model which must accurately estimate the heat release rate. This prevailing structure depends strongly on the droplet size and combustion. A competition between premixed and diffusion regimes may also occur. It has been shown that in some cases, local clusters of droplets are able either to cross the main flame front and burn in pure oxidizer or to break through the diffusion flame. It is observed that very complex interactions can emerge locally between premixed flames, diffusion flames and droplets.


Author(s):  
Mosayeb Shams ◽  
Kamaljit Singh ◽  
Branko Bijeljic ◽  
Martin J. Blunt

AbstractThis study focuses on direct numerical simulation of imbibition, displacement of the non-wetting phase by the wetting phase, through water-wet carbonate rocks. We simulate multiphase flow in a limestone and compare our results with high-resolution synchrotron X-ray images of displacement previously published in the literature by Singh et al. (Sci Rep 7:5192, 2017). We use the results to interpret the observed displacement events that cannot be described using conventional metrics such as pore-to-throat aspect ratio. We show that the complex geometry of porous media can dictate a curvature balance that prevents snap-off from happening in spite of favourable large aspect ratios. We also show that pinned fluid-fluid-solid contact lines can lead to snap-off of small ganglia on pore walls; we propose that this pinning is caused by sub-resolution roughness on scales of less than a micron. Our numerical results show that even in water-wet porous media, we need to allow pinned contacts in place to reproduce experimental results.


2018 ◽  
Vol 857 ◽  
pp. 270-290 ◽  
Author(s):  
Josef Hasslberger ◽  
Markus Klein ◽  
Nilanjan Chakraborty

This paper presents a detailed investigation of flow topologies in bubble-induced two-phase turbulence. Two freely moving and deforming air bubbles that have been suspended in liquid water under counterflow conditions have been considered for this analysis. The direct numerical simulation data considered here are based on the one-fluid formulation of the two-phase flow governing equations. To study the development of coherent structures, a local flow topology analysis is performed. Using the invariants of the velocity gradient tensor, all possible small-scale flow structures can be categorized into two nodal and two focal topologies for incompressible turbulent flows. The volume fraction of focal topologies in the gaseous phase is consistently higher than in the surrounding liquid phase. This observation has been argued to be linked to a strong vorticity production at the regions of simultaneous high fluid velocity and high interface curvature. Depending on the regime (steady/laminar or unsteady/turbulent), additional effects related to the density and viscosity jump at the interface influence the behaviour. The analysis also points to a specific term of the vorticity transport equation as being responsible for the induction of vortical motion at the interface. Besides the known mechanisms, this term, related to surface tension and gradients of interface curvature, represents another potential source of turbulence production that lends itself to further investigation.


Sign in / Sign up

Export Citation Format

Share Document