Room temperature gas sensing properties of tubular hydroxyapatite

2015 ◽  
Vol 39 (5) ◽  
pp. 3865-3874 ◽  
Author(s):  
Li Huixia ◽  
Liu Yong ◽  
Tan Yanni ◽  
Luo Lanlan ◽  
Zhang Qing ◽  
...  

Tubular hydroxyapatite was synthesized and showed high response, selectivity, good reproducibility and short response and recovery time to ammonia.

2014 ◽  
Vol 809-810 ◽  
pp. 731-736
Author(s):  
Qin Zhu ◽  
Yu Min Zhang ◽  
Jin Zhang ◽  
Zhong Qi Zhu ◽  
Qing Ju Liu

A new gas sensor with high response and selectivity was fabricated by using molecularly imprinted powders (MIPs) which provide special recognition sites to methanol. The MIPs were characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM) and fourier transform infrared spectrometer (FT-IR), respectively. The gas sensing properties of MIPs to methanol were investigated. The experimental results indicate that the sensors based on the MIPs show excellent gas sensing properties to methanol vapor, and the properties of the sensor with x=6:10 (x= methyl acrylic acid: LaFeO3, molar ratio) are the best. At the optimal operating temperature of 130°C, the response of the sensor (x=6:10) to 1 ppm methanol is 21, and the response and recovery times are 57 s and 67 s, respectively.


2019 ◽  
Vol 30 (18) ◽  
pp. 17094-17105
Author(s):  
Akshay Krishnakumar ◽  
Parthasarathy Srinivasan ◽  
Arockia Jayalatha Kulandaisamy ◽  
K. Jayanth Babu ◽  
John Bosco Balaguru Rayappan

2013 ◽  
Vol 320 ◽  
pp. 554-557 ◽  
Author(s):  
Yu Min Zhang ◽  
Yu Tao Lin ◽  
Jin Zhang ◽  
Zhong Qi Zhu ◽  
Qiang Liu ◽  
...  

Our previous study revealed that the gas sensitive property of Silver-modified Lanthanum Ferrite (Ag-LaFeO3) is well, but the operating temperature is still high and the sensitivity also needs to be improved. This work based on our previous study. Ag-LaFeO3 was further modified by the Carbon nanoTubes (CNTs). The Ag-LaFeO3 powder modified with CNTs (CNTs-Ag-LaFeO3) was prepared by a sol-gel method combined with microwave chemical synthesis. The structure and gas-sensing properties were investigated. The results show that the structure of CNTs-Ag-LaFeO3 is of orthogonal perovskite. The sensitivity of 0.75% CNTs-Ag-LaFeO3 powder for 1 ppm formaldehyde is 13 at 86°C. The response and recovery time are 100s and 60s, respectively. Moreover, the sensor also has an obvious response for 1ppm formaldehyde at 58°C.


2007 ◽  
Vol 1035 ◽  
Author(s):  
Amandeep Saluja ◽  
Jie Pan ◽  
Lei Kerr ◽  
Eunjung Cho ◽  
Seth Hubbard

AbstractIn this work, various ZnO nanostructures were synthesized and a detailed study on the effect of different process parameters such as temperature, carrier gas flow, inter-electrode spacing, gas concentration and material properties on gas sensitivity was conducted. Initial ZnO nanoparticles were prepared by a simple solution chemical process and characterized by Secondary Electron Microscopy (SEM) and Brunauer, Emmet and Teller (BET) Sorptometer to demonstrate the morphology and surface area respectively. Sensitivity of nano-platelets and porous films was measured for different concentrations of the analytes (H2, CO). High response was observed at room temperature for H2 gas with sensitivities in excess 80% for 60ppm and about 55% for 80ppm of H2 gas at room temperature were observed for the nano-platelets and the porous films respectively with short response and recovery times of about 200 seconds. The sensitivity of the nano-platelets to CO gas was also measured and found to be about near 90% for 80 ppm CO at operating temperatures of 200 °C.


2017 ◽  
Vol 19 (29) ◽  
pp. 19043-19049 ◽  
Author(s):  
Shuai Wang ◽  
Da Huang ◽  
Shusheng Xu ◽  
Wenkai Jiang ◽  
Tao Wang ◽  
...  

Defects caused by Al3+doping significantly affect the gas-sensing properties of NiO nanosheets.


2018 ◽  
Vol 325 ◽  
pp. 17-23 ◽  
Author(s):  
Tian-tian Li ◽  
Ren-rong Zheng ◽  
Hui Yu ◽  
Long Xia ◽  
Ying Yang ◽  
...  

2019 ◽  
Vol 30 (9) ◽  
pp. 8371-8380 ◽  
Author(s):  
S. B. Kulkarni ◽  
Y. H. Navale ◽  
S. T. Navale ◽  
F. J. Stadler ◽  
V. B. Patil

Nanomaterials ◽  
2019 ◽  
Vol 9 (8) ◽  
pp. 1059 ◽  
Author(s):  
Yanlin Zhang ◽  
Chaowei Jia ◽  
Qiuyue Wang ◽  
Quan Kong ◽  
Gang Chen ◽  
...  

Toluene is extensively used in many industrial products, which needs to be effectively detected by sensitive gas sensors even at low-ppm-level concentrations. Here, NiFe2O4 nano-octahedrons were calcinated from NiFe-bimetallic metal-organic framework (MOFs) octahedrons synthesized by a facile refluxing method. The co-existence of p-Phthalic acid (PTA) and 3,3-diaminobenzidine (DAB) promotes the formation of smooth NiFe-bimetallic MOFs octahedrons. After subsequent thermal treatment, a big weight loss (about 85%) transformed NiFe2O4 nanoparticles (30 nm) into NiFe2O4 porous nano-octahedrons with hollow interiors. The NiFe2O4 nano-octahedron based sensor exhibited excellent gas sensing properties for toluene with a nice stability, fast response, and recovery time (25 s/40 s to 100 ppm toluene), and a lower detection limitation (1 ppm) at 260 °C. The excellent toluene-sensing properties can not only be derived from the hollow interiors combined with porous nano-octahedrons to favor the diffusion of gas molecules, but also from the efficient catalytic activity of NiFe2O4 nanoparticles.


Sign in / Sign up

Export Citation Format

Share Document