scholarly journals Experimental study on single factor effect of divergent ultrasonic degradation of methylene blue in water

2019 ◽  
Vol 118 ◽  
pp. 03051
Author(s):  
Yong-guang Bi ◽  
Xin-ting Zhang ◽  
Shao-qi Zhou

The study of divergent ultrasonic degradation of methylene blue in water was carried out by exploring the ultrasonic intensity of the methylene blue, the initial concentration and the degradation rate of the solution pH. The test results show that the degradation rate of methylene blue decreases with the increase of ultrasonic power.The initial concentration of methylene blue solution is in the range of 0.00-10.00 mg/L. The degradation rate of methylene blue increases as the concentration of the solution increases. when the concentration is greater than 10.00mg/L, the concentration increases, and the ultrasonic degradation rate decreases. When the pH value is higher, the degradation rate of the methylene blue solution increases with the increase of pH, and the degradation rate reaches a maximum of 77.89%. The region where the ultrasonic degradation of methylene blue occurs is mainly at the junction of gas-liquid two phases, and is degraded by forming hydrogen peroxide in the cavitation bubbles and decomposing into various highly active radicals. Ultrasound has the advantages of fast, low energy consumption and environmental friendliness.

2011 ◽  
Vol 332-334 ◽  
pp. 1040-1044 ◽  
Author(s):  
Qiu Mei Wang ◽  
Lei Tan ◽  
Rong Wen Zhou ◽  
Zhi Wei Zou ◽  
Xue Mei Xu

In this paper, the photocatalytic degradation of methylene blue solution by photocatalysis bamboo charcoal fiber knitted fabric was studied. The relationships were analyzed between the photocatalytic degradation rate and the reaction time, the initial concentration, pH of methylene blue solution, and the distance between the UV light centre and liquid level. The results indicates that there is an remarkable photocatalytic degradation effect of methylene blue solution by photocatalysis bamboo charcoal fiber knitted fabric under UV-irradiation, even the degradation rate could reach to 67.02%. The degradation effect was better with lower initial concentration of methylene blue solution, higher initial pH,and the shorter distance between light centre and liquid level.


2011 ◽  
Vol 197-198 ◽  
pp. 996-999 ◽  
Author(s):  
Kun Hong Hu ◽  
Yong Kui Cai ◽  
Sai Li

A MoS2/TiO2 composite was synthesized and its photocatalytic activity for the degradation of methylene blue was evaluated. The results showed that the nano-MoS2/TiO2 composite presented excellent photocatalytic properties in the degradation reaction of methylene blue, which was ascribed to the good absorption of nano-MoS2/TiO2 in the visible light region. The decoloration rate of methylene blue solution was influenced by the dosage of nano-MoS2/TiO2 and the initial concentration of methylene blue. However, both the pH value and the degradation temperature had negligible effects on the decoloration rate of methylene blue. Moreover, the nano-MoS2/TiO2 composite as the degradation catalyst of methylene blue was of good regeneration properties.


2013 ◽  
Vol 807-809 ◽  
pp. 526-529
Author(s):  
Wei Xing Li ◽  
Jing Huan Ma ◽  
Ying Liu ◽  
Qing Tong Ren ◽  
Zhan Sheng Ma

In this paper, Fe (NO3) 3 9H2O and TiO2 were selected as raw materials. Fe2O3/TiO2 photocatalyst was prepared by the impregnation method. The degradation performance of the photocatalyst for methylene blue solution was studied in detail under the tungsten light source environment. The results showed that Fe2O3/TiO2 had the good photocatalytic properties, and that methylene blue had a higher degradation rate at about 60min. In a certain range of loading, degradation gradually increased with the amount of doped iron. The catalytic performance was high at the basic condition. The degradation rate decreased with the higher initial concentration of methylene blue. The photocatalyst with good performance has been prepared.


2013 ◽  
Vol 2013 ◽  
pp. 1-7 ◽  
Author(s):  
Julius Ndi Nsami ◽  
Joseph Ketcha Mbadcam

The adsorption of methylene blue from aqueous solution onto activated carbon prepared from cola nut shell has been investigated under batch mode. The influence of major parameters governing the efficiency of the process such as, solution pH, sorbent dose, initial concentration, and contact time on the removal process was investigated. The time-dependent experimental studies showed that the adsorption quantity of methylene blue increases with initial concentration and decreasing adsorbent dosage. The equilibrium time of 180 min was observed and maximum adsorption was favoured at pH 3.5. The dye removal using 0.1 g of adsorbent was more than 90%. This dosage (0.1 g) was considered as the optimum dosage to remove methylene blue from aqueous solutions. The equilibrium adsorption data were analyzed by the Freundlich, Langmuir adsorption isotherm models. The kinetics of methylene blue solution was discussed by pseudo-first-order, pseudo-second-order, and Elovich models. The adsorption process follows the Elovich rate kinetic model, having a correlation coefficient in the range between 0.9811 and 1.


2012 ◽  
Vol 518-523 ◽  
pp. 3208-3211
Author(s):  
Ya Na Liu ◽  
Hui Tian ◽  
An Heng Si

Ultraviolet ozone process was used to eliminate Methyl Violet, the effects of the type of research process, the initial solution pH, dye concentration and free radical quenching agent N-butanol on its degradation rate were studied. The experimental results showed that: comparing to UV, O3, UV/O3 three types of technology, UV and O3 technology had significant synergies, the degradation rate of Methyl Violet solution achieve 99.58% at 50min for the initial concentration of 100mg/L. increasing pH value resulted in increasing degradation rate, the degradation rate achieved 99. 8% at 50min under alkaline conditions. The remove rate decreased with increasing initial concentrations. Quenchers of free radicals inhibited the generation of hydroxyl radical and induced decreasing degradation rate. The degradation reaction of Methyl Violet by UV/O3 followed first-order law.


2012 ◽  
Vol 554-556 ◽  
pp. 333-338
Author(s):  
Cai Ning Zhang ◽  
Xu Man Wang

The composite was prepared with montmorillonite (MMT) and poly(γ-glutamic acid) (γ-PGA). Applied the composite as the sorbent, methylene blue as the adsorbate, the influences of the initial concentrations of methylene blue, adsorption time and pH values of the solution on the adsorption capacity of methylene blue by the composite were studied. The experimental results showed that the adsorption capacity of methylene blue by MMT/γ-PGA composite both increased with the increasing of initial concentration of methylene blue and the prolonging of adsorption time, and then approached saturation respectively. The adsorption capacity of methylene blue by MMT/γ-PGA composite increased with the increasing of pH values of methylene blue solution. Meanwhile, the study of adsorption mechanism demonstrated that the adsorption of methylene blue by MMT/γ-PGA composite was Langmuir type, and the adsorption equation wasΓ=0.204c/(1+0.381C).


2013 ◽  
Vol 773 ◽  
pp. 923-926 ◽  
Author(s):  
Yong Guang Bi ◽  
Min Xia Huang

aniline solution for the study, the effects of ultrasonic time, reaction factors such as temperature, ultrasonic power, and the pH of its ultrasonic degradation rate. Experimental results show that: as time increases, the ultrasonic degradation rate of aniline also rise, When the ultrasound the irradiation time 80min, aniline degradation rate reached 89.3%, 90min when the degradation rate of 92.1%, the degradation rate of aniline with decreases with the rise of the temperature of the solution, more than 40°C the degradation rate decreased significantly. Aniline degradation rate increased with the initial solution pH value increases, indicating that the alkaline conditions are favorable for degradation of aniline solution. Relative to the traditional method, the method is fast, simple, degradation rate, etc..


1927 ◽  
Vol 10 (6) ◽  
pp. 927-948 ◽  
Author(s):  
Marian Irwin

When uninjured cells of Valonia are placed in methylene blue dissolved in sea water it is found, after 1 to 3 hours, that at pH 5.5 practically no dye penetrates, while at pH 9.5 more enters the vacuole. As the cells become injured more dye enters at pH 5.5, as well as at pH 9.5. No dye in reduced form is found in the sap of uninjured cells exposed from 1 to 3 hours to methylene blue in sea water at both pH values. When uninjured cells are placed in azure B solution, the rate of penetration of dye into the vacuole is found to increase with the rise in the pH value of the external dye solution. The partition coefficient of the dye between chloroform and sea water is higher at pH 9.5 than at pH 5.5 with both methylene blue and azure B. The color of the dye in chloroform absorbed from methylene blue or from azure B in sea water at pH 5.5 is blue, while it is reddish purple when absorbed from methylene blue and azure B at pH 9.5. Dry salt of methylene blue and azure B dissolved in chloroform appears blue. It is shown that chiefly azure B in form of free base is absorbed by chloroform from methylene blue or azure B dissolved in sea water at pH 9.5, but possibly a mixture of methylene blue and azure B in form of salt is absorbed from methylene blue at pH 5.5, and azure B in form of salt is absorbed from azure B in sea water at pH 5.5. Spectrophotometric analysis of the dye shows the following facts. 1. The dye which is absorbed by the cell wall from methylene blue solution is found to be chiefly methylene blue. 2. The dye which has penetrated from methylene blue solution into the vacuole of uninjured cells is found to be azure B or trimethyl thionine, a small amount of which may be present in a solution of methylene blue especially at a high pH value. 3. The dye which has penetrated from methylene blue solution into the vacuole of injured cells is either methylene blue or a mixture of methylene blue and azure B. 4. The dye which is absorbed by chloroform from methylene blue dissolved in sea water is also found to be azure B, when the pH value of the sea water is at 9.5, but it consists of azure B and to a less extent of methylene blue when the pH value is at 5.5. 5. Methylene blue employed for these experiments, when dissolved in sea water, in sap of Valonia, or in artificial sap, gives absorption maxima characteristic of methylene blue. Azure B found in the sap collected from the vacuole cannot be due to the transformation of methylene blue into this dye after methylene blue has penetrated into the vacuole from the external solution because no such transformation detectable by this method is found to take place within 3 hours after dissolving methylene blue in the sap of Valonia. These experiments indicate that the penetration of dye into the vacuole from methylene blue solution represents a diffusion of azure B in the form of free base. This result agrees with the theory that a basic dye penetrates the vacuole of living cells chiefly in the form of free base and only very slightly in the form of salt. But as soon as the cells are injured the methylene blue (in form of salt) enters the vacuole. It is suggested that these experiments do not show that methylene blue does not enter the protoplasm, but they point out the danger of basing any theoretical conclusion as to permeability on oxidation-reduction potential of living cells from experiments made or the penetration of dye from methylene blue solution into the vacuole, without determining the nature of the dye inside and outside the cell.


2015 ◽  
Vol 1 (2) ◽  
pp. 179
Author(s):  
Syukri Darajat ◽  
Hermansyah Aziz ◽  
Admin Alif

 ABSTRACT A research aimed to study the influence of ZnO white powder on photodegradation of methylene blue using Merkuri lamp (l = 365 nm) as light source have been reached. A suspension of ZnO (40 mg) mixed with 25 mL of methylene blue solution (initial concentration of 0.015 mM) then was illuminated for 60 minutes showed degradation and quantum yield amounting 23.84% and 3.55 molecules photon-1, respectively. These results mean that by using ZnO as photocatalyst there is about four times efficiency than the one without ZnO either in case of time consumed or the number of photon applied. In kinetic study, it has been observed that such semiconductor-catalyzed photochemical reaction obeys the first order rule where rate constant and half time consecutively were 0.0029 minute-1 and 231 minutes.  Keywords : photodegradation, photocatalyst, quantum yield, semiconductor, photochemical reaction.


1930 ◽  
Vol 14 (1) ◽  
pp. 19-29 ◽  
Author(s):  
Marian Irwin

Glass electrode measurements of the pH value of the sap of cells of Nitella show that azure B in the form of free base penetrates the vacuoles and raises the pH value of the sap to about the same degree as the free base of the dye added to the sap in vitro, but the dye salt dissolved in the sap does not alter the pH value of the sap. It is concluded that the dye penetrates the vacuoles chiefly in the form of free base and not as salt. The dye from methylene blue solution containing azure B free base as impurity penetrates and accumulates in the vacuole. This dye must be azure B in the form of free base, since it raises the pH value of the sap to about the same extent as the free base of azure B dissolved in the sap in vitro. The dye absorbed by the chloroform from methylene blue solution behaves like the dye penetrating the vacuole. These results confirm those of spectrophotometric analysis previously published. Crystal violet exists only in one form between pH 5 and pH 9.2, and does not alter the pH value of the sap at the concentrations used. It does not penetrate readily unless cells are injured. A theory of "multiple partition coefficients" is described which explains the mechanism of the behavior of living cells to these dyes. When the protoplasm is squeezed into the sap, the pH value of the mixture is higher than that of the pure sap. The behavior of such a mixture to the dye is very much like that of the sap except that with azure B and methylene blue the rise in the pH value of such a mixture is not so pronounced as with sap when the dye penetrates into the vacuoles. Spectrophotometric measurements show that the dye which penetrates from methylene blue solution has a primary absorption maximum at 653 to 655 mµ (i.e., is a mixture of azure B and methylene blue, with preponderance of azure B) whether we take the sap alone or the sap plus protoplasm. These results confirm those previously obtained with spectrophotometric measurements.


Sign in / Sign up

Export Citation Format

Share Document