Hydrogen‐diffusion‐rate‐limited hydriding and dehydriding kinetics

1979 ◽  
Vol 50 (11) ◽  
pp. 7195-7199 ◽  
Author(s):  
P. S. Rudman
CORROSION ◽  
1954 ◽  
Vol 10 (3) ◽  
pp. 101-102 ◽  

Abstract Data were obtained on the diffusion of atomic hydrogen through several kinds of steel in acidic solutions. Where diffusion occurred, the presence of sulfide increased the diffusion rate. In an electric furnace grade steel, diffusion did not take place unless sulfide was present. Observations were made on the permanene of the sulfide surface associated with rapid atomic hydrogen diffusion.


2012 ◽  
Vol 57 (3) ◽  
pp. 727-731 ◽  
Author(s):  
I. Kukuła ◽  
H. Bala

On the basis of potentiostatic discharge method, the diffusion rate of atomic hydrogen as well as its solubility in LaNi5 crystal lattice have been evaluated for three LaNi5 powder - paraffin composite electrodes, with different LaNi5 powder particle diameters: 0 - 20 μm, 20 - 50 μm and 50 - 100 μm. The chronoamperommetric tests have been carried out in strong alkaline (6 M KOH), deaerated solution, at 25°C. Apparent hydrogen diffusion coefficients have been determined using Crank’s spherical diffusion model. It has been shown, that increase of particle size is prone to increase of hydrogen apparent diffusion coefficient and to decrease of hydrogen concentration in the solid phase. To explain the granulation effect on hydrogenation ability parameters, the inhibition of hydrogen transport by surfacial corrosion products present on powder particles has been assumed.


Author(s):  
R.L. Sabatini ◽  
Yimei Zhu ◽  
Masaki Suenaga ◽  
A.R. Moodenbaugh

Low temperature annealing (<400°C) of YBa2Cu3O7x in a ozone containing oxygen atmosphere is sometimes carried out to oxygenate oxygen deficient thin films. Also, this technique can be used to fully oxygenate thinned TEM specimens when oxygen depletion in thin regions is suspected. However, the effects on the microstructure nor the extent of oxygenation of specimens has not been documented for specimens exposed to an ozone atmosphere. A particular concern is the fact that the ozone gas is so reactive and the oxygen diffusion rate at these temperatures is so slow that it may damage the specimen by an over-reaction. Thus we report here the results of an investigation on the microstructural effects of exposing a thinned YBa2Cu3O7-x specimen in an ozone atmosphere using transmission electron microscopy and energy loss spectroscopy techniques.


Author(s):  
C. S. Lin ◽  
W. A. Chiou ◽  
M. Meshii

The galvannealed steel sheets have received ever increased attention because of their excellent post-painting corrosion resistance and good weldability. However, its powdering and flaking tendency during press forming processes strongly impairs its performance. In order to optimize the properties of galvanneal coatings, it is critical to control the reaction rate between solid iron and molten zinc.In commercial galvannealing line, aluminum is added to zinc bath to retard the diffusion rate between iron and zinc by the formation of a thin layer of Al intermetallic compound on the surface of steel at initial hot-dip galvanizing. However, the form of this compound and its transformation are still speculated. In this paper, we report the direct observations of this compound and its transformation.The specimens were prepared in a hot-dip simulator in which the steel was galvanized in the zinc bath containing 0.14 wt% of Al at a temperature of 480 °C for 5 seconds and was quenched by liquid nitrogen.


2019 ◽  
Vol 3 (2) ◽  
pp. 221-231 ◽  
Author(s):  
Rebecca Millington ◽  
Peter M. Cox ◽  
Jonathan R. Moore ◽  
Gabriel Yvon-Durocher

Abstract We are in a period of relatively rapid climate change. This poses challenges for individual species and threatens the ecosystem services that humanity relies upon. Temperature is a key stressor. In a warming climate, individual organisms may be able to shift their thermal optima through phenotypic plasticity. However, such plasticity is unlikely to be sufficient over the coming centuries. Resilience to warming will also depend on how fast the distribution of traits that define a species can adapt through other methods, in particular through redistribution of the abundance of variants within the population and through genetic evolution. In this paper, we use a simple theoretical ‘trait diffusion’ model to explore how the resilience of a given species to climate change depends on the initial trait diversity (biodiversity), the trait diffusion rate (mutation rate), and the lifetime of the organism. We estimate theoretical dangerous rates of continuous global warming that would exceed the ability of a species to adapt through trait diffusion, and therefore lead to a collapse in the overall productivity of the species. As the rate of adaptation through intraspecies competition and genetic evolution decreases with species lifetime, we find critical rates of change that also depend fundamentally on lifetime. Dangerous rates of warming vary from 1°C per lifetime (at low trait diffusion rate) to 8°C per lifetime (at high trait diffusion rate). We conclude that rapid climate change is liable to favour short-lived organisms (e.g. microbes) rather than longer-lived organisms (e.g. trees).


1993 ◽  
Vol 3 (7) ◽  
pp. 1643-1648
Author(s):  
N. Adnani ◽  
J. M. Titman

1979 ◽  
Vol 40 (C2) ◽  
pp. C2-635-C2-638
Author(s):  
F. Pröbst ◽  
F. E. Wagner ◽  
M. Karger ◽  
G. Wortmann

2003 ◽  
Vol 173 (10) ◽  
pp. 1107 ◽  
Author(s):  
Aleksei V. Gapontsev ◽  
Vladimir V. Kondrat'ev

1992 ◽  
Vol 1 (1) ◽  
pp. 685-692
Author(s):  
D. Lupu ◽  
R. Grecu ◽  
S. I. Fărcaș

1992 ◽  
Vol 1 (1) ◽  
pp. 631-635
Author(s):  
U. Stuhr ◽  
D. Steinbinder ◽  
H. Wipf ◽  
B. Frick

Sign in / Sign up

Export Citation Format

Share Document