Comment on ‘‘Is intermittent motion of outer flow in the turbulent boundary layer deterministic chaos?’’ [Phys. Fluids A 3, 1941 (1991)]

1992 ◽  
Vol 4 (7) ◽  
pp. 1587-1588 ◽  
Author(s):  
Charles Meneveau
1991 ◽  
Vol 3 (8) ◽  
pp. 1941-1946 ◽  
Author(s):  
Yoshiyuki Tsuji ◽  
Katsuya Honda ◽  
Ikuo Nakamura ◽  
Shinichi Sato

1975 ◽  
Vol 42 (3) ◽  
pp. 591-597 ◽  
Author(s):  
D. H. Wood ◽  
R. A. Antonia

Mean velocity and turbulence intensity measurements have been made in a fully developed turbulent boundary layer over a d-type surface roughness. This roughness is characterised by regular two-dimensional elements of square cross section placed one element width apart, with the cavity flow between elements being essentially isolated from the outer flow. The measurements show that this boundary layer closely satisfies the requirement of exact self-preservation. Distribution across the layer of Reynolds normal and shear stresses are closely similar to those found over a smooth surface except for the region immediately above the grooves. This similarity extends to distributions of third and fourth-order moments of longitudinal and normal velocity fluctuations and also to the distribution of turbulent energy dissipation. The present results are compared with those obtained for a k-type or sand grained roughness.


2002 ◽  
Vol 124 (3) ◽  
pp. 664-670 ◽  
Author(s):  
Donald J. Bergstrom ◽  
Nathan A. Kotey ◽  
Mark F. Tachie

Experimental measurements of the mean velocity profile in a canonical turbulent boundary layer are obtained for four different surface roughness conditions, as well as a smooth wall, at moderate Reynolds numbers in a wind tunnel. The mean streamwise velocity component is fitted to a correlation which allows both the strength of the wake, Π, and friction velocity, Uτ, to vary. The results show that the type of surface roughness affects the mean defect profile in the outer region of the turbulent boundary layer, as well as determining the value of the skin friction. The defect profiles normalized by the friction velocity were approximately independent of Reynolds number, while those normalized using the free stream velocity were not. The fact that the outer flow is significantly affected by the specific roughness characteristics at the wall implies that rough wall boundary layers are more complex than the wall similarity hypothesis would allow.


1999 ◽  
Vol 105 (4) ◽  
pp. 2097-2106 ◽  
Author(s):  
Timothy A. Brungart ◽  
Gerald C. Lauchle ◽  
Steven Deutsch ◽  
Eric T. Riggs

2008 ◽  
Vol 130 (5) ◽  
Author(s):  
Noor Afzal

The turbulent boundary layer subjected to strong adverse pressure gradient near the separation region has been analyzed at large Reynolds numbers by the method of matched asymptotic expansions. The two regions consisting of outer nonlinear wake layer and inner wall layer are analyzed in terms of pressure scaling velocities Up=(νp′∕ρ)1∕3 in the wall region and Uδ=(δp′∕ρ)1∕2 in the outer wake region, where p′ is the streamwise pressure gradient and ρ is the fluid density. In this work, the variables δ, the outer boundary layer thickness, and Uδ, the outer velocity scale, are independent of ν, the molecular kinematic viscosity, which is a better model of fully developed mean turbulent flow. The asymptotic expansions have been matched by Izakson–Millikan–Kolmogorov hypothesis leading to open functional equations. The solution for the velocity distribution gives new composite log-half-power laws, based on the pressure scales, providing a better model of the flow, where the outer composite log-half-power law does not depend on the molecular kinematic viscosity. These new composite laws are better and one may be benefited from their limiting relations that for weak pressure gradient yield the traditional logarithmic laws and for strong adverse pressure gradient yield the half-power laws. During matching of the nonlinear outer layer two cases arise: One where Uδ∕Ue is small and second where Uδ∕Ue of order unity (where Ue is the velocity at the edge of the boundary layer). In the first case, the lowest order nonlinear outer flow under certain conditions shows equilibrium. The outer flow subjected to the constant eddy viscosity closure model is governed by the Falkner–Skan equation subjected to the matching condition of finite slip velocity on the surface. The jet- and wakelike solutions are presented, where the zero velocity slip implying the point of separation, which compares well with Coles traditional wake function. In the second case, higher order terms in the asymptotic solutions for nearly separating flow have been estimated. The proposed composite log-half-power law solution and the limiting half-power law have been well supported by extensive experimental and direct numerical simulation data. For moderate values of the pressure gradient the data show that the proposed composite log-half-power laws are a better model of the flow.


Sign in / Sign up

Export Citation Format

Share Document