scholarly journals Electronically Tunable Quadrature Oscillator Using Translinear Conveyors and Grounded Capacitors

2003 ◽  
Vol 26 (3) ◽  
pp. 193-196 ◽  
Author(s):  
Sudhanshu Maheshwari
Keyword(s):  
Frequency Control ◽  
Current Mode ◽  
Current Control ◽  
External Current ◽  
Quadrature Oscillator ◽  
Sinusoidal Oscillator ◽  
Wide Range ◽  
Simulation Results ◽  
Electronically Tunable

A new electronically tunable current-mode sinusoidal oscillator with three quadrature outputs is presented. The proposed circuit employs three translinear conveyors and two grounded capacitors to realize three quadrature outputs with independent frequency control. The circuit requires no resistors and the frequency of the oscillator can be varied over a wide range by external current control. RSPICE simulation results using the bipolar implementation of translinear conveyors are given to support the proposed circuit.

scholarly journals Electronically Tunable Sinusoidal Oscillator Circuit

2012 ◽  
Vol 2012 ◽  
pp. 1-6 ◽  
Author(s):  
Sudhanshu Maheshwari ◽  
Rishabh Verma
Keyword(s):  
Frequency Tuning ◽  
Current Mode ◽  
Bias Current ◽  
Cmos Process ◽  
Third Order ◽  
Passive Components ◽  
Sinusoidal Oscillator ◽  
Wide Range ◽  
Tunable Frequency ◽  
Electronically Tunable

This paper presents a novel electronically tunable third-order sinusoidal oscillator synthesized from a simple topology, employing current-mode blocks. The circuit is realized using the active element: Current Controlled Conveyors (CCCIIs) and grounded passive components. The new circuit enjoys the advantages of noninteractive electronically tunable frequency of oscillation, use of grounded passive components, and the simultaneous availability of three sinusoidal voltage outputs. Bias current generation scheme is given for the active elements used. The circuit exhibits good high frequency performance. Nonideal and parasitic study has also been carried out. Wide range frequency tuning is shown with the bias current. The proposed theory is verified through extensive PSPICE simulations using 0.25 μm CMOS process parameters.

scholarly journals Current-Mode Third-Order Quadrature Oscillator Using CDTAs

2009 ◽  
Vol 2009 ◽  
pp. 1-5 ◽  
Author(s):  
Jiun-Wei Horng
Keyword(s):  
Theoretical Analysis ◽  
Phase Difference ◽  
Oscillation Frequency ◽  
Current Mode ◽  
Third Order ◽  
Quadrature Oscillator ◽  
Oscillation Condition ◽  
Transconductance Amplifiers ◽  
Simulation Results ◽  
A Current

This paper describes a current-mode third-order quadrature oscillator based on current differencing transconductance amplifiers (CDTAs). Outputs of two current-mode sinusoids with90°phase difference are available in the quadrature oscillator circuit. The oscillation condition and oscillation frequency are orthogonal controllable. The proposed circuit employs only grounded capacitors and is ideal for integration. Simulation results are included to confirm the theoretical analysis.

scholarly journals New Current-Mode Oscillators Using a Single Unity-Gain Current-Follower

1995 ◽  
Vol 18 (3) ◽  
pp. 151-157 ◽  
Author(s):  
Muhammad Taher Abuelma'atti
Keyword(s):  
Current Mode ◽  
Quadrature Oscillator ◽  
Current Follower ◽  
Unity Gain ◽  
Simulation Results

A general circuit for realizing current-mode oscillators using a single negative unity-gain current-follower is presented. Using this circuit new oscillators of this class can be discovered systematically. Simulation results obtained from three new circuits are presented. The feasibility of obtaining a quadrature oscillator is investigated.

Improved Electronically-Tunable Current-Mode Square-Root-Domain First-Order Multifunction Filter

2021 ◽  
pp. 2150190
Author(s):  
Manoj Kumar Jain
Keyword(s):  
Transient Response ◽  
Current Mode ◽  
Square Root ◽  
Spice Simulation ◽  
First Order ◽  
Low Pass ◽  
Multifunction Filter ◽  
Simulation Results ◽  
Electronically Tunable ◽  
High Pass

Some time back, Kircay reported an electronically-tunable current-mode square-root-domain first-order filter capable of realizing low-pass (LP), high-pass (HP) and all-pass (AP) filter functions. When simulated in SPICE, Kircay’s circuit has been found to exhibit DC offsets in case of LP and AP responses and incorrect transient response in case of HP response. In this paper, an improved circuit overcoming these difficulties/deficiencies has been suggested and its workability of the improved circuit as well as its capability in meeting the intended objectives has been demonstrated by SPICE simulation results.

An Active-C Current-Mode Universal First-Order Filter and Oscillator

2019 ◽  
Vol 28 (13) ◽  
pp. 1950219 ◽  
Author(s):  
D. Agrawal ◽  
S. Maheshwari
Keyword(s):  
Transfer Functions ◽  
Current Mode ◽  
Cmos Technology ◽  
Monte Carlo Analysis ◽  
Passive Element ◽  
First Order ◽  
Order Filter ◽  
Sinusoidal Oscillator ◽  
High Output Impedance ◽  
Electronically Tunable

This paper presents an electronically tunable current-mode first-order universal filter. The proposed circuit employs only a single Extra-X Current-Controlled Conveyor (EX-CCCII) and a single grounded capacitor, which is suitable for IC implementation. The circuit can realize three current transfer functions simultaneously, namely low-pass, high-pass and all-pass. The proposed circuit exhibits low-input and high-output impedance, which is suitable for cascading. The pole frequency of the filter can be electronically tuned, by varying the bias current of EX-CCCII. The nonidealities and parasitic effects on the circuit performance are investigated in detail. Also, the Monte Carlo analysis is done to show the effect of active and passive element mismatches on the pole frequency. An eight-phase current-mode sinusoidal oscillator and current-mode second-order filter are further realized using the proposed circuit. The functionality of the proposed circuits is verified through PSPICE simulations, using 0.25-[Formula: see text]m TSMC CMOS technology parameters.

Sign in / Sign up

Export Citation Format

Share Document