scholarly journals Effect of stacking sequences on tensile properties of natural fiber hybrid polymer composite

2021 ◽  
Vol 2027 (1) ◽  
pp. 012003
Author(s):  
R Ganesh ◽  
P Anand
Author(s):  
Ng Tian Ching ◽  
Khairul Anwar Abdul Halim ◽  
Mohd Firdaus Omar ◽  
Azlin Fazlina Osman ◽  
Muhammad Salihin Zakaria

Polymers ◽  
2021 ◽  
Vol 13 (8) ◽  
pp. 1282
Author(s):  
M.J. Suriani ◽  
Fathin Sakinah Mohd Radzi ◽  
R.A. Ilyas ◽  
Michal Petrů ◽  
S.M. Sapuan ◽  
...  

Oil palm empty fruit bunches (OPEFB) fiber is a natural fiber that possesses many advantages, such as biodegradability, eco-friendly, and renewable nature. The effect of the OPEFB fiber loading reinforced fire retardant epoxy composites on flammability and tensile properties of the polymer biocomposites were investigated. The tests were carried out with four parameters, which were specimen A (constant), specimen B (20% of fiber), specimen C (35% of fiber), and specimen D (50% of fiber). The PET yarn and magnesium hydroxide were used as the reinforcement material and fire retardant agent, respectively. The results were obtained from several tests, which were the horizontal burning test, tensile test, and scanning electron microscopy (SEM). The result for the burning test showed that specimen B exhibited better flammability properties, which had the lowest average burning rate (11.47 mm/min). From the tensile strength, specimen A revealed the highest value of 10.79 N/mm2. For the SEM morphological test, increasing defects on the surface ruptured were observed that resulted in decreased tensile properties of the composites. It can be summarized that the flammability and tensile properties of OPEFB fiber reinforced fire retardant epoxy composites were reduced when the fiber volume contents were increased at the optimal loading of 20%, with the values of 11.47 mm/min and 4.29 KPa, respectively.


Author(s):  
Raghu V. Prakash ◽  
Monalisha Maharana

Polymer composites have a characteristic, composition specific visco-elastic property which influences the damage progression during fatigue cycling. While some researchers have studied the time dependent constitutive response of polymer composites during the first cycle of fatigue loading, very few have experimentally investigated the dependence of visco-elastic response of built-up polymer composite materials at various stages of fatigue cycling [1]. Our earlier studies on fatigue response of polymer composites focused primarily on the stiffness degradation as a function of applied cycles of loading, which represents the gross response of the material [2]. While doing such an experiment, complimentary experimental techniques to measure the temperature evolution was attempted through the use of infrared thermal imaging technique, which gave some insight into the change in temperature response as a function of fatigue cycling. However, there was no systematic measurement of creep and stress relaxation response of the composite material as a function of induced fatigue damage. The present paper describes the results of creep and stress-relaxation obtained during uni-axial fatigue loading of a hybrid polymer composite material. For this purpose, a woven carbon fiber mat was chosen as the synthetic fiber and Flax fiber in the unidirectional form was chosen as the natural fiber that is laid between the two layers of woven carbon fiber mat. Epoxy LY 556 and hardener Araldite® was used for building up of composite laminate by hand-lay-up technique. Dog-bone shaped tensile specimens with a gage width of 13 mm and gage length of 57 mm were extracted from the 250 × 250 mm sq. plate laminate of 2.1 mm thickness using a numerical controlled milling machine. The specimens were tested at 35% of their median tensile strengths under fatigue at a positive stress ratio (Pmin/Pmax) of 0.1 in tension-tension loading. Prior to start of fatigue loading, the specimens were held in load control and the strain in the gage length was measured for understanding the creep response over 2500 seconds. For stress-relaxation characterization, the specimens were held in extensometer control over a period of 2500 sec. The creep and stress relaxation tests were carried out after periodic intervals of fatigue cycling. It was observed that in the case of un-impacted specimens, the creep rate is consistent with the stiffness variation, which in turn, is dependent on the number of fatigue cycles - till it showed signs of de-lamination. Thereafter it was governed by the woven synthetic fiber response. Similarly, the stress relaxation response was found to decrease with increasing fatigue cycles. In case of impacted specimens, the local deformation had a prominent role in terms of creep and stress relaxation response.


Sign in / Sign up

Export Citation Format

Share Document