scholarly journals Basic Performance of Fibre Reinforced Asphalt Concrete with Reclaimed Asphalt Pavement Produced In Low Temperatures with Foamed Bitumen

Author(s):  
Anna Chomicz-Kowalska ◽  
Mateusz M. Iwański ◽  
Justyna Mrugała
2019 ◽  
Vol 278 ◽  
pp. 01012
Author(s):  
Raudhah ◽  
R. Jachrizal Sumabrata ◽  
Sigit Pranowo Hadiwardoyo

Reclaimed asphalt pavement (RAP) comprises removed pavement materials containing high-quality aggregates and asphalt which can be recycled as materials for new pavement construction. It is removed continually for reconstruction, resurfacing, and maintenance purposes, and if not recycled will become waste. This paper determines the influence of using different RAP percentages and asphalt content in warm mix asphalt on the Marshall test results for asphalt concrete binder course (AC-BC) using Retona Blend 55. The percentages of RAP are determined by analyzing the gradation of the existing aggregates in RAP and adding virgin aggregates so that it meets the standard gradation for AC-BC specified by the Ministry of Public Works and Housing. The RAP percentages in the asphalt mixes in this study are 35%, 45%, and 51.55% of total aggregates, while the asphalt contents are 5%, 6%, and 7% of the total mix. To determine the influence of RAP percentage and asphalt content, and to discover if there is any influence from the interaction between these two factors, the analysis is performed using a factorial design. The results of this study show that variation in RAP percentages in the mix has no significant influence on stability, flow, and Marshall quotient, but there is significant influence on void in mineral aggregates (VMA), void in mix (VIM), and void filled with asphalt (VFA). Correlations of 97.5%, 80%, and 95.1%, respectively show that increase in RAP percentage increases VMA and VIM and decreases VFA. The interaction between RAP percentage and asphalt content has no significant influence on Marshall test results.


2019 ◽  
Vol 262 ◽  
pp. 05002 ◽  
Author(s):  
Przemysław Buczyński ◽  
Marek Iwański

This article presents research on recycled cold mix with foamed bitumen (MCAS) containing recycled concrete aggregate. The primary concept driving this research was to determine if recycled concrete aggregate (RC) could be used as a substitute for reclaimed asphalt pavement (RAP). Recycled concrete aggregate was used in the MCAS mix in amounts ranging from 20%, 60% and 80%. The reference mix was the MCAS mix containing 50% reclaimed asphalt pavement (RAP) and virgin aggregate. Identical 0/31.5-mm continuously graded dolomite virgin aggregate was used in all mixes. 2.5% foamed bitumen (FB) and 2.0% CEM I 42.5R Portland cement (PC) were used to increase the cohesion of the mineral mix. Foamed bitumen was produced from 50/70 penetration paving bitumen. The behaviour of the recycled base course was tested in the range of cyclic sinusoidal strain with amplitude εo = 25–50 με. The tests were carried out in the (-7°C, 5°C, 13°C, 25°C, 40°C) temperature and (0.1 Hz, 0.3 Hz, 1 Hz, 3 Hz, 10 Hz, 20 Hz) loading time range. The complex modulus was tested in a direct tension-compression test on cylindrical samples (DTC-CY) in accordance with EN 12697-26. The results of the tests were used to assess the complex modulus (E*), phase angle (φ) and complex modulus components (E1) and (E2).Tests of the mixes indicate that recycled concrete aggregate can be used in recycled cold mixes in amounts of up to 80%. Increasing the amount of recycled concrete aggregate does not cause excessive stiffness of the recycled mix in comparison with the reference mix. The tests did not demonstrate a significant difference in terms of the phase angle (φ), which indicates a similar content of the viscous part and elastic part in the obtained complex modulus for the reference mix (RAP + MCAS) and the mix containing recycled concrete aggregate (RC + MCAS).


Sign in / Sign up

Export Citation Format

Share Document