scholarly journals Lipophilicity Determination of Some Potential Photosystem II Inhibitors on Reversed-Phase High-Performance Thin-Layer Chromatography

1999 ◽  
Vol 37 (2) ◽  
pp. 41-44 ◽  
Author(s):  
Q. S. Wang ◽  
L. Zhang ◽  
H. Z. Yang ◽  
H. Y. Liu
RSC Advances ◽  
2020 ◽  
Vol 10 (4) ◽  
pp. 2133-2140 ◽  
Author(s):  
Prawez Alam ◽  
Essam Ezzeldin ◽  
Muzaffar Iqbal ◽  
Md. Khalid Anwer ◽  
Gamal A. E. Mostafa ◽  
...  

A literature survey revealed no suitable “reversed phase-high performance thin layer chromatography (RP-HPTLC)” method for the analysis of rivaroxaban in nanoparticle (NP) formulations.


1998 ◽  
Vol 17 (4-5) ◽  
pp. 671-677 ◽  
Author(s):  
Kathleen E McCarthy ◽  
Qingxi Wang ◽  
Eric W Tsai ◽  
Rebecca E Gilbert ◽  
Dominic P Ip ◽  
...  

1999 ◽  
Vol 82 (2) ◽  
pp. 244-247 ◽  
Author(s):  
M H Guermouche ◽  
D Habel ◽  
S Guermouche

Abstract Determination of tinidazole in human serum by high-performance thin-layer chromatography (HPTLC) is presented. It includes use of 10 × 10 cm plates coated with silica gel 60 and chloroform-acetonitrile-acetic acid (60 + 40 + 2) as mobile phase. Quantitation was performed by densitometry at 320 nm. The linearity (1-10 ng), precision (6%), reproducibility (5%), recovery (96%), and detection limit (1 mg/L) of tinidazole determination by HPTLC were comparable with corresponding method parameters by reversed-phase HPLC. A satisfactory correlation was found between the 2 analytical methods. The procedure was used to quantitate tinidazole in patient sera.


2019 ◽  
Vol 2019 ◽  
pp. 1-6 ◽  
Author(s):  
Andrzej Czyrski

The lipophilicity is an important parameter that influences the activity of the drugs in the human body. The reversed phase high performance thin layer chromatography was applied to determine the Log P values of ibuprofen, ketoprofen, naproxen, and flurbiprofen. The stationary phase used in the study was silica-gel coated plates. The mobile phase was the mixture of acetonitrile and water in different proportions. The content of acetonitrile varied in 5% increments from 50% to 80%. The Rm0 values were determined for the compounds with a known Log P and for the analyzed substances (ibuprofen, naproxen, ketoprofen, and flurbiprofen). The Log P values were calculated for the analyzed compounds using the regression curve Rm0 = f(Log P) parameters for the compounds with the known lipophilicity. Flurbiprofen is characterized by the highest Log P value: 3.82. The lowest one is noted for ketoprofen: 2.66. The determined Log P values of tested compounds were similar to the values calculated by the software.


Sign in / Sign up

Export Citation Format

Share Document