scholarly journals Detection of Two Orchid Viruses Using Quartz Crystal Microbalance-Based DNA Biosensors

2002 ◽  
Vol 92 (6) ◽  
pp. 654-658 ◽  
Author(s):  
Alvin Jin-Cherng Eun ◽  
Liqun Huang ◽  
Fook-Tim Chew ◽  
Sam Fong-Yau Li ◽  
Sek-Man Wong

We have developed a piezoelectric DNA-sensor based on DNA-RNA hybridization for the detection of two orchid viruses, Cymbidium mosaic virus (CymMV) and Odontoglossum ringspot virus (ORSV). Specific oligonucleotide probes modified with a mercaptohexyl group at the 5′-phosphate end were directly immobilized onto 10-MHz AT-cut quartz crystal microbalance (QCM). QCMs coated with such oligonucleotide probes were exposed to test solutions containing viral RNA for hybridization. Various experimental conditions evaluated were (i) DNA probe coating concentration, (ii) sensitivity and specificity of the probes at different hybridization temperatures, and (iii) effects of incubation temperature on the hybridization time. The specific nucleotide probe-coated QCM-based DNA sensors were able to detect both CymMV and ORSV in quantities as low as approximately 1 ng in purified RNA preparations and 10 ng in the crude sap of infected orchids. This is the first application of a DNA biosensor for the detection of plant viruses.

1997 ◽  
Vol 75 (11) ◽  
pp. 1674-1679 ◽  
Author(s):  
Galit Zilberman ◽  
Vladimir Tsionsky ◽  
Eliezer Gileadi

The electrochemical quartz crystal microbalance (EQCM) is used to study adsorption of pyridine and benzene on gold. The most important result observed is that thefrequencyincreaseswhentheorganicmoleculeisadsorbed, namely, the total mass of the species rigidly adsorbed is reduced as a result of adsorption. This is consistent with the accepted idea that electrosorption is a replacement reaction, in which a number of water molecules are replaced from the interface for each organic molecule adsorbed. However, this is the first time, to the best of our knowledge, that it has been observed experimentally. If the number of water molecules desorbed to make place for one molecule of pyridine is larger than 4.4, a decrease in mass should be observed. When independent data on the dependence of surface coverage on potential is available, this number can be estimated. In the case of pyridine, the EQCM data best fit the adsorption results if each molecule is assumed to replace 10–12 water molecules. In the case of benzene a similar calculation could not be performed since there are no adsorption data collected under comparable experimental conditions. Nevertheless, a positive shift of frequency is observed, indicating that this number must be >4.4. Keywords: electrochemical quartz crystal microbalance, electrical double layer, gold, pyridine, benzene.


2020 ◽  
Vol 13 (6) ◽  
Author(s):  
Adolfo Vázquez-Quesada ◽  
Marc Meléndez Schofield ◽  
Achilleas Tsortos ◽  
Pablo Mateos-Gil ◽  
Dimitra Milioni ◽  
...  

The Analyst ◽  
2015 ◽  
Vol 140 (4) ◽  
pp. 1323-1336 ◽  
Author(s):  
Jiajie Fang ◽  
Chunlai Ren ◽  
Tao Zhu ◽  
Kaiyu Wang ◽  
Zhongying Jiang ◽  
...  

The different characteristics of surface plasmon resonance and quartz crystal microbalance techniques under different experimental scenarios are discussed.


The Analyst ◽  
1997 ◽  
Vol 122 (10) ◽  
pp. 1139-1142 ◽  
Author(s):  
M. Teresa S. R. Gomes ◽  
A. Alexandre F. Silva ◽  
João A. B. P. Oliveira

2019 ◽  
Vol 25 (6) ◽  
pp. 879-884
Author(s):  
Takahiro Sakai ◽  
Hayato Seki ◽  
Shogo Yoshida ◽  
Hayato Hori ◽  
Hisashi Suzuki ◽  
...  

1998 ◽  
Vol 145 (2) ◽  
pp. 492-497 ◽  
Author(s):  
James J. Kelly ◽  
K. M. Anisur Rahman ◽  
Christopher J. Durning ◽  
Alan C. West

Sign in / Sign up

Export Citation Format

Share Document