Three-phase reactive power compensation using a single-phase AC/AC converter

Author(s):  
Zhong Ye
2014 ◽  
Vol 521 ◽  
pp. 298-302
Author(s):  
Wei Zhao Gao ◽  
Qing Chao Zhang ◽  
Ming Zhong Zheng ◽  
Heng Chao Zhang

With the increasing asymmetry of the three-phase load, the problem of three-phase imbalance in power system is becoming more serious every day. Asymmetrical three-phase voltages and currents affect the safe and stable operation of the power system.The main direction for solving the problem of unbalanced three-phase power system is reactive power compensation. But in present paper, we demonstrate a new method. First, we load the single-phase load into the phase with smallest current and keep oscillation. Then, considering that system stability requires as small as possible imbalance, so we treat line current as criterion and adjust part load into system phases to reduce the neutral current to a value less action. Thus we can achieve homeostasis of three-phase load. We also have realized it by simulation.


Energies ◽  
2019 ◽  
Vol 12 (13) ◽  
pp. 2479 ◽  
Author(s):  
Shunjiang Lin ◽  
Sen He ◽  
Haipeng Zhang ◽  
Mingbo Liu ◽  
Zhiqiang Tang ◽  
...  

Due to the unbalanced three-phase loads, the single-phase distributed photovoltaic (PV) integration, the long feeders, and the heavy loads in a three-phase four-wire low voltage distribution network (LVDN), the voltage unbalance factor (VUF), the network loss and the voltage deviation are relatively high. Considering the uncertain fluctuation of the PV output and the load power, a robust optimal allocation of decentralized reactive power compensation (RPC) devices model for a three-phase four-wire LVDN is proposed. In this model, the uncertain variables are described as box uncertain sets, the three-phase simultaneous switching capacity and single-phase independent switching capacity of the RPC devices are taken as decision variables, and the objective is to minimize the total power loss of the LVDN under the extreme scenarios of uncertain variables. The bi-level optimization method is used to transform the robust optimization model with uncertain variables into bi-level deterministic optimization models, which could be solved alternately. The nonlinear programming solver IPOPT in the mature commercial software GAMS is adopted to solve the upper and lower deterministic optimization models to obtain a robust optimal allocation scheme of decentralized RPC devices. Finally, the simulation results for an actual LVDN show that the obtained decentralized RPC scheme can ensure that the voltage deviation and the VUF of each bus satisfied the secure operation requirement no matter how the PV output and load power changed within their own uncertain sets, and the network loss could be effectively reduced.


2015 ◽  
Vol 21 ◽  
pp. 482-489 ◽  
Author(s):  
M.R. Sindhu ◽  
Manjula G. Nair ◽  
T.N.P. Nambiar

Electronics ◽  
2020 ◽  
Vol 9 (9) ◽  
pp. 1490
Author(s):  
Ting Chen ◽  
Hong Cheng ◽  
Cong Wang ◽  
Wenbo Chen ◽  
Zhihao Zhao

This paper proposes an open-circuit fault-tolerant design for the cascaded H-Bridge rectifier incorporating reactive power compensation. If one or two switching devices of the H-bridge modules are fault, the drive signals of the faulty H-bridge modules will be artificially redistributed into the bridgeless mode (including the boost bridgeless mode, the symmetric boost bridgeless mode, the totem-pole bridgeless mode and the symmetry totem-pole bridgeless mode) and cooperate with the normally operated H-bridge modules. In this case, the faulty cascaded H-bridge rectifier is not only able to achieve active power transmission, but also can still provide part of reactive power compensation when injecting reactive power from the power grid. Nonetheless, the reactive power that it can supply will be limited, due to the unidirectional characteristics of the bridgeless mode for the faulty modules. Therefore, a method for calculating its adjustable power factor angle range is also presented, which provides the basis for the faulty modules switching to the bridgeless mode. Then, a control strategy of the cascaded H-bridge rectifier incorporating reactive power compensation under the faulty condition and normal operation is presented. Finally, an experimental platform with a single-phase cascaded H-bridge rectifier containing three cells is given to verify the proposed theories.


Sign in / Sign up

Export Citation Format

Share Document