Pulsed power network with power sources and consumers operated on exhibition table

Kahn at Penn ◽  
2017 ◽  
Author(s):  
Hisayoshi Sugiyama
Author(s):  
Hisayoshi Sugiyama

Abstract Pulsed power network is proposed for reliable and low loss electrical power distribution among various type of power sources and consumers. The proposed scheme is a derivative of power packet network so far investigated that has affinity with dispersion type power sources and has manageability of energy coloring in the process of power distribution. In addition to these advantages, the proposed scheme has system reliability and low loss property because of its intelligent operation performed by individual nodes and direct relaying by power routers. In the proposed scheme, power transmission is decomposed into a series of electrical pulses placed at specified power slots in continuous time frames that are synchronized over the network. The power slots are pre-reserved based on information exchanges among neighboring nodes following inherent algorithm of the proposed scheme. Because of this power slots reservation based on decentralized intelligence, power pulses are directly transmitted from various power sources to consumers with the least power dissipation even though a partial failure occurs in the network. The network operations with the proposed scheme is simulated to confirm the algorithms for the power slots reservation and to evaluate the power network capacity.


2014 ◽  
Vol 986-987 ◽  
pp. 394-399
Author(s):  
Xue Yong Xu ◽  
Pan Zhou ◽  
Qi Zhe Huang ◽  
Chun Ming Deng ◽  
Meng Meng Shi ◽  
...  

Along with the increasing use of cables in power grid and the increasing ration of distributed power sources’ synchronization, such as small hydropower’s synchronization, increasing the reactive power transmission on the line, make it difficult to achieve the balance of reactive hierarchical partition. Take a certain region’s power grid for actual examples, after the installation of magnetic control reactor (MCR), using immune genetic algorithm (IGA) to coordinate the capacity of magnetic control reactor and the existing reactive power resources, the results show that the magnetic control reactor does much good to absorb the system’s excessive reactive power and limit the voltage’s increasing.


2019 ◽  
Vol 47 (7) ◽  
pp. 3241-3245 ◽  
Author(s):  
Mohammad Samizadeh Nikoo ◽  
Armin Jafari ◽  
Elison Matioli
Keyword(s):  

2011 ◽  
Vol 25 (4) ◽  
pp. 313-319
Author(s):  
E.N. Vereshchago ◽  
V.F. Kvasnitskii ◽  
V.I. Kostyuchenko
Keyword(s):  

2015 ◽  
Vol 36 (1) ◽  
pp. 109-130
Author(s):  
Andrzej Gębura ◽  
Tomasz Tokarski

AbstractThe article addresses in a complex way the problem of cooperation between the on-board electric power sources of an aircraft with its on-board electric network. The authors paid special attention to conditions related to correct switching of the on-board electric power sources. Structural protection of the electric power sources against harmful impact of loads, and of the loads against incorrectly operating sources, as well as certain methods to counteract such phenomena, are discussed. Exploring these relations will enable the user to undertake actions which can reduce the failure rate of the on-board electrical power network, and ensure power supply to the electrical loads under all flight conditions. Their correct operation determines correct operation of the on-board electrical power network. The authors tried to discuss all the problems in the most universal way possible, so the deliberations presented here could be helpful in analyzing defects in various aircrafts.


Sign in / Sign up

Export Citation Format

Share Document