Fuzzy Path-Query Algorithm and its Application in PX Absorption and Separation Process

2006 ◽  
Author(s):  
Ren Jia ◽  
Lei Meizhen ◽  
Zhang Yibo
Keyword(s):  
Separation Process ◽  
Query Algorithm

IMPLEMENTATION OF LOW-TRAUMATIC TECHNOLOGY OF GRAIN SEPARATION FROM A WHEAT EAR: RESULTS OF THE PILOT STUDIES

2020 ◽  
Author(s):  
V.I. Pakhomov ◽  
◽  
S.V. Braginets ◽  
O.N. Bakhchevnikov ◽  
A.I. Rukhlyada ◽  
...  
Keyword(s):  
Separation Process ◽  
Experimental Device ◽  
Cereal Crops ◽  
Pilot Studies ◽  
Traditional Technology ◽  
Air Jet ◽  
Cereal Breeding ◽  
Grain Damage ◽  
Partial Abrasion

Low-traumatic technology of grain separation from an ear is developed. It consists in influence of an air jet on an ear.It leads to rolling of an ear on a surface of the threshing device concave and causes its partial abrasion which is followed by grains separation. Process of wheat ears low-traumatic threshing in the experimental device yields satisfactory results, provides reduces grain endosperm damage on 10-12% in comparison with traditional technology. Germ of grain damage decreases by 5%.Crushing of grain made no more than 0,5%. Use of the developed technology of the low-traumatic threshing will allow to reduce grain damage of cereal crops in case of the harvesting. It is important by cereal breeding.

scholarly journals Influence of Casting Solvents on CO2/CH4 Separation Using Polysulfone Membranes

Membranes ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 286
Author(s):  
Roba M. Almuhtaseb ◽  
Ahmed Awadallah-F ◽  
Shaheen A. Al-Muhtaseb ◽  
Majeda Khraisheh
Keyword(s):  
High Efficiency ◽  
In Situ Synthesis ◽  
Separation Process ◽  
Polymeric Membranes ◽  
Gas Mixture ◽  
Manufacturing Cost ◽  
Binary Gas Mixture ◽  
Maximum Permeability ◽  
Polysulfone Membranes

Polysulfone membranes exhibit resistance to high temperature with low manufacturing cost and high efficiency in the separation process. The composition of gases is an important step that estimates the efficiency of separation in membranes. As membrane types are currently becoming in demand for CO2/CH4 segregation, polysulfone will be an advantageous alternative to have in further studies. Therefore, research is undertaken in this study to evaluate two solvents: chloroform (CF) and tetrahydrofuran (THF). These solvents are tested for casting polymeric membranes from polysulfone (PSF) to separate every single component from a binary gas mixture of CO2/CH4. In addition, the effect of gas pressure was conducted from 1 to 10 bar on the behavior of the permeability and selectivity. The results refer to the fact that the maximum permeability of CO2 and CH4 for THF is 62.32 and 2.06 barrer at 1 and 2 bars, respectively. Further, the maximum permeability of CF is 57.59 and 2.12 barrer at 1 and 2 bars, respectively. The outcome selectivity values are 48 and 36 for THF and CF at 1 bar, accordingly. Furthermore, the study declares that with the increase in pressure, the permeability and selectivity values drop for CF and THF. The performance for polysulfone (PSF) membrane that is manufactured with THF is superior to that of CF relative to the Robeson upper bound. Therefore, through the results, it can be deduced that the solvent during in-situ synthesis has a significant influence on the gas separation of a binary mixture of CO2/CH4.

scholarly journals A Spatio-Temporal Local Association Query Algorithm for Multi-Source Remote Sensing Big Data

2021 ◽  
Vol 13 (12) ◽  
pp. 2333
Author(s):  
Lilu Zhu ◽  
Xiaolu Su ◽  
Yanfeng Hu ◽  
Xianqing Tai ◽  
Kun Fu
Keyword(s):  
Remote Sensing ◽  
Remote Sensing Data ◽  
Temporal Correlation ◽  
Local Association ◽  
Sensing Data ◽  
Multi Scale ◽  
Correlation Networks ◽  
Efficient Integration ◽  
Spatio Temporal ◽  
Query Algorithm

It is extremely important to extract valuable information and achieve efficient integration of remote sensing data. The multi-source and heterogeneous nature of remote sensing data leads to the increasing complexity of these relationships, and means that the processing mode based on data ontology cannot meet requirements any more. On the other hand, the multi-dimensional features of remote sensing data bring more difficulties in data query and analysis, especially for datasets with a lot of noise. Therefore, data quality has become the bottleneck of data value discovery, and a single batch query is not enough to support the optimal combination of global data resources. In this paper, we propose a spatio-temporal local association query algorithm for remote sensing data (STLAQ). Firstly, we design a spatio-temporal data model and a bottom-up spatio-temporal correlation network. Then, we use the method of partition-based clustering and the method of spectral clustering to measure the correlation between spatio-temporal correlation networks. Finally, we construct a spatio-temporal index to provide joint query capabilities. We carry out local association query efficiency experiments to verify the feasibility of STLAQ on multi-scale datasets. The results show that the STLAQ weakens the barriers between remote sensing data, and improves their application value effectively.

scholarly journals Parameter optimization and yield prediction of cathode coating separation process for direct recycling of end-of-life lithium-ion batteries

RSC Advances ◽  
2021 ◽  
Vol 11 (39) ◽  
pp. 24132-24136
Author(s):  
Liurui Li ◽  
Tairan Yang ◽  
Zheng Li
Keyword(s):  
Lithium Ion Batteries ◽  
End Of Life ◽  
Lithium Ion ◽  
Separation Process ◽  
Yield Prediction ◽  
Li Ion Batteries ◽  
Treatment Efficiency ◽  
Control Factors ◽  
Li Ion ◽  
Pre Treatment

The pre-treatment efficiency of the direct recycling strategy in recovering end-of-life Li-ion batteries is predicted with levels of control factors.

Improvement of thermal conductivity of diamond/Al composites by optimization of liquid-solid separation process

2021 ◽  
pp. 117267
Author(s):  
Hongyu Zhou ◽  
Minrui Ran ◽  
Yaqiang Li ◽  
Zheng Yin ◽  
Yonghong Tang ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Separation Process

scholarly journals Recovery of γ-Fe2O3 from copper ore tailings by magnetization roasting and magnetic separation

2021 ◽  
Vol 19 (1) ◽  
pp. 128-137
Author(s):  
Bing Luo ◽  
Tongjiang Peng ◽  
Hongjuan Sun
Keyword(s):  
Magnetic Separation ◽  
Magnetic Field Intensity ◽  
Sodium Dodecyl ◽  
Separation Process ◽  
Sodium Dodecyl Sulfonate ◽  
Copper Ore ◽  
Yield Rate ◽  
Optimum Parameters ◽  
Roasting Temperature ◽  
Mineralogical Phase

Abstract To comprehensively reuse copper ore tailings, the recovery of γ-Fe2O3 from magnetic roasted slag after sulfur release from copper ore tailings followed by magnetic separation is performed. In this work, after analysis of chemical composition and mineralogical phase composition, the effects of parameters in both magnetization roasting and magnetic separation process with respect to roasting temperature, residence time, airflow, particle size distribution, magnetic field intensity, and the ratio of sodium dodecyl sulfonate to roasted slag were investigated. Under optimum parameters, a great number of γ-Fe2O3 is recycled with a grade of 66.86% and a yield rate of 67.21%. Meanwhile, the microstructure, phase transformation and magnetic property of copper ore tailings, roasted slag, and magnetic concentrate are carried out.

Sign in / Sign up

Export Citation Format

Share Document