Analytical-Transformation System for Manipulator Kinematics and Dynamics Modelling

Author(s):  
R.R. Kazandjieva
2015 ◽  
Vol 794 ◽  
pp. 419-426
Author(s):  
Philipp Tempel ◽  
Philipp Miermeister ◽  
Armin Lechler ◽  
Andreas Pott

This paper covers the kinematics and dynamics modelling of the mechatronic model for a 6 DOF cable-driven parallel robot and derives a real-time capable simulation model for such robots. The governing equations of motion for the platform are derived using Newton-Euler formalism, furthermore, the pulley kinematics of the winches and a linear spring-damper based cable model is introduced. Once the equations of motion are derived, closed-form force distribution is implemented and simulation results of the real-time capable model for the cable-driven parallel robot IPAnema3 are presented. Given the real-time capability, the presented model can be used for hardware-in-the-loop simulation or controller design, but also for case studies of highly dynamic or large-scale robots.


2013 ◽  
Vol 46 (8) ◽  
pp. 69-73 ◽  
Author(s):  
Xh. Bajrami ◽  
A. Dermaku ◽  
A. Shala ◽  
R. Likaj

2015 ◽  
Vol 1 (1) ◽  
pp. 5-16
Author(s):  
John Ohoiwutun

Utilization of conventional energy sources such as coal, fuel oil, natural gas and others on the one hand has a low operating cost, but on the other side of the barriers is the greater source of diminishing returns and, more importantly, the emergence of environmental pollution problems dangerous to human life. This study aims to formulate the kinematics and dynamics to determine the movement of Solar Power Mower. In this study, using solar power as an energy source to charge the battery which then runs the robot. Design and research was conducted in the Department of Mechanical Workshop Faculty of Engineering, University of Hasanuddin of Gowa. Control system used is a manual system using radio wave transmitter and receiver which in turn drive the robot in the direction intended. Experimental results showed that treatment with three variations of the speed of 6.63 m / s, 8.84 m / s and 15.89 m / sec then obtained the best results occur in grass cutting 15.89 sec and high-speed cutting grass 5 cm. Formulation of kinematics and dynamics for lawn mowers, there are 2 control input variables, x and y ̇ ̇ 3 to control the output variables x, y and θ so that there is one variable redudant. Keywords: mobile robots, lawn mower, solar power


2014 ◽  
Vol 8 (6) ◽  
pp. 1037
Author(s):  
Ratna Chow ◽  
Ahmad Faizal Salleh ◽  
Mohd Shahril Salim ◽  
Wan Mohd Radzi Bin Rusli ◽  
Norazian Abd. Razak ◽  
...  

2020 ◽  
Author(s):  
Anuradha Pallipurath ◽  
Francesco Civati ◽  
Jonathan Skelton ◽  
Dean Keeble ◽  
Clare Crowley ◽  
...  

X-ray pair distribution function analysis is used with first-principles molecular dynamics simulations to study the co-operative H<sub>2</sub>O binding, structural dynamics and host-guest interactions in the channel hydrate of diflunisal.


HortScience ◽  
1998 ◽  
Vol 33 (3) ◽  
pp. 461d-461
Author(s):  
Richard L. Bell ◽  
Ralph Scorza ◽  
Chinnathambi Srinivasan

An efficient regeneration/transformation system was developed for `Beurre Bosc' pear. Young leaves were harvested from in vitro shoots proliferated on a medium containing MS basal salts and 5 BAP, 0.5 μM IBA, and 0.6M3. Shoot regeneration was optimized using a modification of the medium of Chevreau and Leblay (1993). Explants were cultured on shoot induction medium contained 10 μM TDZ and 1 μM IBA for 4 weeks in the dark, and then transfered to a similar, but auxinless, regeneration medium until shoots developed, usually after an additional 4 to 8 weeks. Leaf tissues were transformed by co-cultivation for 3 days with Agrobacterium tumefaciens EHA101 carrying a pGA482 plasmid containing NPTII, GUS, and rolC genes, followed by cultivation on SIM containing 300 mg/L timentin. Putative transgenic plants were selected on shoot induction medium containing 80mg/L kanamycin, and multiplied on shoot proliferation medium. Four clones were confirmed as transgenic using the GUS histochemical assay and Southern blots for the NPTII and rolC genes. Plants of each clone have been rooted and successfully transfered to the greenhouse for further analysis of gene expression.


Sign in / Sign up

Export Citation Format

Share Document