Sensitivity analysis of DOA error on least square-based source localization in UWSAN

Author(s):  
Yan Ma ◽  
Leilei Jin
Resources ◽  
2021 ◽  
Vol 10 (10) ◽  
pp. 99
Author(s):  
Dicho Stratiev ◽  
Svetoslav Nenov ◽  
Dimitar Nedanovski ◽  
Ivelina Shishkova ◽  
Rosen Dinkov ◽  
...  

Four nonlinear regression techniques were explored to model gas oil viscosity on the base of Walther’s empirical equation. With the initial database of 41 primary and secondary vacuum gas oils, four models were developed with a comparable accuracy of viscosity calculation. The Akaike information criterion and Bayesian information criterion selected the least square relative errors (LSRE) model as the best one. The sensitivity analysis with respect to the given data also revealed that the LSRE model is the most stable one with the lowest values of standard deviations of derivatives. Verification of the gas oil viscosity prediction ability was carried out with another set of 43 gas oils showing remarkably better accuracy with the LSRE model. The LSRE was also found to predict better viscosity for the 43 test gas oils relative to the Aboul Seoud and Moharam model and the Kotzakoulakis and George.


2021 ◽  
Vol 252 ◽  
pp. 03032
Author(s):  
Yuchen Jin ◽  
Xiaochen Yang ◽  
Rui Feng ◽  
Wenjie Zuo ◽  
Guikai Guo

Structural dynamic modification plays an important role in structural dynamic design. This paper presents an algorithm for dynamic modification of the structure, which is based on the Combined Approximations (CA) approach, sensitivity analysis, Taylor series expansion and the least square method. The feasibility of the algorithm is verified by a numerical example and the results show that the algorithm is accurate enough and easy to be implemented.


Sensors ◽  
2020 ◽  
Vol 20 (12) ◽  
pp. 3466
Author(s):  
Yuanpeng Chen ◽  
Zhiqiang Yao ◽  
Zheng Peng

In time-of-arrival (TOA)-based source localization, accurate positioning can be achieved only when the correct signal propagation time between the source and the sensors is obtained. In practice, a clock error usually exists between the nodes causing the source and sensors to often be in an asynchronous state. This leads to the asynchronous source localization problem which is then formulated to a least square problem with nonconvex and nonsmooth objective function. The state-of-the-art algorithms need to relax the original problem to convex programming, such as semidefinite programming (SDP), which results in performance loss. In this paper, unlike the existing approaches, we propose a proximal alternating minimization positioning (PAMP) method, which minimizes the original function without relaxation. Utilizing the biconvex property of original asynchronous problem, the method divides it into two subproblems: the clock offset subproblem and the synchronous source localization subproblem. For the former we derive a global solution, whereas the later is solved by a proposed efficient subgradient algorithm extended from the simulated annealing-based Barzilai–Borwein algorithm. The proposed method obtains preferable localization performance with lower computational complexity. The convergence of our method in Lyapunov framework is also established. Simulation results demonstrate that the performance of PAMP method can be close to the optimality benchmark of Cramér–Rao Lower Bound.


1996 ◽  
Vol 06 (06) ◽  
pp. 581-591
Author(s):  
MING JIAN ◽  
ALEX C. KOT ◽  
MENG H. ER

In this paper, we address the problem of acoustical source localization using a five-elements microphone array system. The time delay estimation of signal arrival for any given pair of microphones using least square technique is proposed. These estimated time delays are used in the geometric location method to determine the location of the acoustical source which, in our case, is the position of talker of interest. Computer simulations are carried out in a teleconferencing room scenario. It is shown that the location of the acoustical source can be estimated effectively as signal-to-noise ratio is larger than 20 dB in a high reverberation environment.


Author(s):  
Radu Serban ◽  
Jeffrey S. Freeman ◽  
Dan Negrut

Abstract This paper presents a parameter identification technique for multibody dynamic systems, based on a nonlinear least-square optimization procedure. The procedure identifies unknown parameters in the differential-algebraic multibody system model by matching the acceleration time history of a point of interest with given data. Derivative information for the optimization process is obtained through dynamic sensitivity analysis. Direct differentiation methods are used to perform the sensitivity analysis. Examples of the procedure are presented, applying the technique both to perfect data; i.e. data produced by the assumed model with the optimal choice of parameters, and to experimental data; i.e. data measured on the real system and thus subject to noise and modelling imperfections.


Sign in / Sign up

Export Citation Format

Share Document