The Degradation Analysis of PVC Insulation Tape in 220kV Oil-filled Cable Terminal

2020 ◽  
Author(s):  
Shihu Yu ◽  
Xin Yu ◽  
Yaohong Zhao ◽  
Qing Wang ◽  
Xian Yang ◽  
...  
Keyword(s):  
Degradation Analysis

Degradation Analysis and Degradation Suppression Technology Caused by Light Absorption at Active Layer Facet of GaInAsP Laser Diode

2008 ◽  
Vol 128 (5) ◽  
pp. 732-737
Author(s):  
Hiroyuki Ichikawa ◽  
Masashi Ito ◽  
Chie Fukuda ◽  
Kotaro Hamada ◽  
Akira Yamaguchi ◽  
...  
Keyword(s):  
Active Layer ◽  
Laser Diode ◽  
Light Absorption ◽  
Degradation Analysis

Thermal Degradation Analysis of Fluorocarbon Thin Films prepared by an r.f. Sputtering with Poly (tetrafluoroethylene) Target

2013 ◽  
Vol 56 (4) ◽  
pp. 133-135
Author(s):  
Yuki IKEDA ◽  
Satoru IWAMORI ◽  
Hiroyuki MATSUMOTO ◽  
Kiyoshi YOSHINO ◽  
Itsuo NISHIYAMA ◽  
...  
Keyword(s):  
Thin Films ◽  
Thermal Degradation ◽  
Degradation Analysis

Degradation Analysis of Thick Film Chip Resistors

2009 ◽  
Author(s):  
Bhanu Sood ◽  
Diganta Das ◽  
Michael H. Azarian ◽  
Michael Pecht
Keyword(s):  
Thick Film ◽  
Printed Circuit Board ◽  
Negative Resistance ◽  
Circuit Board ◽  
High Humidity ◽  
Circuit Boards ◽  
Chemical Modifications ◽  
Current Leakage ◽  
Printed Circuit ◽  
Degradation Analysis

Abstract Negative resistance drift in thick film chip resistors in high temperature and high humidity application conditions was investigated. This paper reports on the investigation of possible causes including formation of current leakage paths on the printed circuit board, delamination between the resistor protective coating and laser trim, and the possibility of silver migration or copper dendrite formation. Analysis was performed on a set of circuit boards exhibiting failures due to this phenomenon. Electrical tests after mechanical and chemical modifications showed that the drift was most likely caused by moisture ingress that created a conductive path across the laser trim.

Degradation Analysis of M-C-Si PV Modules After Long Term Exposure Under Desert Climate

2018 ◽  
Author(s):  
Bouraiou Ahmed ◽  
Ammar Necaibia ◽  
Mostefaoui Mohammed ◽  
Abderrezzaq Ziane ◽  
Sahouane Nordine ◽  
...  
Keyword(s):  
Degradation Analysis ◽  
Pv Modules ◽  
Desert Climate

The Microstructure and Mechanical Properties of Ni-Based Superalloy after Service Exposure in Gas Turbine

2010 ◽  
Vol 654-656 ◽  
pp. 2523-2526 ◽  
Author(s):  
Keun Bong Yoo ◽  
Han Sang Lee
Keyword(s):  
High Temperature ◽  
Gas Turbine ◽  
Mechanical Tests ◽  
Time Dependent ◽  
Second Stage ◽  
Degradation Analysis ◽  
Check Points ◽  
Tcp Phase ◽  
Service Exposure ◽  
High Temperature Tensile

Many investigations about superalloys and coatings have been done in the laboratory, but evaluating the degradation condition of hot section components during service is still important not only for repair and reuse but also for outage prevention. Time dependent degradation for second stage blades of gas turbine was investigated. The degradation analysis for used blades was divided into microstructure changes by position of the blade and mechanical tests of high temperature tensile test. In the microstructure analysis, the rafting and coarsening of γ', MC decomposition and TCP phase formation occurred and progressed with increasing service time, and especially the leading and trailing edge of top layer should be a check points for used blade. High temperature tensile results of 25,000 and 52,000 hrs used blades were also compared with serviced time and position in each blade.

Sign in / Sign up

Export Citation Format

Share Document