Microcontroller emission simulation based on power consumption and clock system

Author(s):  
Thomas Steinecke
2014 ◽  
Vol 494-495 ◽  
pp. 1640-1646
Author(s):  
Yu Lan ◽  
Xin Lu ◽  
Ye Shen He ◽  
Yun Feng Li

In the micro-power wireless transmission of the electric system, positions among modes are relatively fixed, power business data is reported at specific time points, and time distribution presents great differences. Key technologies of IEEE802.15.4 MAC layer protocol is expounded, shortages of collision detection and CSMA/CA on power business support, etc. are discussed, self-adaptive low-power consumption CSMA/CA algorithm which is more suitable for business of the electric system are designed and improved, and the algorithm goes through simulation experiment against the business characteristics of micro-power wireless network of the electric system. The simulation result demonstrates the algorithm may be greatly adapted to changes of network traffic under a relatively fixed environment of network topology on the premise of low power consumption.


Author(s):  
Mangal Deep Gupta ◽  
‪Rajeev Kumar Chauhan

This paper presents a design of a binary comparator circuit using minimum fan-in logic gates (NAND-NOR) for achieving low power-delay-product (PDP). A 2-bit binary comparator circuit is re-designed to minimize fan-in of logic gates. Utilizing the concept of 2–bit comparator, a general gate-level architecture of a comparator system is proposed for higher input operands. A back-tracking model has been proposed in this work to estimate the worst-case performance in terms of delay and power or PDP for binary comparator circuits. It combines the advantages of the simulation-based method for power estimation and dynamic timing analysis (DTA) techniques for timing analysis. This work has also been extended for 20, 16, 14, 10, and 7-nm FINFET technology. The comparator circuits are simulated on Pyxis schematic tool by Mentor Graphics.


2013 ◽  
Vol 724-725 ◽  
pp. 902-905
Author(s):  
Si Yu Hao ◽  
Ting Ting Yang ◽  
Lin Wu

To lower the power consumption of elevator ,a Continuously Variable Transmission(CVT) is installed between traction mechanism and counterweight and optimize the mass of elevator counterweight .Adjust gear ratio by CVT,control the elevator counterweight lifting distance to adjust counterweight potential changes, the counterweight potential energy change reasonably compensate the elevator car potential changes,thereby obtaining satisfactory energy-saving effect.Use MATLAB/SIMULINK to establish the elevator traction system dynamics model to finish the power consumption analysis of elevator.


2020 ◽  
Author(s):  
SMITA GAJANAN NAIK ◽  
Mohammad Hussain Kasim Rabinal

Electrical memory switching effect has received a great interest to develop emerging memory technology such as memristors. The high density, fast response, multi-bit storage and low power consumption are their...


Sign in / Sign up

Export Citation Format

Share Document