Implementation of electronic load controller for control of micro hydro power plant

2015 ◽  
Author(s):  
Shailendra Kumar Rai ◽  
O. P. Rahi ◽  
Sunil Kumar
Keyword(s):  
Power Plant ◽  
Hydro Power ◽  
Electronic Load

scholarly journals Performance analysis of microcontroller based electronic load controller

2018 ◽  
Vol 13 (1) ◽  
pp. 20-35
Author(s):  
Amir Raj Giri ◽  
Bikesh Shrestha ◽  
Rakesh Sinha
Keyword(s):  
Power Plant ◽  
Performance Analysis ◽  
System Performance ◽  
Power Source ◽  
Total Power ◽  
Induction Generator ◽  
Hydro Power ◽  
Unique Method ◽  
And Performance ◽  
Electronic Load

The paper ‘Performance Analysis of Microcontroller based Electronic Load Controller’ is an approach for design, fabrication and performance analysis of microcontroller based ELC for 300 Watt Pico hydro controller. Electronic Load Controller (ELC) is an approach for regulating total power in the system with Pico-hydro power plant. The paper presents a unique method to maintain the system performance by regulating the generated power. The system voltage and current is measured by microcontroller to calculate the consumer power. Based upon the consumer power the dump power is varied accordingly. The performance analysis of ELC unit was done with power source from Nepal Electricity Authority (NEA) grid line as well as with separately excited induction generator under various loading conditions. The different resistive, capacitive and inductive loads were taken into consideration and the performance of the system based on voltage, current and power profiles were obtained.Kathmandu University Journal of Science, Engineering and TechnologyVol. 13, No. 1, 2017, 20-35

scholarly journals Electronic Load Controller based on Dimmer Circuit and Stepper Motor for 5 kW Micro-Hydro Power Plant

2022 ◽  
Vol 19 (2) ◽  
pp. 2023
Author(s):  
Abdul Hafid ◽  
Andi Faharuddin ◽  
Abdul Rajab
Keyword(s):  
Power Plant ◽  
Low Power ◽  
Stepper Motor ◽  
Small Scale ◽  
Hydro Power ◽  
Variable Resistor ◽  
Full Load ◽  
South Sulawesi ◽  
Electronic Load ◽  
Load Tolerance

This paper presents the results of research on a new schematic generator load controller simulation, namely an electronic load controller based on a dimmer circuit and a stepper motor for a small-scale 5 kW micro-hydro. The load controller is built from a dimmer circuit and a stepper motor with program control using Matlab software, and the PPI 8255 interface device. Using a dimmer circuit built from diac, triac, a variable resistor (pot), and capacitor components. As well as using a 28BYJ-48 stepper motor. Simulation is made to determine the performance of the load controller in controlling the distribution of power to the ballast load when the generator supplies power to consumers less than the full load of the generator. By using the simulation data of 45 variations of the consumer load sample, the result is that there are only 4 samples where the load controller is not working well. For the 4 samples, the generator was loaded beyond its full load tolerance limit (full load tolerance of 5kW ± 5 %). Overall, based on the simulation results, it can be said that the generator load controllers tested in this study have good performance. HIGHLIGHTS Methods and power electronic configurations used in electronic load controllers for micro-hydropower plants from 1980 until now. In the future, the use of low-power micro hydro and pico hydro power plants is also in great demand, especially for rural areas The utilization of micro-hydro in Indonesia, especially low-power micro-hydro, has been utilized by the community in Bulukumba Regency, South Sulawesi Province. A 5 kW generator has been operated in Katimbang Village, Borong Rappoa District, Kindang Regency, Bulukumba Regency, South Sulawesi Province to distribute electrical energy to 15 households This research proposes a new electronic load control scheme for a simple and inexpensive 5 kW micro-hydro power plant, namely a dimmer circuit and stepper motor-based generator load controller. With the consideration that the main components that make up this controller are not expensive GRAPHICAL ABSTRACT

Virtual Synchronous Generator Control of Power System including Large-scale Wind Farm by Cooperative Operation between Battery and LFC Hydro Power Plant

2020 ◽  
Vol 140 (6) ◽  
pp. 531-538
Author(s):  
Kotaro Nagaushi ◽  
Atsushi Umemura ◽  
Rion Takahashi ◽  
Junji Tamura ◽  
Atsushi Sakahara ◽  
...  
Keyword(s):  
Power Plant ◽  
Power System ◽  
Large Scale ◽  
Wind Farm ◽  
Synchronous Generator ◽  
Hydro Power ◽  
Virtual Synchronous Generator

scholarly journals Effect of Symmetrically Switched Rectifier Topologies on the Frequency Regulation of Standalone Micro-Hydro Power Plants

Energies ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 3201
Author(s):  
Henry Bory ◽  
Jose L. Martin ◽  
Iñigo Martinez de Alegria ◽  
Luis Vazquez
Keyword(s):  
Power Factor ◽  
Power Plants ◽  
Reactive Power ◽  
Alternating Current ◽  
Frequency Regulation ◽  
Hydro Power ◽  
Major Energy Source ◽  
Hydro Power Plants ◽  
Electronic Load ◽  
Ac Converters

Micro-hydro power plants (μHPPs) are a major energy source in grid-isolated zones because they do not require reservoirs and dams to be built. μHPPs operate in a standalone mode, but a continuously varying load generates voltage unbalances and frequency fluctuations which can cause long-term damage to plant components. One method of frequency regulation is the use of alternating current-alternating current (AC-AC) converters as an electronic load controller (ELC). The disadvantage of AC-AC converters is reactive power consumption with the associated decrease in both the power factor and the capacity of the alternator to deliver current. To avoid this disadvantage, we proposed two rectifier topologies combined with symmetrical switching. However, the performance of the frequency regulation loop with each topology remains unknown. Therefore, the objective of this work was to evaluate the performance of the frequency regulation loop when each topology, with a symmetrical switching form, was inserted. A MATLAB® model was implemented to simulate the frequency loop. The results from a μHPP case study in a small Cuban rural community called ‘Los Gallegos’ showed that the performance of the frequency regulation loop using the proposed topologies satisfied the standard frequency regulation and increased both the power factor and current delivery capabilities of the alternator.

Sign in / Sign up

Export Citation Format

Share Document