The strain-gauge type textile sensors adopted in many studies on respiration-sensing wearable systems have been reported to have two major limitations that result in reduced sensing accuracy and insufficient durability of the sensor. The two limitations are the inability to accurately monitor the changes in the three-dimensional (3D) body contour during changes in the respiration cycle and the frequent occurrence of baseline drifts. To solve these issues, this study proposes new types of textile respiration rate sensors with a 3D structure, which measure the respiration rate based on the variation in the size of the contacting section’s surface during respiration, rather than the changes in the length of the sensor, as in existing strain-gauge type sensors. Firstly, the sensing signals were analyzed based on morphology and size measurements. Then, the sensing reliability of three respiration rate sensor types, namely the no-filler, 3D hard, and 3D soft types, was analyzed by comparing their measurements with those of the SS5LB. Finally, the reproducibility and baseline drifts of the sensors’ measurements were evaluated by taking and comparing repeated measurements. As a result, the consistency of the sensing signals of the SS5LB and those of the two types of 3D sensors was higher than those of the no-filler type sensor, and the 3D soft type sensor had the highest reliability and reproducibility among the three new types of sensors. The result showed relatively reduced baseline drifts in the two types of 3D sensors.
Technical note: Development of a noninvasive respiration rate sensor for cattle
