Application of artificial neural network in wastewater treatment

Author(s):  
Li Guihong ◽  
Zheng Hua
2012 ◽  
Vol 2012 ◽  
pp. 1-17 ◽  
Author(s):  
Inchio Lou ◽  
Yuchao Zhao

Sludge bulking is the most common solids settling problem in wastewater treatment plants, which is caused by the excessive growth of filamentous bacteria extending outside the flocs, resulting in decreasing the wastewater treatment efficiency and deteriorating the water quality in the effluent. Previous studies using molecular techniques have been widely used from the microbiological aspects, while the mechanisms have not yet been completely understood to form the deterministic cause-effect relationship. In this study, system identification techniques based on the analysis of the inputs and outputs of the activated sludge system are applied to the data-driven modeling. Principle component regression (PCR) and artificial neural network (ANN) were identified using the data from Chongqing wastewater treatment plant (CQWWTP), including temperature, pH, biochemical oxygen demand (BOD), chemical oxygen demand (COD), suspended solids (SSs), ammonia (NH4+), total nitrogen (TN), total phosphorus (TP), and mixed liquor suspended solids (MLSSs). The models were subsequently used to predict the sludge volume index (SVI), the indicator of the bulking occurrence. Comparison of the results obtained by both models is also presented. The results showed that ANN has better prediction power (R2=0.9) than PCR (R2=0.7) and thus provides a useful guide for practical sludge bulking control.


2016 ◽  
Vol 2 (11) ◽  
pp. 555-567 ◽  
Author(s):  
Samaneh Khademikia ◽  
Ali Haghizadeh ◽  
Hatam Godini ◽  
Ghodratollah Shams Khorramabadi

In this study a hybrid estimation model ANN-COA developed to provide an accurate prediction of a Wastewater Treatment Plant (WWTP). An effective strategy for detection of some output parameters tested on a hardware setup in WWTP. This model is designed utilizing Artificial Neural Network (ANN) and Cuckoo Optimization Algorithm (COA) to improve model performances; which is trained by a historical set of data collected during a 6 months operation. ANN-COA based on the difference between the measured and simulated values, allowed a quick revealing of the faults. The method could obtain the fault detection and used in solving continuous and discrete optimization problems, successfully. After constructing and modelling the method, selected performance indices including coefficient of Regression, Mean-Square Error, Root-Mean-Square Error and Aggregated Measure used to compare the obtained results. This analysis revealed that the hybrid ANN-COA model offers a higher degree of accuracy for predicting and control the WWTP.


2021 ◽  
Vol 83 (5) ◽  
pp. 1250-1264
Author(s):  
B. L. Dinesha ◽  
Sharanagouda Hiregoudar ◽  
Udaykumar Nidoni ◽  
K. T. Ramappa ◽  
Anilkumar Dandekar ◽  
...  

Abstract The present investigation was focused to compare chitosan based nano-adsorbents (CZnO and CTiO2) for efficient treatment of dairy industry wastewater using Response Surface Methodology (RSM) and Artificial Neural Network (ANN) models. The nano-adsorbents were synthesized using chemical precipitation method and characterized by using scanning electron microscope with elemental detection sensor (SEM-EDS) and atomic force microscope (AFM). Maximum %RBOD (96.71 and 87.56%) and %RCOD (90.48 and 82.10%) for CZnO and CTiO2 nano-adsorbents were obtained at adsorbent dosage of 1.25 mg/L, initial biological oxygen demand (BOD) and chemical oxygen demand (COD) concentration of 100 and 200 mg/L, pH of 7.0 and 2.00, contact time of 100 and 60 min, respectively. The results obtained for both the nano-adsorbents were subject to RSM and ANN models for determination of goodness of fit in terms of sum of square errors (SSE), root mean square error (RMSE), R2 and Adj. R2, respectively. The well trained ANN model was found superior over RSM in prediction of the treatment effect. Hence, the developed CZnO and CTiO2 nano-adsorbents could be effectively used for dairy industry wastewater treatment.


Author(s):  
Eldon R. Rene ◽  
M. Estefanía López ◽  
María C. Veiga ◽  
Christian Kennes

Due to their inherent robustness, artificial neural network models have proven to be successful and have been used extensively in biological wastewater treatment applications. However, only recently, with the scientific advancements made in biological waste gas treatment systems, the application of neural networks have slowly gained the practical momentum for performance monitoring in this field. Simple neural models, after vigorous training and testing, are able to generalize the results of a wide range of operating conditions, with high prediction accuracy. This chapter gives a fundamental insight and overview of the process mechanism of different biological waste gas (biofilters, biotrickling filters, continuous stirred tank bioreactors and monolith bioreactors), and wastewater treatment systems (activated sludge process, trickling filter and sequencing batch reactors). The basic theory of artificial neural networks is explained with a clear understanding of the back propagation algorithm. A generalized neural network modelling procedure for waste treatment applications is outlined, and the role of back propagation algorithm network parameters is discussed. Anew, the application of neural networks for solving specific environmental problems is presented in the form of a literature review.


Sign in / Sign up

Export Citation Format

Share Document