A Max 2.3μA Quiescent Current External Capacitorless Low-Dropout Regulator

Author(s):  
Yanxia YAO ◽  
Menglian ZHAO ◽  
Xiaobo WU
2011 ◽  
Vol 20 (01) ◽  
pp. 1-13 ◽  
Author(s):  
CHENCHANG ZHAN ◽  
WING-HUNG KI

A CMOS low quiescent current low dropout regulator (LDR) with high power supply rejection (PSR) and without large output capacitor is proposed for system-on-chip (SoC) power management applications. By cascoding a power NMOS with the PMOS pass transistor, high PSR over a wide frequency range is achieved. The gate-drive of the cascode NMOS is controlled by an auxiliary LDR that draws only 1 μA from a small charge pump, thus helping in reducing the quiescent current. Adaptive biasing is employed for the multi-stage error amplifier of the core LDR to achieve high loop gain hence high PSR at low frequency, low quiescent current at light load and high bandwidth at heavy load. A prototype of the proposed high-PSR LDR is fabricated using a standard 0.35 μm CMOS process, occupying an active area of 0.066 mm2. The lowest supply voltage is 1.6 V and the preset output voltage is 1.2 V. The maximum load current is 10 mA. The measured worst-case PSR at full load without using large output capacitor is -22.7 dB up to 60 MHz. The line and load regulations are 0.25 mV/V and 0.32 mV/mA, respectively.


2012 ◽  
Vol 591-593 ◽  
pp. 2632-2635
Author(s):  
Lee Chu Liang ◽  
Roslina Mohd Sidek

A low power low-dropout (LDO) voltage regulator with self-reduction quiescent current is proposed in this paper. This proposed capacitorless LDO for Silicon-on-Chip (SoC) application has introduced a self-adjustable low-impedance circuitry at the output of LDO to attain stability critically during low output load current (less than a few hundred of micro-ampere). When the LDO load current increases, it reduces the LDO output impedance and moved the pole towards higher frequency away from the dominant pole and improving the system stability. When this happen, less amount of quiescent current is needed for the low-impedance circuitry to sustain the low output impedance. In this proposed LDO, the quiescent current that been used to sustain the low output impedance will be self-reduced when the output load current increases. Thus, the reduction of quiescent current at low output load current has tremendously improved the efficiency. The simulation results have shown a promising stability at low load current 0~1mA. The dropout voltage for this LDO is only 100mV at 1.2V supply. The proposed LDO is validated using Silterra 0.13μm CMOS process model and designed with high efficiency at low output load current.


2016 ◽  
Vol 90 (1) ◽  
pp. 227-235 ◽  
Author(s):  
Jaejin Yeo ◽  
Khurram Javed ◽  
Jaeseong Lee ◽  
Jeongjin Roh ◽  
Jae-Do Park

Sign in / Sign up

Export Citation Format

Share Document