Active disturbance rejection control — Based load frequency controller of interconnected power systems involving wind power penetration

Author(s):  
Emad Abu Khousa ◽  
Abdulla Ismail
2013 ◽  
Vol 325-326 ◽  
pp. 1145-1151 ◽  
Author(s):  
Qiao Li Guo ◽  
Wen Tan

This paper studies the load frequency control (LFC) problem for hybrid power system (HPS) with renewable energy technology. The goal is to attenuate the frequency deviation due to changing load demand, fluctuating wind and varying solar radiation. Two typical HPSs are considered in the paper: one with abundant wind energy and the other with solar energy. Active disturbance rejection control (ADRC) method is used to design the load frequency controller. Simulation results show that ADRC provides higher reliability and stability for the studied HPSs than conventional PI control.


Energies ◽  
2021 ◽  
Vol 14 (16) ◽  
pp. 4804
Author(s):  
Yuemin Zheng ◽  
Jin Tao ◽  
Hao Sun ◽  
Qinglin Sun ◽  
Zengqiang Chen ◽  
...  

To ensure the safe operation of an interconnected power system, it is necessary to maintain the stability of the frequency and the tie-line exchanged power. This is one of the hottest issues in the power system field and is usually called load frequency control. To overcome the influences of load disturbances on multi-source power systems containing thermal power plants, hydropower plants, and gas turbine plants, we design a linear active disturbance rejection control (LADRC) based on the tie-line bias control mode. For LADRC, the parameter selection of the controller directly affects the response performance of the entire system, and it is usually not feasible to manually adjust parameters. Therefore, to obtain the optimal controller parameters, we use the Soft Actor-Critic algorithm in reinforcement learning to obtain the controller parameters in real time, and we design the reward function according to the needs of the power system. We carry out simulation experiments to verify the effectiveness of the proposed method. Compared with the results of other proportional–integral–derivative control techniques using optimization algorithms and LADRC with constant parameters, the proposed method shows significant advantages in terms of overshoot, undershoot, and settling time. In addition, by adding different disturbances to different areas of the multi-source power system, we demonstrate the robustness of the proposed control strategy.


Energies ◽  
2019 ◽  
Vol 12 (6) ◽  
pp. 1132 ◽  
Author(s):  
Fan Zhang ◽  
Yali Xue ◽  
Donghai Li ◽  
Zhenlong Wu ◽  
Ting He

Supercritical circulating fluidized bed (CFB) is one of the prominent clean coal technologies owing to the advantages of high efficiency, fuel flexibility, and low cost of emission control. The fast and flexible load-tracking performance of the supercritical CFB boiler-turbine unit presents a promising prospect in facilitating the sustainability of the power systems. However, features such as large inertia, strong nonlinearity, and multivariable coupling make it a challenging task to harmonize the boiler’s slow dynamics with the turbine’s fast dynamics. To improve the operational flexibility of the supercritical CFB unit, a burning carbon based decentralized active disturbance rejection control is proposed. Since burning carbon in the furnace responds faster than throttle steam pressure when the fuel flow rate changes, it is utilized to compensate the dynamics of the corresponding loop. The parameters of the controllers are tuned by optimizing the weighted integrated absolute error index of each loop via genetic algorithm. Simulations of the proposed method on a 600 MW supercritical CFB unit verify the merits of load following and disturbance rejection in terms of less settling time and overshoot.


Sign in / Sign up

Export Citation Format

Share Document