FT-ESR measurements on BDPA by Pulsed ESR using a gyrotron as high-power millimeter wave source

Author(s):  
S. Mitsudo ◽  
K. Kono ◽  
K. Dono ◽  
K. Hayashi ◽  
Y. Ishikawa ◽  
...  
2021 ◽  
Vol 118 (2) ◽  
pp. 022407
Author(s):  
Hideyuki Takahashi ◽  
Yuya Ishikawa ◽  
Tsubasa Okamoto ◽  
Daiki Hachiya ◽  
Kazuki Dono ◽  
...  

1996 ◽  
Vol 430 ◽  
Author(s):  
S. Birken ◽  
K. Birken ◽  
K. Connor ◽  
G. Scheitrum

AbstractA new process is in development that uses high power millimeter wave energy to separate specific components from a composite material stream. The component to be separated from the material stream must have a combination of high loss tangent and low permittivity with respect to the other materials involved. In this case, when the material is subjected to a high power, high frequency RF source, the desired component can be vaporized and extracted without transferring significant heat to the remaining material. Since absorption increases significantly with frequency, it is important to use a millimeter wave source. A vacuum pump with sufficient pumping speed can transport the vaporized component for collection. The bulk material can either be collected or recycled through the system for further extraction.


2016 ◽  
Vol 16 (4) ◽  
pp. 225-228 ◽  
Author(s):  
Jae-Yong Kwon ◽  
Dong-Joon Lee ◽  
Aditia Nur Bakti ◽  
Windi Kurnia Perangin Angin

Sign in / Sign up

Export Citation Format

Share Document