A New Robust Control by Active Disturbance Rejection Control Applied on Wind Turbine System Based on Doubly Fed Induction Generator DFIG

Author(s):  
Mohammed Arbaoui ◽  
Ahmed Essadki ◽  
Ibtissam Kharchouf ◽  
Tamou Nasser
2020 ◽  
Vol 2020 ◽  
pp. 1-14
Author(s):  
Hammadi Laghridat ◽  
Ahmed Essadki ◽  
Maha Annoukoubi ◽  
Tamou Nasser

A novel and robust active disturbance rejection control (ADRC) strategy for variable speed wind turbine systems using a doubly fed induction generator (DFIG) is presented in this paper. The DFIG is directly connected to the main utility grid by stator, and its rotor is connected through a back-to-back three phase power converter (AC/DC/AC). Due to the acoustic nature of wind and to ensure capturing maximum energy, a control strategy to extract the available maximum power from the wind turbine by using a maximum power point tracking (MPPT) algorithm is presented. Moreover, a pitch actuator system is used to control the blades’ pitch angle of the wind turbine in order to not exceed the wind turbine rated power value in case of strong wind speeds. Furthermore, the rotor-side converter is used to control the active and reactive powers generated by the DFIG. However, the grid-side converter is used to control the currents injected into the utility grid as well as to regulate the DC-link voltage. This paper aims to study and develop two control strategies for wind turbine system control: classical control by proportional integral (PI) and the proposed linear active disturbance rejection control (LADRC). The main purpose here is to compare and evaluate the dynamical performances and sensitivity of these controllers to the DFIG parameter variation. Therefore, a series of simulations were carried out in the MATLAB/Simulink environment, and the obtained results have shown the effectiveness of the proposed strategy in terms of efficiency, rapidity, and robustness to internal and external disturbances.


2016 ◽  
Vol 40 (3) ◽  
pp. 1005-1017 ◽  
Author(s):  
Mohammed Aidoud ◽  
Moussa Sedraoui ◽  
Abderrazek Lachouri ◽  
Abdelhalim Boualleg

A robustification method of primary two degree-of-freedom (2-DOF) controllers is proposed in this paper to control the wind turbine system equipped with a doubly-fed induction generator DFIG. The proposed robustification method should follow the following three step-procedures. First, the primary 2-DOF controller is designed through the initial form of the multivariable generalized predictive control MGPC law to ensure a good tracking dynamic of reference trajectories. Second, the robust [Formula: see text] controller is independently designed for the previous system to ensure good robustness properties of the closed-loop system against model uncertainties, neglecting dynamics and sensor noises. Finally, both above mentioned controllers are combined to design the robustified 2-DOF-MGPC controller using Youla parameterization method. Therefore, the obtained controller conserves the same good tracking dynamic that is provided by the primary 2-DOF-MGPC controller. It ensures the same good robustness properties which are produced by the robust [Formula: see text] controller. A wind turbine system equipped with a DFIG is controlled by the robustified 2-DOF-MGPC controller. Its dynamic behaviour is modelled by an unstructured-output multiplicative uncertainty plant. The controller performances are valid by comparison with those given through both controllers, which are primary 2-DOF-MGPC and robust [Formula: see text] controllers in time and frequency domains.


Author(s):  
Ghulam sarwar Kaloi ◽  
Jie Wang ◽  
Mazhar H Baloch

<p><em> </em><em>     </em>The present paper formulates the state space modeling of doubly fed induction generator (DFIG) based wind turbine system for the purpose of the stability analysis. The objective of this study is to discuss the various modes of operation of the DFIG system under different operating conditions such as voltage sags with reference to variable wind speed and grid connection. The proposed control methodology exploits the potential of the DFIG scheme to avoid that grid voltage unbalances compromise the machine operation, and to compensate voltage unbalances at the point of common coupling (PCC), preventing adverse effects on loads connected next to the PCC. This methodology uses the rotor side converter (RSC) to control the stator current injected through the machine and the GSC to control the stator voltage to minimize the electromagnetic torque oscillations. Extensive simulation results on a 2MW DFIG wind turbine system illustrate the enhanced system performance and verify the effectiveness of the controller.</p>


Sign in / Sign up

Export Citation Format

Share Document