scholarly journals The BIS78 Pad trigger board for the Phase-I Upgrade of the Level-1 Muon Trigger of the ATLAS experiment at the LHC

Author(s):  
Salvatore Loffredo
Author(s):  
G. Carlino ◽  
F. Conventi ◽  
V. Izzo ◽  
A. Migliaccio ◽  
V. Bocci ◽  
...  

Author(s):  
G. Carlino ◽  
F. Conventi ◽  
V. Izzo ◽  
A. Migliaccio ◽  
V. Bocci ◽  
...  

2021 ◽  
Vol 2105 (1) ◽  
pp. 012026
Author(s):  
Stamatios Tzanos

Abstract In conjunction with the High Luminosity upgrade of the Large Hadron Collider accelerator at CERN, the ATLAS detector is also undergoing an upgrade to handle the significantly higher data rates. The muon end-cap system upgrade in ATLAS, lies with the replacement of the Small Wheel. The New Small Wheel (NSW) is expected to combine high tracking precision with upgraded information for the Level-1 trigger. To accomplish this, small Thin Gap Chamber (sTGC) and MicroMegas detector technologies are being deployed. Due to their installation location in ATLAS, the effects of Barrel Toroid and End-Cap Toroid magnets on NSW must be measured. For the final experiment at ATLAS, each sTGC large double wedge will be equipped with magnetic field Hall effect sensors to monitor the magnetic field near the NSW. The readout is done with an Embedded Local Monitor Board (ELMB) called MDT DCS Module (MDM). For the integration of this hardware in the experiment, first, a detector control system was developed to test the functionality of all sensors before their installation on the detectors. Subsequently, another detector control system was developed for the commissioning of the sensors. Finally, a detector control system based on the above two is under development for the expert panels of ATLAS experiment. In this paper, the sensor readout, the connectivity mapping and the detector control systems will be presented.


2006 ◽  
Vol 53 (4) ◽  
pp. 2446-2451 ◽  
Author(s):  
A. Aloisio ◽  
G. Carlino ◽  
F. Conventi ◽  
R. De Asmundis ◽  
V. Izzo ◽  
...  

1997 ◽  
Vol 44 (3) ◽  
pp. 348-353 ◽  
Author(s):  
J. Steinberg ◽  
K. Davis ◽  
D. Fein ◽  
R. Jayanti ◽  
K. Johns ◽  
...  
Keyword(s):  

2001 ◽  
Vol 19 (9) ◽  
pp. 2433-2438 ◽  
Author(s):  
Gilles Freyer ◽  
Nadine Bossard ◽  
Pascale Romestaing ◽  
Françoise Mornex ◽  
Olivier Chapet ◽  
...  

PURPOSE: Oxaliplatin could increase the efficacy of fluorouracil (5-FU)/folinic acid chemoradiotherapy in rectal cancer. We tested three dose levels to identify a feasible oxaliplatin dose for combination therapy. PATIENTS AND METHODS: Between February 1998 and April 2000, we included 17 rectal adenocarcinoma patients in a single-center phase I study. Patients had T4 rectal carcinoma, T1-T3 disease with colostomy refusal, or potentially operable T2/T3 M1 requiring local treatment. Pelvic radiotherapy was 45 Gy over 5 weeks, 1.8 Gy/fraction, with concomitant chemotherapy weeks 1 and 5. Chemotherapy was oxaliplatin 80, 100, or 130 mg/m2 2-hour infusion on day 1 followed by l-folinic acid 100 mg/m2/d intravenous bolus, and 5-FU 350 mg/m2/d continuous infusion on days 1 to 5 (FolfoR1). Six patients refusing surgery received additional contact radiotherapy +/− brachytherapy. Dose escalation proceeded if less than two of six patients had dose-limiting toxicity (DLT) at a given dose-level. RESULTS: All except two patients completed treatment; patients at level 1 (prolonged grade 1 thrombocytopenia) and level 3 (prolonged cold-related dysesthesia) had no second chemotherapy course. Median follow-up is 14 months (range, 2 to 28 months). One elderly patient at dose level 1 had DLT asthenia, severe diarrhea and vomiting, and more than 10% weight loss. There were no other DLTs and no severe rectitis or gastrointestinal toxicity. There were objective responses at all doses and no progressions. Eight patients underwent radical surgery after chemoradiotherapy. Two had complete pathologic responses. CONCLUSION: FolfoR1 seems feasible and effective. Dose escalation did not increase toxicity. Although the MTD was not reached in this study, we recommend oxaliplatin 130 mg/m2 for phase II studies because it is the dose determined from studies in metastatic patients with no toxicity when given concurrently with radiation.


Author(s):  
V. BOCCI ◽  
G. CHIODI ◽  
G. CIAPETTI ◽  
D. DE PEDIS ◽  
A. DI GIROLAMO ◽  
...  
Keyword(s):  

2019 ◽  
Vol 214 ◽  
pp. 01034
Author(s):  
Ralf Spiwoks ◽  
Aaron Armbruster ◽  
German Carrillo-Montoya ◽  
Magda Chelstowska ◽  
Patrick Czodrowski ◽  
...  

The Muon to Central Trigger Processor Interface (MUCTPI) of the ATLAS experiment at the Large Hadron Collider(LHC) at CERN is being upgraded for the next run of the LHC in order to use optical inputs and to provide full-precision information for muon candidates to the topological trigger processor (L1TOPO) of the Level-1 trigger system. The new MUCTPI is implemented as a single ATCA blade with high-end processing FPGAs which eliminate doublecounting of muon candidates in overlapping regions, send muon candidates to L1TOPO, and muon multiplicities tothe Central Trigger Processor (CTP), as well as readout data to the data acquisition system of the experiment. A Xilinx Zynq System-on-Chip (SoC) with a programmable logic part and a processor part is used for the communication to the processing FPGAs and the run control system. The processor part, based on ARM processor cores, is running embedded Linux prepared using the framework of the Linux Foundation's Yocto project. The ATLAS run control software was ported to the processor part and a run control application was developed which receives, at configuration, all data necessary for the overlap handling and candidate counting of the processing FPGAs. During running, the application provides ample monitoring of the physics data and of the operation of the hardware. *


2013 ◽  
Vol 8 (01) ◽  
pp. C01039-C01039 ◽  
Author(s):  
W Qian
Keyword(s):  
Phase I ◽  

Sign in / Sign up

Export Citation Format

Share Document