Spectral and Laser Properties of Yb:LuAG Transparent Ceramics Fabricated by Tape Casting Method

This paper reports the fabrication and characterization of (Bi0.48Sb1.52)Te3 thick films using a tape casting process on glass substrates. A slurry of thermoelectric (Bi0.48Sb1.52)Te3 was developed and cured thick films were annealed in a vacuum chamber at 500–600 °C. The microstructure of these films was analyzed, and the Seebeck coefficient and electric conductivity were tested. It was found that the subsequent annealing process must be carefully designed to achieve good thermoelectric properties of these samples. Conductive films were obtained after annealing and led to acceptable thermoelectric performance. While the properties of these initial materials are not at the level of bulk materials, this work demonstrates that the low-cost tape casting technology is promising for fabricating thermoelectric modules for energy conversion.

Download Full-text

Fabrication of PVDF–HFP-based microporous membranes by the tape casting method as a separator for flexible Li-ion batteries

Bulletin of Materials Science ◽

10.1007/s12034-021-02420-7 ◽

2021 ◽

Vol 44 (2) ◽

Author(s):

Prerna Chaturvedi ◽

Amarsingh Bhabu Kanagaraj ◽

Amani Alhammadi ◽

Hamda Al Shibli ◽

Daniel S Choi

Keyword(s):

Tape Casting ◽

Microporous Membranes ◽

Li Ion Batteries ◽

Casting Method ◽

Li Ion

Download Full-text

Ultrahigh energy storage density of Ca2+-modified PLZST antiferroelectric ceramics prepared by the tape-casting method

Journal of the European Ceramic Society ◽

10.1016/j.jeurceramsoc.2021.02.013 ◽

2021 ◽

Author(s):

Yujing Zhang ◽

Pin Liu ◽

Yanfeng Qin ◽

Kumara Raja Kandula ◽

Guangzu Zhang ◽

...

Keyword(s):

Energy Storage ◽

Tape Casting ◽

Energy Storage Density ◽

Ultrahigh Energy ◽

Casting Method ◽

Storage Density

Download Full-text

Fabrication and rheological behavior of tape‐casting slurry for ultra‐thin multilayer transparent ceramics

International Journal of Applied Ceramic Technology ◽

10.1111/ijac.13421 ◽

2019 ◽

Vol 17 (3) ◽

pp. 1255-1263 ◽

Cited By ~ 1

Author(s):

Han Zhao ◽

Fei Tang ◽

Yongzhen Xie ◽

Zicheng Wen ◽

Kangzhen Tian ◽

...

Keyword(s):

Rheological Behavior ◽

Tape Casting ◽

Transparent Ceramics

Download Full-text

Studies on Highly Dense Pure YIG Polycrystalline Ceramics Fabricated by Tape-casting Method

10.21203/rs.3.rs-57431/v1 ◽

2020 ◽

Author(s):

Chong Zhao ◽

Yingkui Li ◽

Xiaofei Shen ◽

Zhijun Cao ◽

Zhiquan Cao ◽

...

Keyword(s):

Tape Casting ◽

Solid State Reaction Method ◽

Grain Structure ◽

Casting Method ◽

Forming Process ◽

Sem Images ◽

Polycrystalline Ceramics ◽

Pure Phase ◽

One Step ◽

Xrd Patterns

Abstract Pure phase Y3Fe5O12 (YIG) ceramics was successfully produced by tape-casting forming process and one-step solid-state reaction method. With the sintering temperature above 1100 ºC, the pure phase YIG ceramics was synthesized with no YIP or Fe2O3 phase in XRD patterns. YIG ceramic sintering at 1400 ºC for 10 h showed a clear grain structure with an obvious grain boundary, and no pores were observed in the SEM images. YIG ceramics in this paper has a high relative density which was 99.8% and the saturation magnetization was 28.2 emu/g at room temperature. The hysteresis loss at temperatures of 230-360 K was smaller than 10 mJ/kg. The tan Se was nearly zero at 6~7 GHz and 11~12 GHz, showing that it can be used as a good material for microwave applications. In addition, the low values of tan and tan indicates that it may have a good electromagnetic wave absorption ability.

Download Full-text