scholarly journals Plain-Jet Airblast Atomization of Alternative Liquid Petroleum Fuels Under High Ambient Air Pressure Conditions

Author(s):  
A. K. Jasuja

An investigation has been conducted of the effects that air and fuel properties have upon the spray mean dropsize characteristics of a plain-jet airblast atomizer of the type employed in the gas turbine engine. The fuels tested included kerosine, gas oil and a high-viscosity blend of gas oil in residual fuel oil. The tests covered a wide range of ambient air pressures. Well established laser light-scattering technique was employed for dropsize measurements. The experimental data collected in the present investigation are presented in this paper and comparisons are made against similar data relating to the pre-filming type of airblast atomizer, collected in an earlier study (2).

1981 ◽  
Vol 103 (3) ◽  
pp. 514-518 ◽  
Author(s):  
A. K. Jasuja

A study has been conducted of the effects that fuel and air properties have upon the mean droplet size characteristics of a pre-filming airblast atomizer of the type commonly employed in the gas turbine engine. The fuels tested included kerosine, gas oil and two blends of gas oil in residual fuel oil. The tests were carried out over a wide range of air pressures (about 1 to 13 atmospheres), fuel viscosities (about 0.001 to 0.037 Ns/m2) and the spray mean drop sizes were measured using a laser light-scattering technique. The experimental data accumulated in the study is presented in the paper and it is concluded that the spray Sauter Mean Diameter performance of the atomizer studied can be predicted to a reasonable degree of accuracy, over the range of conditions studied, by a relatively simple correlating equation.


1979 ◽  
Vol 101 (2) ◽  
pp. 250-258 ◽  
Author(s):  
A. K. Jasuja

A study is made of the effects that fuel properties have upon the mean droplet size characteristics of three fuel atomizer types that are commonly employed in the gas turbine engine. The fuels tested included kerosine, gas oil, and a heavy residual fuel oil, and each was passed through a pressure swirl jet, a prefilming airblast, and a plain-jet airblast atomizer in turn. Tests were carried out at pressure levels close to ambient and mean drop sizes were determined using a light-scattering technique. Two main points emerge from the results: Firstly, for all atomizers tested, that the existing dropsize correlations are not sufficiently accurate for use with the high-viscosity residual fuel oils. Secondly, that the fuel dropsize decreases with the change in atomizer type from plain-jet airblast to prefilming airblast. The difference in performance of the two types of airblast atomizers is most noticeable for the residual fuel oil, particularly so at pressure drop levels of less than around five percent. Use is also made of the many data points collected to derive improved dropsize correlations which may be used over the whole range of fuels tested.


2016 ◽  
Vol 110 (1) ◽  
pp. 343-353 ◽  
Author(s):  
Kathryn E. Brown ◽  
Catherine K. King ◽  
Konstantinos Kotzakoulakis ◽  
Simon C. George ◽  
Peter L. Harrison

Author(s):  
Y. S. H. Najjar

Broadening of aviation fuel specifications has been simulated with blends of gas oil and residual fuel oil. Radiation, smoke and temperature measurements in a developed experimental combustor at various air pressures, inlet temperatures and air-fuel ratios permit derivation of a non-dimensional temperature parameter showing good correlation with theory.


RSC Advances ◽  
2021 ◽  
Vol 11 (52) ◽  
pp. 33017-33026
Author(s):  
Mahmoud Abd El-Aziz Mohamed ◽  
Mostafa A. A. Mahmoud ◽  
H. A. El Nagy

The mazout properties were improved using ecofriendly ways because of its wide range of applications, abundance and low cost.


1983 ◽  
Vol 105 (1) ◽  
pp. 82-88 ◽  
Author(s):  
Y. S. H. Najjar ◽  
E. M. Goodger

Broadening of aviation fuel specifications has been simulated using blends of gas oil and residual fuel oil. Radiation, smoke, and temperature measurements in an experimental combustor at various air pressure, inlet temperture, and air/fuel ratios showed a diminishing rate of increase of radiation with soot concentration and reduced sensitivity of smoke to fuel hydrogen content at higher combustor pressures.


2013 ◽  
Vol 48 (6) ◽  
pp. 832-838
Author(s):  
Chiori Takahashi ◽  
Shoko Imai ◽  
Yoshitaka Yamaguchi ◽  
Yuta Mitsui ◽  
Toshiaki Hayashi

Author(s):  
Michael T. Timko ◽  
Timothy B. Onasch ◽  
Megan J. Northway ◽  
John T. Jayne ◽  
Manjula R. Canagaratna ◽  
...  

The characterization of volatile and nonvolatile particle materials present in gas turbine exhaust is critical for accurate estimation of the potential impacts of airport activities on local air quality, atmospheric processes, and climate change. Two field campaigns were performed to collect an extensive set of particle and gaseous emission data for on-wing gas turbine engines. The tests included CFM56, RB211-535E4-B, AE3007, PW4158, and CJ610 engines, providing the opportunity to compare emissions from a wide range of engine technologies. Here we report mass, number, composition, and size data for the nonvolatile (soot) and volatile particles present in engine exhaust. For all engines, soot emissions (EIm-soot) are greater at climbout (85% power) and takeoff (100%) power than idle (4% or 7%) and approach (30%). At the engine exit plane, soot is the only type of particle detected. For exhaust sampled downwind (15–50 m) and diluted by ambient air, total particle number emissions (EIn-total) increases by about one or two orders of magnitude relative to the engine exit plane, and the increase is driven by volatile particles that have freshly nucleated in the cooling exhaust gas both in the free atmosphere and in the extractive sample lines. Fuel sulfur content is the determining factor for nucleation of new particles in the cooling exhaust gases. Compositional analysis indicates that the volatile particles consist of sulfate and organic materials (EIm-sulfate and EIm-organic). We estimate a lower bound S[IV] to S[VI] conversion efficiency of (0.08±0.01)%, independent of engine technology. Measurements of EIm-organic ranged from about 0.1 mg kg−1 to 40 mg kg−1. Lubrication oil was present in particles emitted by all engines and accounted for over 90% of the particulate organic mass under some conditions. The products of incomplete combustion are a likely source of the remaining volatile organic particle material.


Author(s):  
A. K. Jasuja

The atomization characteristics of a fuel-air mixture preparation cum placement device featuring a conventional dual-orifice pressure atomizer spraying into a narrow diameter, airstream carrying tube are outlined in this paper. The experimental tests were carried out on gas oil over a range of ambient air pressures. A well established laser light-scattering technique was employed for dropsize measurements. The spray quality data collected in the present investigation allows some interesting comparisons against conventional airblast and pressure atomized spray data.


2009 ◽  
Vol 45 (3) ◽  
pp. 164-169
Author(s):  
V. Georgiev ◽  
D. Stratiev ◽  
K. Kirilov ◽  
K. Petkov ◽  
D. Minkov

Sign in / Sign up

Export Citation Format

Share Document